Question about 1990 Mazda 626

Open Question

1990 Mazda 323 LX 1.8..where I can locating the DRL Module and the Relay (daytime lights) not working

Posted by on

  • dezsoed Jul 29, 2010

    All reay fixed,,,,,blown Fuse, Which is under the Hood ,The fuse are just right corner beside the batterie. and the Resistor ,,

  • dezsoed Jul 29, 2010

    Check the Fuse are Blown which is under the Hood right corner beside the Batterie you see there the Resistor (with heatsink) attached to the car body there are connectors and here hiding the Fuse ( 10 Amp), on the wire covered with the Rubber.

    I just fixed it...working fine.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: MAZDA 323F 1990 MODEL

There you go, the prices, i dont know about the charges, sorry, try also go to Amazon.com
here is a link for you:
http://www.google.com/products?hl=en&q=steering+wheel+for+mazda+323f+1990&um=1&ie=UTF-8&sa=X&oi=product_result_group&resnum=1&ct=title

Posted on Jun 22, 2008

Ad
  • 218 Answers

SOURCE: Battery for 1997 Mazda 323 Astina 5dr hatch

It's fine to use a battery with a higher cold crank rating than original. Consider the rating in the manual to be a minimum requirement. You'll be fine as long as the physical dimensions and terminal placement are compatible with your car. The battery manufacturer's guide should tell you which battery fits your car.

Posted on Mar 03, 2009

  • 289 Answers

SOURCE: where is the starter motor on my 1990 mazda 323

its on the gearbox it bolts through it and connects to the flywheel on the bulk head side

Posted on Apr 22, 2010

johnjohn2
  • 5763 Answers

SOURCE: mazda 1990 323 1.8L LX, 5 minutes after the

Start by having the charging system checked,unless the car engine spins but doesnt start,if it spins over and wont start then it not the charging system,when the car dies check for spark, remove a sparkplug wire insert a screwdriver in boot and place 1/4 inch near metal and crank engine and see if theres spark,this will help pin point your problem if theres spark then the next thing to do would be to spray starting fluid in throttlebody and see if it starts,hope this helps let me know the results.

Posted on Jun 09, 2010

Testimonial: "Thank YOu for your info,,,Great help, The ingine has a Crank but not a spark retested all parts and found out the problem was in the Distributor the Module not worked, this part replaced whit a used one (150$)used Mazda Parts, and Now running fin, (Odometer 263.000 Km)"

jturcotte
  • 8266 Answers

SOURCE: can u tell me please where to locate fuel pump

It may be the circuit relay #21 in the battery junction box. See diagram below. Let me know if you have more questions.


jturcotte_89.gifjturcotte_90.gif

Posted on Nov 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy e3500 drl location


DRL location ? Module ? Lights ?
The operation of the daytime running lamps is controlled by the daytime running lamps control module. The module is powered by CKT 39 (PNK) from the GAUGES fuse, and it is grounded through CKT 150 (BLK). The module turns on the daytime running lamps under the following conditions:
Daytime Running Lamp (DRL) Control Module
Under the left side of the IP, taped on the IP harness

Jul 03, 2017 | Chevrolet Cars & Trucks

2 Answers

Can anyone tell me where the drl module is located on a 2000 Chevy Blazer


Behind the lower kick panel on the passenger's side good luck colin

Jun 24, 2017 | Cars & Trucks

1 Answer

I need clarification on 2003 Chev Malibu DRL problems:


That piece you think is a ceramic DRL module is a resistor , When in DRL mode voltage to the low beam headlamps circuit goes through that resistor dimming the headlamps from low beam to daytime running lamps . It sounds to me like you need a new resistor ,but without doing some electrical testing it could be a lot of things . The DRL relay in the under hood fuse box could have a problem , could be the BCM - body control module , the ambient light sensor etc... Here is how daytime running lamps work .
Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Feb 25, 2016 | Cars & Trucks

1 Answer

Where is the fuse located for the daytime running lights on a 2005 Chev Siveraado?


It is located in the underhood fuse/relay box , marked DRL 10 amp fuse ! Also if that is good check the DRL relay in the same fuse/relay box .Your light sensor could also be bad .
The daytime running lamps (DRL) will operate when the ignition switch is in the RUN position, for automatic transmissions (A/T), the gear selector is not in the PARK position, the headlamp switch is in the AUTO position, and for manual transmissions (M/T), the park brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate. The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the DRL or the headlamps for auto headlamp operation. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. The DRL can be manually turned OFF by depressing the AHL/DRL switch in the headlamp switch
Do you know that on inside of fuse box lid it shows what fuse is what .

Feb 01, 2016 | 2005 Chevrolet Silverado

1 Answer

I need help locating the drl microprocessor in my 2001 Pontiac sunfire


Pontiac Sunfire Questions - Daytime Running Lights ...

www.cargurus.com > Questions > Pontiac > Sunfire

CarGurusJul 22, 2009 - Daytime Running Lights - Relay clicks and then DRL shuts down. ... housing piece, but I couldn't seem to find any store or dealer to locate the specific part. ... The same EXACT thing is happening in my 2001 Pontiac Sunfire.Missing: microprocessor

Where is the DRL Module on a 2003 Sunfire? - Fixya

www.fixya.com/cars/t2791740-drl_module_2003_sunfire
Aug 24, 2009 - My wife's 2003 sunfire has a problem with the day time running lights and ... Your instrument cluster has a microprocessor which energizes the relay. .... Daytime Running light Module and relay on a 2001 Pontiac Sunfire GTX ...

DADRL - How To Disable DRLs


Jan 08, 2016 | 2001 Pontiac Sunfire

1 Answer

Where is the DRL Module on my 2007 Hyundai Tuscon


How to disable DRL (Daytime Running Lights) - TucsonDrivers.com

tucsondrivers.com/viewtopic.php?t=1809
Oct 17, 2006 - I wonder why Hyundai didn't put it on the US models? ... I wish my Tucson had daytime running lights. ... The DRL module on the Tucson in Canada basically puts 12 volts on ... #8 Postby Hermine » Wed Jun 20, 2007 5:39 pm.

Daytime Running Lights (DRL) not working =( - Hyundai Forum ...

www.hyundaiforum.com > ... > Vehicle Line Up > Hyundai Accent
Apr 25, 2008 - Join Date: May 2007 ... Basically, I've noticed my DRL are no longer working. ... Does anyone know what does the DRL module looks like and where I could find it? ... 04 Daytime running lights, CaptAthlon, Hyundai Elantra, 9 ...

Nov 24, 2015 | 2007 Hyundai Tucson Limited

1 Answer

Where is the DRL relay located?


There is no DRL relay , has a lamp control module .
The daytime running lamps (DRL) activate under the following conditions:
?€¢
The ignition switch is in the RUN position.


?€¢
The ambient light sensor indicates daylight.


?€¢
The vehicle is not in the PARK position.

When the above conditions are met, the lamp control module (LCM) supplies battery positive voltage (B+) to the low beam headlamps through CKT 589 (GRY), the DRL resistor, and CKT 12 (TAN). The DRL resistor reduces the voltage supplied by the LCM. The low beam headlamps light at a reduced intensity. The DRL disable if the vehicle is placed in the PARK position. When the ambient light sensor indicates darkness, the low beam headlamps automatically switch from a reduced intensity to a regular intensity.
Lamp Control Module (LCM)
In the center of the IP, below the center heater outlets

Nov 17, 2015 | 1998 Oldsmobile 88

2 Answers

Daytime running lights not working


Assuming this is an LX, check 7.5A fuses 9 and 5 in the driver's underdash fuse/relay box. Fuse 9 applies power to the DRL indicator light in the gauge assembly which connects to the DRL control unit. Fuse 5 supplies power to the DRL control unit when the ignition is on. Also check 100A fuse 41 in the underhood fuse/relay box which supplies power to the headlight relays. Setting the headlight switch to HEAD causes the headlight relays to close and apply power through 20A fuses 45 and 43 in the underhood fuse/relay box to the low beams. Low beam power also passes through the DRL diode to close the high beam cut relay and prevent high beam use during DRL operation.

Sep 23, 2012 | 2002 Honda Accord

2 Answers

Where is the Daytime driving Lamp relay located


follow the wires to the drl relay. It must be inline from the regular light switch to the headlamps. I have a 1990 Cadillac Deville that has an aftermarket module that controls the daytime running lamps, and it is mounted on the driver's side wheel well.

Some relays are found in the fuse box under the hood.

If your daytime running lamps burnt out, take it to an electrical shop and ask them to check it out.

If you buy an aftermarket daytime running lamp kit, they can install it for you.

But, I agree, you should check for voltage and function at the relay for the daytime running lamps on your Astro.

But, if all else fails, the electrical shop should be able to diagnose and repair this problem.

Jul 21, 2010 | 1999 Chevrolet Astro

1 Answer

Location of the daytime running light module


1991 Mustang not equipped with DRL.

Sep 26, 2009 | 1991 Ford Mustang

Not finding what you are looking for?
1990 Mazda 626 Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...