Question about 1993 Toyota Corolla

2 Answers

How do i check fuel pump on 1993 toyota corolla

How do i check fuel pump

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

THis is normally done with a pressure gauge on the fuel rail. Do you suspect a fuel delivery problem? Take off the air filter and spray a little carb cleaner in the intake manifold and crank. If it tries to start you are going in the right direction possibly fuel pump. Use extreme caution not to spreay too much. If the car backfires you may see a backflash flame!

Posted on Jul 30, 2010

  • jrwgoldstr1 Sep 20, 2010

    Turn the key on listen for pump, its in the fuel tank, if you do not hear it. . In front of the brake booster there is a test plug take a wire and short across the rear two pins this should turn on the fuel pump with key in the on position. you will be able to hear it if it turns on if you do not hear i. t pump could be bad be sure all fuses and relays are good before replacing pump
    You can shoot a little starting fluid in air intake if the engine doesnt fire problem may be elsewhere and not fuel pump. if pump is good check injectors

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How do i check fule pump 93 toyota corolla?

Posted on Aug 05, 2010

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1993 toyota corolla fuel pump fues are relay

gghjjm,

Posted on Dec 21, 2009

manuelleiva
  • 97 Answers

SOURCE: where is fuel reset button on 1993 toyota corolla wagon

i am pretty sure that this type of car does not have a reset button for the fuel.i have the same toyota,but mines is a sedan and i have never seen one on it.if your not getting any fuel,check your fuses,if good,check your fuel pump which is located right under your rear seat.hope this info helps.good luck and take care, manny

Posted on Jun 19, 2010

Pelukes01
  • 52 Answers

SOURCE: 1993 toyota corolla how to replace watwr pump

  1. Place the water pump gasket (O-ring) on the block and install the pump. Tighten the mounting bolts evenly to 11 ft. lbs. (15 Nm). Install the timing belt covers, making sure they are properly seated and not rubbing on the belt or other moving parts. Install a new seal (O-ring) on the dipstick tube and lightly coat it with engine oil. Remove the plug and install the dipstick tube and dipstick; secure the mounting bolt to 82 inch lbs. (9 Nm).
Using a new O-ring, install the inlet pipe to the water pump.
Attach the clamps and bolts to hold the pipe in place and tighten to 7-9 ft. lbs. (9-12 Nm).
Connect the water inlet and water bypass hoses to the inlet pipe.
Install the water pump pulley and temporarily tighten the four pulley bolts.
Install the drive belts on all the pulleys and adjust all of them to the correct tension.
With the belts in place and adjusted, the water pump pulley will now resist turning. Tighten the pulley bolts to 16-18 ft. lbs. (22-24 Nm).
Install the front engine mount (mounting insulator).
Confirm that the draincocks are closed on the engine block and radiator. Refill the engine with coolant. Reconnect the negative battery cable. Start the engine and check for leaks.

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel rail pressure code 43 / Po191


Check to make sure the fuel pump is working. If the fuel pump is not working check the fuel pump fuse and fuel pump relay, also check to make sure the inertia cut off switch hasn't been tripped. If the fuel pump is working then check the fuel pressure regulator.

Nov 27, 2015 | Ford Freestyle Cars & Trucks

2 Answers

1995 KIA sportage has no voltage to fuel pump but has voltage to fuel gauge


check for blown fuse check for bad fuel pump relay. check for bad wires.

Feb 25, 2015 | 1995 Kia Sportage

1 Answer

316 cranking but not starting


Most likely fault due to lack of fuel supply to engine. Make sure there is fuel in the tank. Check fuse for fuel pump relay, check fuel pump relay clicks when switched on. Check power is going to fuel pump (voltmeter is easiest). Check fuel pump is running (listen to pump).

Jan 23, 2015 | BMW 316i Cars & Trucks

2 Answers

No fuel coming to carburator


It could be fuel pump or fuel pump relay.Click here to see how to remove fuel pump.Click here to see fuel pump.See how much the fuel pump is,make sure it's that.Here's the fuel pump relay.Here's how to remove fuel pressure.

