Question about 2000 Chevrolet Impala
My Impala is a 2002 with a 3.8L. I had to replace my condensor and therefore remove my radiator. I wrote it up and saved the instructions and pictures at:
I hope this helps, and good luck.
Posted on Aug 09, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
PCV . Positive Crankcase Ventalation Valves are always located in the valve cover pans with a hose attached usually leading to the air cleaner, or some other vacuum source..
Posted on Jun 19, 2009
I First, you must remove the black air deflctor that runs underneath the radiator across the car. Maybe about 8 bolts. Even then I couldn't find the drain plug at first. It is on the driver's side. Beneath the radiator there is a heavy metal Mounting bracket. Almost looks like a crossmember. About an inch in from the left (driver's) side bottom of the bracket there is a large round hole with a rubber grommet. In the center of this hole it the outlet of the drain. If you reach directly above it on the back side of the radiator, i.e. come around back on the bracket and looking forward, you will find the drain ****. It is black plastic and has 2 ****, not a full petcock handle. It is still hard to see, even after removing the air deflector. The air deflector is the one people knock off by running too far forward when parking. I hope this helps .Remember the 2 or 3 vents at top of radiator hoses when refilling the system.
The radiator does have a hard to see drain plug on the left drivers' side. There are 5 10MM screws holding the air deflector on. The block has removable plugs, one 14MM hex next to the oil filter and one in about the same location on the other side of the block toward the firewall under the exhaust manifold.
Posted on Oct 30, 2009
It sounds like you might need to replace your motor mounts, or get a tier allignement done. The allignment you cannot do yourself but the motor mounts you can this requires you to place a jack under you engine and undoing the motor mounts then replace them and take away jack.
Posted on Jan 30, 2010
Tips for a great answer:
Jan 08, 2016 | Cars & Trucks
Dec 19, 2015 | 2000 Chevrolet Impala
Sep 09, 2015 | 2003 Chevrolet Impala
Mar 14, 2012 | 2000 Chevrolet Impala
Feb 24, 2012 | 2000 Chevrolet Impala
Feb 03, 2011 | 2004 Chevrolet Impala
Dec 01, 2010 | 2000 Chevrolet Impala
Jan 30, 2010 | 2000 Chevrolet Impala
Jun 10, 2009 | 2000 Chevrolet Impala
Jun 18, 2008 | 2003 Chevrolet Impala
980 people viewed this question
Usually answered in minutes!