Question about 2000 Honda Accord

1 Answer

How do i replace the check engine light in a 2000 honda accord, it is burnt out

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 327 Answers

Hello, The following steps will show you how to do that:

1. Check to make sure your engine is off. This may sound like common sense but this is important.


2. Check to make sure your gas cap is tighten. Take it off and place it back on until you hear the gas cap click.

3. Open the passenger side door. Look for the fuse box located on the side of the dash board. You'll see it says fuse. Open the fuse box.

4. Look on the backside of the fuse panel door. You should see a lists of the arrangement of the fuses. Locate the fuse that says "Clock." This should be fuse number 13. Use tweezers or preferably a fuse puller. Pull the fuse.

5. Leave the fuse out for about 10-30 minutes. Place the fuse back in. Your car system will reset. The clock and radio settings have returned to default settings and check engine light should be off.

Thanks


















Posted on Jul 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Honda Accord 2000 6 cyl. I have 3 brake lights, and the only light working is the top one-the other 2 do not light up you hit the brake pedal.. All my lights work, hazards, left/right turn signal,...


there is a little box on the left side of the trunk in the brake lamp harness chances are this little control unit burnt up. find it and unplug it and make sure the connector did not get burned also take the box apart it will have some tabs by the connector end to slide the inside out check the printed circuit board to see if it is burnt.If it is it will cost you about a hundred bucks from the dealer.

May 14, 2011 | 2000 Honda Accord

Tip

1999 Honda Accord Clock Burnt Out Light Bulb/Lamp Replacement


The Honda OE part number of the Clock Light Bulb2_bing.gif/Lamp replacement is # 35505-S84-N01. The part cost me $3.25 from a local Honda Dealer. A good site with instructions on how to replace the burnt out bulb is http://automotive.trevorated.com/
This part number may work for most G6 / 6th Generation Honda Accords, though I do know it works for my 1999 Honda Accord 4-speed automatic.

on May 07, 2010 | Honda Accord Cars & Trucks

1 Answer

I have a 2000 Honda Accord V-6 that had an engine light on code


check egr ports may be filled with **** or egr might be full of **** and need clean

Jan 08, 2010 | 2000 Honda Accord

2 Answers

Check engine light


Before you start replacing everything it is definitely worth investing $60 for a code reader to see exactly what the code is. We recently spent a ton of money on our 2000 CRV with persistent check engine. Dealership replaced rotor, cap, wires, plugs etc. Turned out to be burnt exhaust valves. Rebuilt engine was bad enough without all the money we spent for no reason before we found the real problem. At least with the code reader you will know where to start looking.
Good Luck.

Sep 25, 2009 | 2000 Honda Accord

1 Answer

The "S" light on my 1990 honda accord came on, then check engine light came on. Parked the car. Then when I started it again later, there was a clanking noise and car shuddered.


That s light is an indication some is going out in your transmission check your transmission fluid level engine off,if ok smell fluid see if like burnt

Sep 23, 2009 | 1990 Honda Accord

1 Answer

Gear shift wont light up


You either have a burnt out buld, or a bad connection to the indicator sircuit.

Sep 09, 2009 | 2000 Honda Accord

1 Answer

Check Engine Light - 2000 Honda Accord


it could be that the air filter housing is worn and thats why they said you needed a new one what that means is that you are getting to much air into the engine and will cause check engine light to come on i would replace that and then see if it goes off and then if not go to a auto zone and they check the light and see what it is and then go from there

Jul 19, 2009 | 2000 Honda Accord

2 Answers

2000 Accord Transmission Problem


Hello mew2149...Honda had a recall on your transmission for several failures, the one you describe being among them. If you have 194k with no problems then you are one of few. Honda extended warranty to help owners absorb the cost. http://world.honda.com/news/2002/4020920.html A good transmission shop will be able to evaluate your problem better with pressure tests. The torque converter could be bypassing fluid, pump weak, clutch pack worn...etc. Good luck...i hope this helps.

Jun 04, 2009 | 2000 Honda Accord

1 Answer

2000 Honda Accord Check Engine light on p0740


YOU HAVE A TORQUE CONVERTER PROBLEM. TORQUE CONVERTER CONTROL CIRCUIT MALFUNCTION CODES CAN COME FROM ELECTRICLE TO INTERNAL MALFUNCTION. IF YOU START EXPERIENCING A HARD SHIFT OR FREE SPIN TO HARD SHIFT DON'T BE SURPRISED. TRY CHANGING FLUID. THIS MAY HELP. HONDA WOULD HAVE REPLACED TRANS IF UNDER 105 k FOR FREE. IF YOU HAVE TO REPLACE TRANS. BUY ONE FROM HONDA, 3 YR WARRANTY AND AS CHEAP AS A REBUILT TRANS. HAVE A QUALIFIED PERSON INSTALL, YOU WILL SAVE ABOUT $500 DOING IT THIS WAY. GOOD LUCK

Mar 16, 2009 | 2000 Honda Accord

1 Answer

98 honda accord panel lights will not turn on


Did you check the dimmer to switch? This is for a 2000 Honda Accord but this may help you: If your instrument lights have burnt out on your 2000 Honda Accord.... You may have another problem!!! While the dealer fixes this recall, they should replace your burnt out bulbs. 2000 Honda Accord Recall ID from NHTSA: 04V256000 Auto Recall Date: 06/07/2004 Vehicle Component: INTERIOR LIGHTING Estimated Vehicles Affected: 19572 2000 Honda Accord Defect Summary: ON CERTAIN PASSENGER VEHICLES, THE DIMMER CONTROL FOR THE INSTRUMENT PANEL LIGHTS COULD FAIL DUE TO HEAT BUILDUP. Defect Consequence: IF THIS OCCURS, THE INSTRUMENT LIGHTS MAY FAIL AND, AT NIGHT, THE DRIVER MAY NOT BE ABLE TO SEE THE INSTRUMENT PANEL GAUGES, SUCH AS THE SPEEDOMETER. Remedy: DEALERS WILL REPLACE A MULTIPLEX CONTROL UNIT FOR THE INSTRUMENT PANEL LIGHTS. OWNER NOTIFICATION BEGAN JUNE 16, 2004. OWNERS SHOULD CONTACT HONDA AT 1-800-999-1009. Notes: AMERICAN HONDA MOTOR CO., P36

Nov 25, 2008 | 1997 Honda Odyssey

Not finding what you are looking for?
2000 Honda Accord Logo

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...