Question about 1996 Mitsubishi Eclipse

1 Answer

Yes i drive a 96 eclipse 5-speed and i was worndering where would the speed sensor be

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 52 Answers

Should be connected to the engine control unit.

Posted on Jul 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 99 eclipse gs-t is not shifting


Have you tested the speed sensor to see if it is producing a signal going back to the computer ?

May 07, 2013 | Mitsubishi Eclipse Cars & Trucks

1 Answer

97 ECLIPSE JERKING AND POWER LOSS WHILE DRIVING


could be a number of things (throttle position sensor, crank position sensor, bad injector, faulty coil, bad plugs,etc) i would take it to a shop and have them scan it .If the scanner comes up with multiple problems and your forced to start "throwing parts " at it, remember most electrical parts cannot be returned once opened, so it could get expensive.shops sometimes have what i call "test pilots", properly working parts to put in to see if it corrects the problem through a process of elimination. this is one way a shop can actually save you money.

Apr 30, 2012 | 1997 Mitsubishi Eclipse

1 Answer

96 eclipse non-turbo idles way too high, disconnect MAP sensor it goes down but then idles rough


Yes by disconneting the map sensor will drop idle and make run rough, the problem is the idle air control valve or a vacuum leak, try to clean the throtlebody with an old tooth brush and some throtlebody spray cleaner if that doesnt help then try having the iac valve checked the iac valve (Idle air control valve ) if with the engine running listen for a hissing noise that will be a vacuum leak, these are the most common reasons for higher than normal idle. hope this is helpful.

Dec 05, 2010 | 1996 Mitsubishi Eclipse

1 Answer

Speedometer does not work in my 95 eclipsis there a speed sensor or anything to fix this problem? if so is it easy and where is it located


I am told there were multiple engines in the 95 Eclipses. I have the Chrysler 2.0 with 5-speed manual transmission. I replaced my speed sensor in about ten minutes. It is located on top of the transmission held in by one bolt and connected with a small electrical connector that simply unclips.

Hope this helps.

May 13, 2010 | 1995 Mitsubishi Eclipse

1 Answer

I have a eclipse 96 I tried to repair the


did you change fluid and filter this is just as important as an engine oil change. also a automatic transmission has things called bands that change the gears and hold overdrive in they also need adjusting every 30,000 miles. if not they will cause your transm,ission to slip. and burn up atf fluid.

Oct 26, 2009 | 2001 Mitsubishi Eclipse

2 Answers

4th cylinder misfire in '96 eclipse rs(5 speed if it makes a dif)


There may be a problem with the coil pack causing this misfire or the timing is off enough to cause late or early firing of the plug.

Oct 12, 2009 | 1996 Mitsubishi Eclipse

1 Answer

Eclipse GST 1997/ car running fine then terrible/ 4 codes


yes bad ecu. exat same thing happened to a freind of mine he replaced maf, coolant sensor, distributor all that came trough check engine light. and still the same and chugged gas like crazy and fans were o always. i swapped his ecu with mine n car ran perfect. so he got new ecu and here he is driving happily to this day.

it was a 96 galant 2.4 sohc with around 75,000 miles.

good luck

May 09, 2009 | 1997 Mitsubishi Eclipse

1 Answer

1996 mitsubishi eclipse 2.0 non turbo


That's wrong and the mechanic should know that. For 96 and newer cars, OBD 2 (onboard diagnostics, second generation) systems are in use, and the codes that come up are four digit codes.

That means that the code you got is 1255, not four individual one-digit codes (even a pre-96 car would have two digit codes, not single digit). Generically, a 1200-series code deals with fuel and air metering, but unfortunately I don't have a listing for a 1255. What symptoms does your car have? Is it just bad gas mileage or is it acting up in other ways? Post up as a reply here with anything along those lines that you can think of and I'm sure we'll figure out the problem.

Aug 29, 2008 | 1996 Mitsubishi Eclipse

Not finding what you are looking for?
1996 Mitsubishi Eclipse Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...