Question about 2005 Mitsubishi Lancer

1 Answer

Need tune up What needs to be taken off to access the sperk plugs?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 14,036 Answers

YOU HAVE TO REMOVE THE ENGINE TOP COVER.DISCONNECT THE IGNITION COIL.REMOVE IGNITION COIL.YOU NEED THE LONG SPARK PLUG SOCKET OR LONG 3/8 EXTENSION.YOU NEED A 3/8 RATCHET WRENCH.

Posted on Jul 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is and what firing order of spark plugs for 2008 ford f150 4.0l v6


Firing order can be obtained at any parts store, online or at a dealer. Misfiring can be a bad spark plug, a bad spark plug wire. Bad news is a bad value seat (most likely intake) or the fuel injector may be the issue.

Apr 02, 2017 | Ford Cars & Trucks

1 Answer

How to fix a p0302 and p1582 on vw golf gl 98


U HAVE MISFIRE AT CYLINDER 2.CHECK SPERK PLUG AND CABLE.IF U CAN DO SO.THIS IS FOR P0302...CLEAN THE THROTLE CONTROL BODY.DIRT MUST BE MORE THAN ACCEPTABLE.LET ME KNOW IF U NEED MORE INFO.

Dec 11, 2014 | 1998 Volkswagen Golf

1 Answer

How would you gain access to change the spark plug on cylinder 6 of a 993 turbo?


hello there
To get to number 6 spark plug...you have to lift the car in the air.Then remove right rear wheel.
Remove from the inside if the engine compartment right side sheet metal where the sperk plug wires go trough.The are also 3 bolts next to the powersteering pump drive (on this sheet metal)-remove them as well.
Once you remove this sheet metal you will gain access to the spark plug....
let me know if you need more help

proporsche@yahoo.com

proporsche

Aug 08, 2011 | 1996 Porsche 911 Turbo 3.6

1 Answer

Hi..mercedez benz ML-320 1999 YEA.check engine light comes and goes...codes 0300..0302..0304..cheked sperk plugs...what shoud i do..thanks


Those codes are Misfire codes, I would change the spark plugs, check or replace coil packs or wires, check or clean fuel injectors, and replace fuel filter.

Jun 14, 2010 | Mercedes-Benz ML320 Cars & Trucks

1 Answer

I HAVE A 1998 FORD ESCORT THAT CRANKS OVER BUT WILL NOT START. TRYED STARTER FLUID, AND I DO HAVE SPERK AT THE PLUGS. ANY SUGESTIONS?


Check compression. This car is fuel injected right? Check for fuel at injectors.
Timing belt good not loose (supposed to be changed approx every 60,000 mi.)

May 11, 2010 | 1998 Ford Escort

1 Answer

Engine wont start, suspect fuel filter needs replacing


see if you have spark first rubber handle screwdriver into a sperk plug wire and hold 1/4 inch or so from a ground source

Sep 08, 2009 | 1999 Ford Windstar

1 Answer

The gear is not picking as fast as it suppose to


When was the last time you have the tranmission fluids changed? Tune up? You should have a tune up every 40,000 miles..Bosch sperk plugs four tips! You shall see a big difference.

Jun 06, 2009 | 2001 Volkswagen Passat

1 Answer

Tune up


the rear plugs are accessed from under the van, they are a pain to change.

Apr 26, 2009 | 2001 Ford Windstar

1 Answer

Dealer holding me hostage


Not giving any type of legal advice ;) but you need to read what is covered under your warranty. I don't believe that anything is covered that constitutes as tune-up or under normal maint. unless they gave you one of the oil change or tires for life deals. Sorry but check into it. You may not need all those parts but if you buy a scanner you can check most of it yourself plus changing the plugs and wires isn't that hard even if you have a V10. Also everyone knows that if you take a vehicle to a dealer for a tune-up you're going to pay what the dealer hourly rate is ..... just a suggestion if you want to have someone do the tune-up for you take it to a small garage their hourly rate will most likely be half of what a dealer is. Plus they don't have the mark-up cost on parts as much as what a dealer does.

Jan 04, 2009 | 2007 Dodge Ram Truck

1 Answer

This car was taken to the repair shop for a tune up It drove in and had to be towed home the lady says that maybe the wires were crossed where should I start? and what size is the star tool needed to...


you need torx 30 or 35, and most likely they just forgot to connect some cables bak, otherwise the car would be bakfiring, with crossed cables.

Jul 30, 2008 | Volvo 960 Cars & Trucks

Not finding what you are looking for?
2005 Mitsubishi Lancer Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...