Question about 2005 Dodge Grand Caravan

1 Answer

Water is leaking through the satelite receiver on the roof of my 2005 Dodge Caravan. I was able to remove the overhead console but the screw that I thought was holding the receiver on is tight but the receiver is still loose to the touch and I see a gap underneath it. What do you suggest?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Use clear bathtub sealer (silicon)its cheaper than trying to take it all apart etc.......

Posted on Jul 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sun roof drain lines


You have to remove screws from any overhead console,
remove sun visors,handles & such to pull down the headliner
to get at & hook up the drain hose that came off

Oct 05, 2012 | 2005 Dodge Durango

1 Answer

Water coming inside when its raining and dont know where its coming from


ifyou have roof racks with the year of your van the sealant that mounts the racks may have dried out and splitting removing the mounts and removing screws partially and applying silicone aaround the bas of screw then retighten should seal ur leak up for anouther 10 yrs or more hope it helps

Jul 26, 2012 | 1999 Dodge Caravan

2 Answers

2005 dodge caravan leaking on the driver side and passenger side floor. the rain water is dropping from corner of the roof.


The rear ac evaporator box is not draining very well,and it is blowing the condensation up threw the vents,most likely.The drain should be under the rear passengers side wheel well.

Aug 17, 2010 | 2005 Dodge Grand Caravan

1 Answer

2005 dodge grand caravan overhead console lost contact; will work perfectly if a lot of pressure applied to it but will not stay put


The spring may be broken or you have poor contact.

Open up the sunglasses holder and there might be a screw holding it in place there. There is also another screw underneath the main body, just unsnap the cover plate to access it.

The entire console slide back away from the windshield about 1/2" once the screws are removed, then drops away. Flip over and inspect.

Jul 10, 2010 | 2005 Dodge Grand Caravan

1 Answer

My sunroof is not able to be closed. It is in the pop up position. Is there a manual way to close it? eg no use of electricity?


there is no manual method. It sounds like a limit switch is not working. Can you hear the motor try to operate? If you push up on the back of the glass a little bit while hitting the switch, what happens.

go here for villager help

http://groups.yahoo.com/group/villagerquest/


The sliding roof panel system consists of the following components:
  • RH circuit breaker
  • Timer module
  • Power window relay
  • Roof sliding panel switch (15B691)
  • Roof glass panel (50054)
  • Sliding roof panel motor (15790)
  • Halo moulding
  • Roof sliding panel headlining (519A02)
  • Roof sliding panel slide links (502M78)
  • Roof sliding panel housing (502C22)
  • Roof air deflector (500A26)
  • Center green diode strip
-------------------------------------
When the roof sliding panel switch is activated, a gear on the sliding roof panel motor drives a spline on the roof sliding panel housing. Within the roof sliding panel housing, the spline is connected to two sliding roof panel cables which cause the roof sliding panel slide links to slide and the roof glass panel to open or to close. The sliding roof panel cables and the spline are part of the roof sliding panel housing. Neither the sliding roof panel motor nor the roof sliding panel housing can be disassembled. If a malfunction is detected with either of these assemblies, the assembly must be replaced.
----------------------------------------------------------------------------
VISUAL INSPECTION CHART Mechanical Electrical
  • Damaged sliding roof panel
  • Sliding roof panel height adjustment
  • Sliding roof panel fore and aft adjustment
  • Blown fuse(s):
    • 30A PWR WDW
  • Damaged circuit breaker #1
  • Damaged wiring harness
  • Loose or corroded connections

------------------------
  • Sliding Roof Panel Does Not Open or Close
  • Fuses.
  • Circuit breaker #2.
  • Power window relay.
  • Sliding roof panel motor.
  • Roof sliding panel switch.
  • Circuit.
  • GO to Pinpoint Test E1 .
  • Sliding Roof Panel Will Not Stop in Vent Position
  • Sliding roof panel motor.


Switch Removal
  1. Disconnect the battery ground cable (14301).
  1. Gently pry the overhead console from the headliner.
  1. Disconnect the sliding roof panel electrical connector from the overhead console.
  1. Disconnect the rear quarter window switch electrical connector from the overhead console, if equipped.
  1. Disconnect the map lamp electrical connector from the overhead console.
  1. Remove the overhead console.
  1. Remove the two roof sliding panel switch screws and the roof sliding panel switch (15B691).
--------------------------------------------------------------------------------
Motor Removal
  1. Place the roof glass panel (50054) in the closed position.
  1. Remove the roof headlining (51916). Refer to Section 01-05 for the removal procedure.
  1. Remove the two sliding roof panel relays from their brackets.




  1. Disconnect the two sliding roof panel motor electrical connectors.
  1. Remove the two sliding roof panel motor screws and the sliding roof panel motor (15790

Jan 11, 2010 | 1997 Mercury Villager

1 Answer

My 2001 Mercury Cougar moonroof is stuck, it opened a few inches then just stopped. Is there a way I can manually close it?


Check fuses #21 40 amp check relay jump 12 volts to motor circuit
Overhead Console Removal
  1. Disconnect the battery ground cable.
  1. NOTE: Remove the interior lamp as a unit.
    Ease out the interior lamp.
    • Disconnect the electrical connectors.
    v4301245.jpg
  1. Remove the overhead console screws.
    v4301246.jpg
  1. Remove the overhead console.
    • Apply an even downwards force to both sides of the console.
    • Disconnect the roof opening panel switch electrical connector (if equipped).
    • Disconnect the information and message center electrical connector (if equipped)
-----------------------------------------------------
SECTION 501-17: Roof Opening Panel 2001 Cougar Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 02/8/2001
Roof Opening Panel Motor Removal
  1. Remove the overhead console. For additional information, refer to Section 501-12.
  1. Disconnect the sliding roof motor electrical connector.
    v4101317.jpg
  1. Disconnect the sliding roof panel relay.
    v4101318.jpg
  1. Remove the sliding roof motor control unit.
    v4101322.jpg
Installation
  1. To install, reverse the removal procedure.

Oct 30, 2009 | 2001 Mercury Cougar

1 Answer

Rain water leaks from overhead console (No sunroof)


common problem with these roof racks check for loose bolts holding it on also there are inserts pressed into your roof under the roof rack these threaded insrts tend to come loose or get pulled out use silocone sealant around every bolt and insert.

Sep 19, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Over head console dodge 2008 se removal


Open up the sunglasses holder and there might be a screw holding it in place there. There is also another screw underneath the main body, just unsnap the cover plate to access it.

The entire console slide back away from the windshield about 1/2" once the screws are removed, then drops away.

Nov 29, 2008 | 2008 Dodge Grand Caravan

Not finding what you are looking for?
2005 Dodge Grand Caravan Logo

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...