Question about 2004 Nissan Quest

1 Answer

How to tighten belt on 2004 nissan quest

How to tighten alternater belt on 2004 nissan quest

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Best to remove the front passenger side wheel. Then snap out the clips that are holding the plastic cover towards the front. Now it will expose the belt area. Loosen the locking nut of the tensioner(idler) pulley located to the right of the Crankshaft Pulley. Crankshaft pulley is the one that handles both belts (alternator and the power sterring pump). Right to that next to it, upwards is the idler pulley. You will find the alternator pulley to the right of that further up. Open the hood of the van and locate the adjusting nut behind the alternator on the idler pulley from top and loosen that as well. Once both these are loosened, belt will loosen and will be easy to remove. Now replace it with the new belt the same way it was wrapped. Go over the crankshaft pulley; under the A/C compressor pulley; over the alternator pulley; under the idler pulley. tighten the adjusting nut from the top through the hood until the play on the belt (when pressed in) is less than 1 inch. Now lock the tensioner pulley by tightening the locking nut. Start and run the car for 15 mins to see if everything is ok.

Posted on Jan 22, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When do I change the timing belt of a 2004 nissan quest


Nissan recommends replacement of the timing belt and water pump at 84 months or 105K miles whichever comes first. ALWAYS replace the water pump at the same time as the timing belt or you will be out the same amount of labor in 2-3 months when the pump goes bad after the timing belt replacement.

Dec 03, 2013 | 1993 Nissan Quest

1 Answer

Nissan quest 2007 whining noise in hood


Your right its probably your serpintine belt. It is a cheap repair to have a mechanic tighten belts or replace if nessasary. Better that then be stranded. Its could also possibly be your power steering pump if your low on fluid. But that you should have noticed earlier each time you turned a corner.

Apr 14, 2012 | 2007 Nissan Quest 3.5 Minivan

2 Answers

My 2004 Nissan quest and starts but when I'm


your timeing is out might need new timeing belt

Mar 24, 2012 | 2004 Nissan Quest

1 Answer

Tighten alternater belt


Loosen the altenater and use a prying bar to tighten the belt by pushing the altnater so as to tighten the belt. while holding altenater in place tighten bolts back tight. Belt should be tight when finished.

Feb 25, 2011 | 1994 Nissan Altima

1 Answer

Belt pulley is rattling


Which pulley? May want to check the idler pulley locking nut and loosen it and tighten again and see if it is still wobbly. If it is, you may have to replace the pulley.

Jul 06, 2010 | 2004 Nissan Quest

2 Answers

2004 quest driver side wiper is not working


you might have worn splines on the shaft of where the wiper arm attaches. You can try to tighten this bolt alittle tighter. just make sure they are in the rest position (normal position) and wipers off. if that bolt is tight , then it could be some worn out link bars that attach to both wiper arms from underneath. I hope this helps.

Feb 22, 2009 | 2004 Nissan Quest

2 Answers

Programming nissan Quest Remote control


I have a used Nissan Quest 1999 that Remote Control does not work . How can I program it?

Jun 29, 2008 | 2004 Nissan Quest

Not finding what you are looking for?
2004 Nissan Quest Logo

763 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...