Question about 1995 Nissan Altima

1 Answer

The vehicle was at a stop light and just cut off and would not recrank. I see that the vehicle is not firing from the coil. The coil was replaced and the vehicle is still not firing. what should I check or replace next. This is a 1995 nissan altima with a 2.4L engine.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 395 Answers

Most likely the Spark Trigger Module in the Distributor.

Posted on Jul 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I accelerate from a stop sign or stop light my Honda Accord stops accelerating cuts out like it's missing a cylinder fire


this a problem ignition timing. Need to reset to manufacturer specification, They imply you need to make a mayor TUNEUP. Pass the scanner/computer for easy diagnostic and fix it. You can have some faulty ignition coil or PCM or BCM or sensor,distributorc4c56f9d-edf0-43e1-9703-e5fa31985ec4.jpg etc
see the diagram attached.

Jul 12, 2013 | Cars & Trucks

1 Answer

97 grand prix rpm gauge/cuts out also


have you checked the fuel pressure. maybe a clogged fuel filter or a bad fuel pump

Jul 04, 2013 | Cars & Trucks

1 Answer

What would cause my distributor to get shorted out?


When it doesn't start, check for spark from the coil.

Aug 29, 2017 | 1997 Nissan Pickup

1 Answer

I got distracted what is my fireing order 2.8L w/coilpack


1-4-3-6-2-5

3 (Coil Pack) 5
2 (Coil Pack) 4
1 (Coil Pack) 6
Front of vehicle

I hope you understand my little diagram not good at cutting and pasting pictures. I hope this helped and good luck.

Feb 08, 2011 | 1999 Volkswagen Passat

1 Answer

1997 jeep grand cheerkee tunes over but won,t start no fire from coil to distributor


So you have B+ to coil but no B+ from coil to distributor. Sounds like the ignition module.
Its not triggering coil to fire . Double check it with a test light at negative side of coil and then to ground.crank the vehicle if light flickers its ok if not its your culprit.
Should light flicker then test its the wires from coil to distributor, distributor , rotor and plug wires.
Honestly if the light flickers your not losing anything by replaceing the items from the coil tower to the plugs.

May 04, 2010 | 1997 Jeep Grand Cherokee

1 Answer

I was driving my 87 Dodge w150 225cid slant six when it stopped running (as if the key was turned off). Will not start. No spark from coil wire, no voltage positive post of coil when cranking. Replaced...


if you are not getting any fire from the coil check the ignition resistor mounted on fire wall. you can have someone to turn key over to start and u can take test light and check both sides of resistor . if no fire on side going to coil (replace it). hope this will help!!!!

Apr 05, 2010 | 1987 Dodge W150

2 Answers

P1320 trouble code plus


The P1320 code is essentially a coil primary voltage problem. This is traceable using a labscope or accurate DVOM and perhaps you can isolate one or two coils that still work but are close to failure...but there is a nissan service message recommending replacement of ALL coils with updated/improved models to prevent this type of failure. TCS/SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel.

Sep 09, 2009 | 2000 Nissan Maxima

1 Answer

2001 Jeep Cherokee Classic shakes and sputters when recranked after driving. Only does it once it's been driven somewhere and ignition is killed, then recranked. Doing it about a week then check engine...


Sounds like a fuel/air problem. Replace fuel filter, check/replace air filter and spark plugs, complete the tuneup and see what happens. If it still happens then suspect injectors. Run cleaner through a tank of gas. If still the same take it to a shop that can plug into your vehicle and verify injectors performance.

Mar 26, 2009 | 2001 Jeep Cherokee

1 Answer

CAR CUTS OFF WHEN IT GETS HOT MAYBE ENGINE MODULE Car shuts off when I am driving and when it gets hot.


if your car has a coil pack it could have a hair line crack and would need to be replaced this would cause the car to stop running once it get hot because when it overheats the coil pace quites allowing your spark pluges to fire which causes the car to stop running

Dec 05, 2008 | 1994 Oldsmobile 88

Not finding what you are looking for?
1995 Nissan Altima Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...