Question about 2003 Saab 9-3

Open Question

Remove ashtray unit from saab 93 2003

Remove ashtray unit from saab 93 200, (located on front console under cd unit)

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

UNABLE TO LOCATE PLUG FOR DIAGNOSIS OF CHECK ENGINE LIGHT


It's located at the front of the center console, directly below the radio, behind the ashtray. Yes, you'll have to remove the ashtray to get to the OBD plug.

Sep 07, 2011 | 1997 Honda Accord

1 Answer

How would i take my fectory radio out of the car?


Radio & Tape Player

  1. Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
  2. Remove the floor console and the front console panel. On 1984-85 cars, if access to the back of the radio may be gained through other means, such as removing the "pocket" from the console, the console need not be removed.

54d84d0.gif
Radio mounting on 1990-93 Accords

4. Remove the ashtray and ashtray holder.
5. Remove the two screws holding the radio at the rear of the unit.
6. Carefully push the unit out the front of the dash. When access
is gained, disconnect the multi-pin connector and
the antenna cable from the unit. Remove the unit.

7. Reinstall in the reverse order. Take great care not to damage the dash trim and instrument visor. Make certain the connectors are firmly and squarely installed. If applicable, be sure to enable the SRS.

Mar 06, 2010 | 1992 Honda Accord

1 Answer

How do I remove the radio on a 1987 Honda Accord LXi


Radio & Tape Player
  1. Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
  2. Remove the floor console and the front console panel. On 1984-85 cars, if access to the back of the radio may be gained through other means, such as removing the "pocket" from the console, the console need not be removed.
e4b1a33.gif
Radio mounting on 1986-89 Accords

  1. Remove the ashtray and ashtray holder.
  1. On 1986-89 cars:
  2. Remove the coin box, air vents and ashtray lighting bracket.
  3. Remove the dashboard switches on the left and right of the steering wheel.
  4. Lower the steering wheel to its lowest position. Remove the dash visor. This is a large, one-piece assembly which includes the center dash trim. It's plastic; don't break it.
  5. Remove the two screws holding the radio at the rear of the unit.
  6. Carefully push the unit out the front of the dash. When access is gained, disconnect the multi-pin connector and the antenna cable from the unit. Remove the unit.
  7. Reinstall in the reverse order. Take great care not to damage the dash trim and instrument visor. Make certain the connectors are firmly and squarely installed. If applicable, be sure to enable the SRS.

Dec 07, 2009 | 1987 Honda Accord

1 Answer

How do u get the wood part around the cd player off in a 2000 diamante


1. Put on the emergency brake and put the transmission in neutral (key must be on, brake must be pressed). Having the shift lever in neutral allows the console to clear it.

2. Remove the front cupholder by pulling it up and out. Set it aside in safe place so you won’t accidentally scratch or break it while continuing your job.

3. Clean out the coin compartment and leave the door open.

4. The console trim pieces are held in place with metal clips. Reach through the opening at the rear of the coin compartment and pull up on the lower console trim until it unsnaps. Continue to unsnap the lower console trim, rear to front. It hooks into the ashtray, so don't try to pull it up from there. Once you have unsnapped the trim from the console, it will pull back and out from the ashtray. Lift the lower console trim up and disconnect any wiring connectors, then remove it up and over the shift lever. Set it aside in a safe place.

5. Put the car back into park for now (key on, press brake, shift, then remove the key).

6. Reach under the bottom of the whole ashtray unit (not just the ashtray) and pull it back towards the rear of the car until it unsnaps, but don’t completely remove it yet. Remove the wiring connector from the ashtray and set the ashtray aside in a safe place.

7. Next, you are going to remove the center vent unit just above the AC controls. If your model has a thumbwheel on the left side of the vent unit, you must first unhook the cable. Use a light to look under the dash from the driver's side, find the end of the cable, unclip it and unhook it from the peg. If you have a problem identifying the cable, move the thumbwheel up and down while looking under the dash and you can see the cable end moving. Remember how it was installed so you can reconnect it later.

8. Now comes the hard part. Work your fingers into the area of the center vents just below the digital clock lens. Unsnap the vent unit by pulling it out towards the rear of the car. It may take some pulling, so be careful. Once the center vent unit unsnaps, remove it from the dash and set it aside in a safe place.

