Question about 1998 Ford Expedition

1 Answer

How do i remove the old ignition from my 1998 ford expedition eddie bauer edition

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 249 Answers

If you still have the key there is a small hole in the bottom plastic of the steering column where you can put a small screwdriver or pick up through and push the pin in with the ignition on and it will slip right out.. It may take a couple tries to get the right spot but you will feel the pin push in as you turn the switch.

Posted on Jul 30, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 95 ford explorer eddie bauer edition and it runs fine but my antitheft light r bliking how do i get them off???

this is one american motor i have done around this year and by-passed the immobilisor so i suspect that the immobilisor has already been by-passed but they didnt remove the bulb in the dash

Mar 07, 2012 | 2007 Ford Expedition Eddie Bauer EL

1 Answer

Cant find the cabin air filter in my 1998 ford expidition

It seem that only the Eddie Bauer Edition had a filter,from the factory

You will how ever, have a place to put one,pass side,near firewall,there is a cover

Nov 24, 2010 | 1998 Ford Expedition

1 Answer

How do you change a flywheel on a 1998 Ford Expedition, 5.4 L Eddie Bauer edition??

You will need to remove the transmission and (transfer case )if equipped to gain access to the flywheel. Once the tranny is out of the way you will be looking at the flywheel. If it is an automatic you will need to remove the torque converter bolts from the flywheel before tranny removal. Also if it is an automatic be sure to get the torque converter to engage the front pump in the tranny when you reinstall.

Nov 22, 2010 | 1998 Ford Expedition

1 Answer

How do you flush the cooling system in 2007 ford expedition eddie bauer edition 8 cyl

Due to hazmat regulations the best answer is to have it flushed at a quick lube shop they are the most qualified to handle the waste generated in this process.

If you are going to do it your self ensure motor is cool additionally that your never allow antifreeze to stand out alone it is very toxic.

Don't flush. Drain and refill only and take your old antifreeze to your local hazwaste center for disposal.

Hope this tip helps.


Feb 14, 2010 | 2007 Ford Expedition Eddie Bauer EL

2 Answers

1998 Ford Expedition Eddie Bauer SERVICE ENGINE SOON light

Take the vehicle to any local auto parts store that will read the codes. WRITE THEM DOWN, and report back here for further help.

Dec 21, 2009 | 1998 Ford Expedition

1 Answer

Location of Shift Solenoid in 1999 Ford Expedition Eddie Bauer?

They are round "cans" with wires attached. You should have SSA, SSB, SSC, Torque converter and Pressure Control solenoids. They control pressures and have no mechanical linkage.

Oct 17, 2009 | 1998 Ford Expedition

1 Answer

New starter and battery and still won't start

Could be voltage regulator or starter relay has also gone bad. Seems to be fairly common in the Bauer editions.

May 22, 2009 | 2000 Ford Expedition

1 Answer

1998 ford expedition eddie bauer edition winshield wiper sometimes works and sometimes it doesnt... i would like to know where the location of the windshield motor

if you take off the wiper themself and then remove the trim under them the wiper motor is on the driver side you may have to replace the motor and if there is a go yard around you there you can get one at half the cost you can also take one off a F-150 the same kind of truck one has a bed the other one has seats also try to help you find one.

Apr 12, 2009 | 1998 Ford Expedition

2 Answers

Diagram bypass heater cord on 2001 ford expedition eddie bauer

the heater bypass is quite simple, if you look at the firewall you will see two medium sized coolant lines, remove them from the firewall and link them together using a proper sized tube, you can purchase a kit at a parts store quite cheaply

Sep 12, 2008 | 2001 Ford Expedition

Not finding what you are looking for?
1998 Ford Expedition Logo

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides