Question about 2001 GMC Yukon XL
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2001 gmc yukon xl 1500
Check to see if the power steering pump is still turning. If you have a broken drive belt (serpentine belt or "fan" belt), and the pump doesn't turn, you have no power assist. If the pump is still turning, check the fluid level in the reservoir.
Posted on Oct 31, 2008
Mark your drive shaft coincidenly with the rear axle and tranny. Remove drive shaft. Press out the old u joints and press in the new. You will need a torch for heat and a lot of patience. Have fun!
Posted on Jun 20, 2009
Try turning key to on only, not start, 2 or 3 times first then try to start. If it starts good first try, then I'd change my fuel filter & then have fuel pressure tested if fuel filter didn't help. You may be looking at a new pump, but lets do filter & test fuel pressure first.
Posted on Jul 06, 2009
Not a module problem: a single module is used for both sides and the hazard signal. Your command lever from the steering column is faulty and it will have to be replaced. Here is a replacement one
Posted on Mar 01, 2011
Tips for a great answer:
Dec 15, 2012 | 2001 GMC Yukon XL
Jun 20, 2010 | 2001 GMC Yukon XL
Jan 13, 2010 | 2003 GMC Yukon XL
Dec 17, 2009 | 2002 GMC Yukon XL
Dec 14, 2009 | 2000 GMC Yukon
Apr 17, 2009 | 2001 GMC Yukon XL
Sep 21, 2008 | 2001 GMC Yukon
196 people viewed this question
Usually answered in minutes!