Question about 1989 Peugeot 405
Peugeot 405 gtx td dashboard diagram what does the lefthand dial indicate?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
carb? mono point injection or multi point injection.check for a thin rubber air hose that runs to ign module is it intact or sucking in air caused by being perished also the thin pipe running to the air intake cold /hot ,flap control .if carb then it has a adjusting screw ,and mono point but multipoint is different.91 model also uses a distributor which could be advanced a slightly ,check the same sort of air pipe to the gearbox as iam sure this year has a pipe to operate the gearchange.any of these pipes sucking air can cause your problem
Posted on Nov 20, 2008
Search 'books' for Peugeot 405 (you will find the Haynes Manual). Make sure you choose the right one for your Year & type (Petrol/Diesel) = the wiring diagrams are in the back. Cost is about £20.
You can also borrow the Manual from your local Library for free ..
Posted on Feb 10, 2009
On paper the procedure for this does indeed involve removing the entire dashboard and it really is a nightmare of a job to do. Having worked on this model before I can however give you this tip.
On the 405 the heater matrix can be disconnected from the engine side as it is connected to the coolant system at the bulkhead. If you then take out the glovebox assembly on the passenger side you will find enough room to work the matrix out towards you.
The only problem is that it is very slightly obstructed by the dash itself when you go to slide it out. If you want to avoid a day and a half of labour all you have to do is take a slight nick - no more than one inch out of the dash which is way down by the passengers feet and really not something you are going to notice a great deal.
The whole heater matrix will then slide out. The matrix can be changed by this method in around an hour. For the sake of an inch of plastic which you are really not going to notice this is the method I would advise.
The alternative is complete removal of the dash assembly for which you will need a service manual and at least a day and a half of your time not to mention the potential problems that occur from removing a dash - upsetting electrics - heater controls etc ........
Hope you find this useful. Please remember to rate my answer. Many Thanks.
Posted on Jul 17, 2009
Tips for a great answer:
Apr 29, 2016 | Peugeot Cars & Trucks
Nov 30, 2012 | 1991 Peugeot 405
May 21, 2010 | 1991 Peugeot 405
Feb 25, 2010 | 1991 Peugeot 405
Feb 18, 2010 | 1991 Peugeot 405
Jan 24, 2010 | 1991 Peugeot 405
Dec 16, 2008 | 1991 Peugeot 405
Nov 11, 2008 | 1990 Peugeot 405
294 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: