Question about 1997 Kia Sephia

1 Answer

No spark turns over freely is there a reset

No spark turns over freely is there a reset button

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

No reset button,

Posted on Jul 29, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Everything seems to be working but it won't start.I'm not getting spark. Turns over fine.Is there a collision button on this car and do you k now where it is ?

The collision reset you're asking about is called the fuel shut off switch. It only kills the fuel supply or shuts off the fuel pumps to the engine when an accident occurs.

Your problem could be caused by a relay or a fuse but I would pull the codes from the ECU first, that way you know what area to look at. If I had to guess, I'd say your crank position sensor was probably bad.

Aug 28, 2016 | 2005 Hyundai Elantra

1 Answer

Have 82 f100 with 3.8 motor when I let out clutch it bogs down ?

truck got tune up recently? good spark from each plug (ignition coil, distributor cap & rotor if equipped, spark plug wires), good fuel delivery, idle rpm & ignition timing set to specs? transmission turns freely?

Oct 07, 2015 | Cars & Trucks

1 Answer

Is there a fuel reset button on a 1996 Subaru Impreza my car shut off now will not start it turns over we have change the camshaft sensor the crankshaft sensor spark plugs and it's still just turns over

No reset button. Ford is the only one that uses them.

have you checked for spark? Have you checked fuel pressure?

i would assume that you checked for spark and found none since you replaced the crank sensor which provides information for both spark and injector pulse.

Where the plugs wet with gas when you pulled them out?

I’m happy to assist further over the phone at

Mar 06, 2015 | Subaru Cars & Trucks

1 Answer

Town and country wont start Replaced starter a month ago Then a week ago starter sounded as if it was stuck or just spin I would turn the drive shaft to start the van but now thats not working Now when I...

i would suggest you remove spark plugs / gloplugs and see if the engine will turn freely by putting a socket on the crankshaft pulley.
If the engine turns freely, I would think the flywheel ringgear may well be the culprit.

Apr 15, 2014 | Cars & Trucks

1 Answer

How reset spark plug indicator in VW golf sdi 1999?

You need a Scanner to reset the Spark Plug Light on your car, I have never found a way to clear the light on the VW without it. Volvo is the same way... It is a way for them to make money. On similar cars, there is a way of setting the Trip Counter to "A" and then Depressing the Button and Then turning the key. you can try that method but I do not think it will work.

Apr 01, 2014 | Volkswagen Golf Cars & Trucks

2 Answers

No spark just stoped running

see if you have voltage going to ignition if not sounds like cam sensor

Mar 08, 2014 | 1992 Buick Regal

1 Answer

1994 another Toyota Camry won't start.

Sounds like a timing chain , worst case, Would you say it's turning over almost too freely?? Look under your cap, and turn motor over, the rotor shouldn't turn if the timing chain is gone, but may turn if it jumped it's timing. Then you'll have to have a look under the timing cover . let me know if this helps

Jan 16, 2013 | 1994 Toyota Camry

2 Answers

MY 2004 Ford Ranger engine turns over but wont start.

Are you getting fire?have you checked your fuel filter and coil pack

Dec 08, 2012 | 2004 Ford Ranger

1 Answer

My 1995 Mazda Protege 1.5L was running fine. We were driving home and the car cutoff, will turnover but will not crank. I can take the oil cap off and see one of the CAM's turning and turning freely

if you can see the cam shaft turning then the timing belt is ok
run the fault codes and check for crank position or cam shaft position sensor failures
one or the other or both are candidates for your problem

May 18, 2017 | 1997 Mazda Protege

1 Answer

No spark inline six turns over strong, has fuel,

take the cap off of the distributer grab the rotor and make sure it does not spin freely if it dooes the pin had sheared off the gear if not replace the ignition module on the distributer if if there you should see it if not it will be on drivers fender

Aug 09, 2009 | 1988 Ford F 150

Not finding what you are looking for?
1997 Kia Sephia Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

81294 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides