Question about 1991 Chevrolet Camaro

1 Answer

Just was told I need to replace the TSP on my 1991 hard is it to replace...

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 468 Answers

The Throttle Position Sensor is something that you want a professional to do. Some require specific voltage settings when installed, so you can be opening a large can of worms if you haven't done one before.

Posted on Jul 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 91 camaro rs v6 just did tune up plugs and wires and oil change power comes on to everything but car wont crank doesn't make a sound had plugs and wires checked i was told to change the...

1. battery would have run down since been parked for extensive duration. insert key into ignition to perform start, lighting displays is indication that bettery is functioning esle car needs a new batery.

Jul 21, 2011 | 1991 Chevrolet Camaro

1 Answer

I need instructions/diagrams to replace the thermostat in my 1991 Chevy Camaro.

Can't be to involved follow the big radiator hose to motor top one where it conects, thats where the t stat is under the nozzle . 2 nuts or bolts hold it down remove replace gasket also ,, clean gasket surface 1st,,

Apr 14, 2011 | 1991 Chevrolet Camaro

1 Answer

I just bought a 1991 z28 camaro with 71,000 miles on it I have a growling noise in the back end of the car and i have replaced the brake pads and bearings on both side of the car and the noise is still...

Sounds like the differential bearings are on the way out. Big perfromance cars like this are always driven hard and its hard on the diff. Put the car up on solid stands, chock the front wheels and put in drive and see if you can here the noise from the diff.

Nov 12, 2010 | 1991 Chevrolet Camaro

2 Answers

When I speed up to 50 miles per hour sometimes, I have a hesistation or missing. Like it will cut off on me, but it doesn't. When I give it gas, it stops. I was told it might be a sensor problem. I am...

this sound like a tsp problem you need a scanner to check this problem if your check engine light is on take it to your nearest auto zone they will read the code if the tsp code comes up tats your problem if it do-sent it could still be your problem but that's a little hard to check without the scanner u need to go were the scanner is reading the tsp sensor and push the accelerator pedal down slowly the reading should go up slowly if it goes bikers that's your problem

Nov 03, 2010 | 2001 Lincoln LS

1 Answer

Need to replace my floor pans for 1991 camaro, looking for step by step instructions

While i can't provide you with much use full information on replacing the floor boards i think i can lead you to a site that will help. If you haven't already been, check out . It's the largest 82-92 F-body website out there.

Oct 25, 2009 | 1991 Chevrolet Camaro

1 Answer


You are dealing with the wrong dealership.I was quoted $57.00 for a new key and they told me the resistance. Phone around and you will get satisfaction. Moe

Jul 15, 2009 | 1991 Chevrolet Camaro

1 Answer

Camaro - broken reclining seat mechanism

the recliner is the outside seat hinge and has 4 bolts holding it to the seat cushion and seat back.The seat covers need to be pulled back to gain access to bolts.Can be done with seat in the vehicle.

May 27, 2009 | 1991 Chevrolet Camaro

2 Answers

What is the timing set at for a 1991 Camero 305 V8 ?

Try 0 degrees. It should state it on the radiator cover, but mine didn't. I tried 10 advance and it started real hard. I think you need to disconnect the single wire terminal near the distributor/coil that sticks out of your harness wrap before you set timing and reconnect it afterwards. That's what I recall from my TPI car and this TBI car seems to have the same electronics. Good luck.

Mar 08, 2009 | 1991 Chevrolet Camaro

1 Answer

How hard to replace fuel pump on 1995 camaro?

yea most american made cars have the fuel pump in the tank.....just drop the tank and replace....not that hard to do but you will need a helping hand...not something id attempt on my own......did you check the fuel pump relay and fuse.....that could be i too....try that first its cheaper....hope this helps :)

Sep 30, 2008 | 1995 Chevrolet Camaro

Not finding what you are looking for?
1991 Chevrolet Camaro Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides