Question about 2004 Hyundai Santa Fe

Open Question

Clicking noise on rear wheel

While driving with my windows open and as drive next to park cars, I hear a clicking noise as if there was a nail on my tire or as if a spring is broken. What can this be?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 117 Answers

SOURCE: rear wheel/brake noise

first check condition of discs and pads if all is good drive and pull up handbrake slowly to see if its the handbrake shoes making the noise if still a problem will most probably be rear wheel bearings

Posted on Jul 01, 2008

Ad
yotaguy
  • 232 Answers

SOURCE: 97 Cougar XR7 V6 shaking in steering wheel and body.

Have you a had a 4 wheel alignment done?If all four wheels aren't set to a comman center line it cause it to shake,a warped brake rotor could cause this also.

Posted on Apr 14, 2009

VWdan
  • 114 Answers

SOURCE: broken wheel stud

1. get new studs and nuts
2.remove wheel
3. remove caliper at bracket to spindle connection(2 18mm bolts?)you may need to remove caliper from bracket,but not always nessacery. Or remove drum,then to #5
4.remove rotor,will need a hammer, tap inbetween studs dont wreck good studs and see if new studs can be installed without removing parking brake shoes. If there is no clearance to get new stud in you will need to remove shoes.
5.Pound out old studs place new stud in hole use a washer on outside then put a nut on and tighten to install stud, A air gun or some type of impact tool will be very helpful. Check to see that stud has enough threds to pull stud all the way thru ,add more washers if nessecary dont let the nut run out of threds it will **** to get back off and wreck new stud.
6. if you dont have air gun or feel comfertable removing brakes bring it to a reputable garage, shouldnt cost more than $70+ parts to get all new studs put in on one wheel.

Posted on May 17, 2009

  • 22 Answers

SOURCE: accelerated clicking/knocking noise when i start driving

sounds like your CV joints are worn out. If the clicking noise gets worse when turning then its a definite possibility. Also check the CV joint boots for splits as this can quickly wear them out. The dust mixes with the grease to form a grinding paste.

Posted on Jun 10, 2009

iambanshee74
  • 3489 Answers

SOURCE: Car won't crank + radio does come on+ clicking noise

it sounds like the starter has failed. it needs to be tested by a trusted technician near you.

Posted on Nov 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2000 ford expedition 4x4 the front right side makes a clicking noise while driving. Any ideas


Clicking Noise From Left Front Tire Area - F150online Forums

www.f150online.com/.../47713-clicking-noise-left-front-tire-area.html
Aug 11, 2001 - I have a clicking type noise comming from the left front tire. It does not ... I can really hear it when I'm driving beside a sound wall or the side of a building. ... the sound. (Yeah right!) ... Almost forgot: 1999 Ford F150 XLT Supercab 5.4 4X4. ... My 2000 4X4 had a ting ting noise coming from the left front wheel. Intermitent Grinding Noise on 2004 F150 4x4 - Page 5
Jan 15, 2010
Popping noise in front end.
Oct 26, 2009
Clicking noise at low speeds.
Aug 7, 2009
Annoying clicking sound in rear of truck?!?!
Jun 8, 2009
More results from www.f150online.com

Jan 05, 2016 | Ford Cars & Trucks

2 Answers

Why do I hear grinding noises while driving?


Hit in the rear axle may have damaged bearings or brake parts. Jack up the side you hear noise from, put on stand, then have helper rotate wheel while you look underneath and listen to see where noise is coming from. Use length of old fuel or heater hose, one end in ear, to locate exactly where noise comes from.

May 27, 2015 | 1996 Jeep Cherokee Country

1 Answer

I have a 2005 hyundai elantra. Today i began to hear a ticking noise when driving. It sounds like its coming from tires. I just had it inspected and had left bearing replaced. The clicking happens whi


It could be something simple....but have the hub and bearings checked.....does the steering wheel vibrate when you drive? If so defiantly have those checked.....Sometimes it could be a nail in tire or a stone(that is the simple part)

Jul 16, 2014 | 2005 Hyundai Elantra

2 Answers

Clicking noise


take a visual look under the car if anything loose. Any lights coming on? ARE left and right signals ok- sometime they make clicking noise.

Nov 05, 2013 | 2006 Jeep Grand Cherokee

2 Answers

A womp womp womp noise in the rear, tires are good, brakes look good, wheels are not warped, just had them balanced?


Go to a place that has a good smooth parking lot and a wooden private fence. Open all your windows and drive the car slowly as close as possible along the fence in order to pin point where the sound is coming from. The sound will echo back from the fence and will make it easier to pin point the area where the womp womp sound is coming from. Next thing you can do is lift the car up and place it on four jack stands in case you have a front wheel drive. If you have a front wheel drive and your car is on four jack stands, place you gear in nuetral and spin each rear tire separately to see which one is making the noise. Keep in mind that it might be a wheel bearing or if it a rear wheel drive and on four jack stands have someone drive it slowly while you listen for the noise. Some rear wheel drive differentials can make this noise if it is low on differial oil. Be very careful that the jack stands are on solid and making good contact with the car frame and flat on the pavement. Don't place yourself where the car can fall and hit you or run in to you. Good luck.

Dec 03, 2012 | 2002 Porsche Boxster

1 Answer

When I am driving I hear a clicking noise. It sounds like it is coming from the rear of the vehicle


Hello, it wigit with his/here finger nail stripping the rubber of you tires in the back of you vehicle.
Is it a timely click that is unformed sound. Does the clicking intervals get louder with the speed increasing? It sound like a rear wheel bearing that out of grease. If it start squalling really loud. You will need to a new wheel bearing install. Don't let go to far it can out the wheel bearing and cause the particular wheel to come off. GB...stewbsion

Aug 26, 2011 | 2005 Jeep Grand Cherokee

2 Answers

We have a clicking noise every time we drive the car it sounds like there is a nail stuck in the tyres but we have changed all the tyres . the faster you go the louder the clicking goes it is very anoying


I suggest you find a large parking lot devoid of cars (at night, for example) and drive clockwise, then counter clockwise at moderate speed to see if there is any change in the volume of the click.
You may have a pitted front wheel bearing; when it isn't serious yet, it will produce the click. As it deepens or enlarges, it will become increasingly audible and when bad enough, it will be felt in the steering wheel too. Driving it in both directions can reveal on which side the bearing is failing. If you hear a change, even minor, I would have it inspected by a pro.

Sep 05, 2010 | 2004 Ford Focus

1 Answer

Its a clicking noise when i get to my 2 gear


There are a number of things it can be. Full wheel hubcaps can click or get rocks in them. Stones in the tires or a nail. An out of round brake rotor (does the car vibrate when braking?). The rear emergency brakes are not self cleaning and build up debris.

If you have someone to gently rev the engine while in PARK, to about the speed of 20mph, you can hear if it is an engine noise. Or if you can coast at 20 to 30 mph with the engine in NEUTRAL, you can tell if it is a rolling noise or something in the powertrain. Have the window down to get maximum effect.

You have several things to check now. Let us know what you find.

Aug 16, 2009 | 1997 Mercury Grand Marquis

1 Answer

Clicking noise in left rear wheel when driving down the street in my 2003 Cavalier. About in sync with wheel RPM's.


most likely a rock or possibly from a drive way or road construction jammed in tire tread could be a nail or screw, no your tire will most likely not loose pressure quickly due to new compounds used in new tires

Jun 24, 2009 | 1998 Chevrolet Cavalier

1 Answer

1998 GMC 4x4 Suburban - Clicking noise when excellerating


shot in the dark here did you check drive shaft to see if there might be some debris of some kind wrapped around it

Sep 05, 2008 | 2002 GMC Sierra C/K1500

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...