Dec 23, 2012 | 2003 Saturn VUE

2 Answers

Secondary fuel pump is going out what do i have to fix


Your 2000 Ford. only has one fuel pump, no secondary, if no fuel pump pressure, check fuse, if fuse good, check voltage at fuel pump connector, fuel pump sit in gas tank, check voltage there, will only have voltage for 3 -5 seconds, every time the key is cycle, from on to off, if you have voltage there, bad fuel pump, fuel tank will have to come off, to replace fuel pump.

Sep 01, 2010 | 2000 Ford Taurus

1 Answer

My van wont start, it turns over but acts like it is not getting any fuel. Could it be fuel pump or filter?


did you check the spark if occur when cranking engine, if it have spark, direct fuel pump by shorting 30 and 87 pin off fuel pump relay and check if theres fuel go to fuel injectors, check for pressure, if no fuel, connect voltage directly to fuel pump assembly, if fuel turn s, check circuit, if no fuel goes, check the tank for empty fuel, if you have fuel change the fuel pump including fuel filter

Jun 26, 2010 | 1997 Mazda MPV

1 Answer

1997 Ford F150 Electric Fuel Pump will npt pump


Did you check the fuel inertia switch in the passenger side kick panel ?

The fuel pump is powered :
the fuse to the fuel pump relay.
The fuel pump relay to the fuel inertia switch
The fuel inertia switch to the fuel pump itself.

At the fuel inertia switch in the kick panel, power from the relay is the Dark Green w/ Yellow stripe wire and the pink w/ black stripe wire is the power. from the fuel inertia switch to the fuel pump.

If you jumper the fuel pump relay, you should hear it run. If not pull the fuel pump relay, and check the pins in the relay socket, pin 30 should be the power from the fuse.

50b0c31.jpg

If you have power at pin #30, jumper the relay socket as shown with the red line above, and check the dark green w/ yellow stripe wire at the fuel inertia switch for power.
Press the button on the top of the fuel inertia switch, and check for power leaving the fuel inertia switch on the pink w/ black stripe wire.

This is tests good, check for power at the fuel pump, same pink w/ black stripe wire.
Fuel inertia switch info is in the owners manual, If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Jan 03, 2010 | 1997 Ford F150 Regular Cab

2 Answers

It will not start. We changed the fuel pump three times. Each time the new fuel pump will not hum or buzz when you turn the igntion.


Did you check the fuel pump wiring harness, fuel pump ground , power to the fuel pump, fuel pump fuse , fuel pump relay

Oct 18, 2009 | 1999 Chevrolet Venture

2 Answers

Mi truck a toyota 85carb,when I rever up high rpm starts missing like not enough gas You think maybe is the fuel pump?


If it start and it misses and like not enough gas. it means that there is a problem in the fuel pump that why you have to check the fuel pump and the fuel lines may be there is a dirt or may be the fuel pump is worn out.But if you don't have time to fix the problem of your fuel pump . Then you have to go to a car mechanic and let them fix the problem of the car. But if you have time to fix the fuel problem then this is what to do.The owner of the car should be able to check fuel lines .Prepare the equipment and tools to be used in checking fuel lines .So that fuel will flow freely and no abstraction within the fuel lines .Locate the fuel lines ,visual inspection on duel lines for learage, Disconnect lines at fuel pump and fuel pump.Use compress air to remove sediments on fuel lines .Re-install fuel line to the unit.But if the problem is the fuel thank that it is being worn out or malfunctioning .The owner of the car should prepare the equipment or tools in servicing the fuel pump.So that fuel pump will operate properly .Locate the fuel pump .disconnect the fuel lines from the fuel pump.remove the fuel pump from the engine. Dis-assemble the fuel pump.Check the diaphram for defects.Replace defective parts.Assemble and install the fuel pump.And always use safety rules in servicing the fuel pump.

Oct 04, 2009 | 1985 Toyota Pickup

2 Answers

Fuel Pump is not pumping fuel


What have u done to solve this--do u have power to the pump? Is the pump grounded? Is the pump working? Check the fuel lines and fuel filter.

Jul 08, 2009 | 1995 Buick Riviera

Not finding what you are looking for?
1993 Toyota Corolla Logo

Related Topics:

1,053 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...