9. You now can see the upper and lower mounting screws for the center unit. Remove the screws, being careful not to drop the screws inside of the dash.

10. Carefully pull the center unit out a bit from the dash. You will have to disconnect all the wiring and a tube before you fully remove it.

11. Disconnect the wiring from emergency flasher, and pull the AC temperature sensor breather tube off.

12. Disconnect all the connectors from the AC unit and the radio. Use a flat blade screwdriver to press the tab on those connectors with one. The screwdriver will also help you pry those connectors out of their sockets. Remember how everything was connected so you can put it back later.

13. Once you have the connectors disconnected the center console unit can be removed from the dash. Set the unit face down on a soft surface and remove the screws that hold the trim in place. The radio is mounted by screws that go into each side.

14. Reassembly is the reverse of the above steps. Be careful to not overtighten any of the screws, or they may strip out their mounting holes.

Nov 11, 2009 | 2000 Mitsubishi Diamante

1 Answer

How to remove 1990 xj6 radio


You must open the center console lid and remove the 2 Phillips head screws above the fuse station to expose the ashtray Phillips head screws.Remove the ashtray screws and carefully pull he ashtray back towards the center console. After the ashtray is removed take your hand an feel under the wood grain unit for the 2 plastic wing nuts holding the wood grain in place. Remove them and gently lift the wood grain up and out of the way. Remove the 4 Phillips head screws holding the AC controls and Radio bracket. Place the gear shifter in drive to pull the whole unit out. Sounds like a lot but takes about 10-15 mins to complete.

Aug 29, 2009 | 1990 Jaguar XJ6

1 Answer

I need to replace the cigarette lighter unit and don't know how to take the dash apart


turn ignition switch to on ,shift trans into neutral,i'm assuming this is a baja,remove 2 screws under lid of center console cover lift this piece out of the way now remove bezel surrounding shifter,remove ashtray,above ashtray are 2 screws holding ashtray frame in place remove those now bezel surrounding radio can be removed and now you can remove cigar lighter good luck

Aug 19, 2009 | 2004 Subaru Baja

1 Answer

I have a 1999 Saab 9-5. The fan blower doesn't


The fan is located under the windsheild wipers. The windsheild wipers will have to be removed. Then remove the plastic shroud and wiper motor and assembly. The fan is located in the middle under the windsheild. If your feeling the AC you can check the stepping units located on the AC unit behind the front console under the dash.....KEH

Aug 04, 2009 | 1999 Saab 9-5

1 Answer

Ignition Switch Removal


you'll need to remove the console, as the key switch is between the seats. remove the shift boot cover and undo two console hold down screws (Torx 25) in front of the shift lever; there are two more in the aperture remaining when you take out the rear ashtray. Turn on the ignition key so you can put the shifter into neutral, and slide the console up and out between the seats (squeeze fit between the seat belt connectors) It's much easier if you get a sacrificial key cut, then cut the lobes off it!

with the console out, you'll need to remove the gear shift housing, for which there's a special Saab tool - they are 3 point heads. A six point socket with 3 points filed out might work. rotate the gear shift housing 90 deg to one side, to get at it's bottom, where there are two screws holding its cover in place.

With the cover off, you'll find two screws (T25) one on either side of the switch, holding the switch in place. Remove these and you have the switch. Note connections and alignments for re-assembly.

Hope this helps, if it does please give a "thumbs up"

Thanks

Saabreur

Jan 21, 2009 | 1986 Saab 900

1 Answer

Factory installed radio/casette player 1992 honda accors


You should disconnect the neg. battery cable and disarm the air bag. Remove the floor console and the front console panel, remove ashtray and ashtray holder, remove 2 screws holding the radio at the rear of the unit, carefully push unit out the front of the dash. When it clears enough, disconnect the antenna and multi pin connector. Remove the unit. Reverse to install. Enjoy the new sound system. countrycurt0

Sep 02, 2008 | 1992 Honda Accord

1 Answer

2003 Cadillac Escalade Front console removal


MY FRONT CONSOLE GLOVE COMPARTMENT NEEDS TO BE REMOVED ON MY 2003 CADILLAC ESCALADE TO GET MY PHONE FELL DOWN THROUGH OPEN CRACK.

Jun 28, 2008 | 2003 Cadillac Escalade Esv

Not finding what you are looking for?
2003 Saab 9-3 Logo

Related Topics:

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...