Question about Toyota Camry

1 Answer

I recently took my Toyota Camry into the shop to have them replace a oil pump cover gasket and now that it is put back together it runs really rough while idling only (it will rev up and then almost stall) they thought maybe the timing might be off but after messing with it they think it is dead on is there anything else that i should double check or does it sound like it could be a timing problem?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

It actually sounds like a vacuum or intake leak or the map sensor start the car and unplug the map sensor wire set. motor should have steady idle after that. if not then start checking and unpluging the idle air control valve or the throttle position sensor the only sensro the car will not run with unplugged is the mass air flow sensor

Posted on Jul 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi there, recently I bought a 1989 toyota camry for very cheap as I was told it needed a water pump. I decided to buy the car as a learning car, plan was to fix it up and sell it. After replacing the...


Damnnnnn Wes your a mechanic ,you did your fare share of work for a flip car ,start at the fuel tank and clean all your lines if possible use compressed air , change fuel filter, and that all lines are tight, and make sure you have good fuel flow to rack , no bs I really hope you get it running ,good luck.
Woody

Oct 05, 2014 | 1989 Toyota Camry

2 Answers

1998 toyota camry problems


If above the pump, it is usually the cam cover gasket in a Camry.

Jun 24, 2014 | 1998 Toyota Camry

2 Answers

My 1990 camry has oil in the spark plug tubes. Everything seems sealed. Got any ideas? Your help would be greatly appreciated.


If my memory serves me right, your plugs go down through the valve cover. There is a gasket around the spark plug holes that needs to be replaced.That is where your oil is coming from. Replace the outer gasket around the edge of the cover while you are at it. Hope this helps.

May 08, 2010 | 1990 Toyota Camry

1 Answer

1997 Toyota Camry Engine Short Block- took it to the toyota dealer to replace oil pan gasket and valve cover gaskets, and front engine seals. they took for a after repair test drive and the lower block...


they probably didn't put any oil in it after the gaskets were replaced and that caused the problem.if the car was running fine prior to you having it fixed and there was no noise coming from the engine,then that would be my best assumption to your problem.hope this info helps and good luck.take care , manny

Apr 05, 2010 | 1997 Toyota Camry

1 Answer

Brake rotors and pads recently replaced. Seem to


You could stop the noisy brake problem by applying special adhesive to the back of the brake pads. They are available at the autoparts stores.If you buy high quality brake pads, you would see the anti-noise shims included in the package.

As for the oil dripping issue: have the required quantity of oil in the crankcase-3.2 quarts to start when you change engine oil. Inspect the oil-pan gasket, drain-plug, oil-pump seal

Nov 24, 2009 | 1997 Toyota Camry

1 Answer

My 1990 toyota camry v6. i just recently put some


put some stop smoke in it will prob be your rings

Nov 22, 2009 | 1990 Toyota Camry

2 Answers

Need to know what parts should be replaced when changing the timming belt on a 2001 toyota camery 4cyl


Hi. Since you took the chance of opening the engine to replace the timing belt, you might replace the seals and gaskets for the head, cover, and crankcase, including the valve seals. in this way you will add brand new seals, minimizing or eliminating any leak problems. Also, try to use shur-tak spray. This one hold the gaskets in place while putting the engine back together and adds a protective layer to them as well. Ask for it at any parts store.

Aug 12, 2008 | 2007 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...