Question about 1999 Jeep Grand Cherokee

1 Answer

1999 JGC driver door won't lock or unlock with fob, and there's no power to the drivers door whatsoever (windows, locks, etc.); the security system won't arm, and the vehicle won't start without starting fluid. When it starts it idles at 2500-3000 rpm. Push the gas petal and it loses rpm and dies out. I've replaced fuel pump (twice), upper O2 Sensor, TPS, and catalytic converter. It woud start before I took it to the Chrysler dealer who had me replaced the fuel pump (again). Then they said I need to install another (OEM) pump. I don't believe that's the problem. A friend told me it could be the PassLock System shutting down the fuel system. Please help!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 249 Answers

I have had that same problem in the shop a few years ago and there were broken wires going from the body to the door inside the rubber boot.. Check there first.

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Security system is locked on my 2006 pontiac montana,now how do I fix it.


Try locking and unlocking the drivers door with the key. You may have to do that more than once.

Apr 16, 2017 | Pontiac Cars & Trucks

1 Answer

I tried to program a new fob for a 1999 Altima. And nothing worked





1.   Close and lock all doors with the driver’s side power lock/unlock switch.

2.   Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.

3.   Insert key into the ignition cylinder and turn to the ACC position.

4.   Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.

5.   If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).

6.   Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.




Make sure you have the right fob for your car.

Nov 15, 2016 | 1999 Nissan Altima

1 Answer

Range rover p38 problems


I have the same problem sometimes
1 Check the condition of your battery, if old, it will not give full power required to communicate with the security system.
2 If you don't have the EKA of your RR, try this next time you get caught, put key in the drivers door look, press unlock button on key fob and at the same time turn to unlock, if all locks unlock then the engine should not be immobilized - Good luck

Jul 13, 2014 | 1996 Land Rover Range Rover

1 Answer

Door lock nissan murano


check the interior light switch is working on all the doors. these control the security system.

Jan 23, 2018 | Cars & Trucks

2 Answers

2003 Monte Carlo SS, FOBS won't unlock doors (new batterries), use key and open the door with the door open FOB will lock and unlock the door, shut the door and the FOB won't lock the doors. After...


If the passkey is messed up, there will be a light on the dash that says security, or have a picture of a car with a lock thru it. If there is no light when the key is turned forward, then its NOT a passkey problem.



tayjoejoe_35.jpgtayjoejoe_36.jpg

Aug 17, 2011 | 2003 Chevrolet Monte Carlo

1 Answer

Replaced batery in key fob and now there is no connection between fob and security system...I can lock and unlock doors with the key and I can start car ...fob doesn't work; does not lock or unlock...


reprogram the remote transmitter. first leave driver door open all other doors closed,key removed from the ignition switch. insert key into the ignition switch,then remove it.press lock and unlock on the vechicle door lock control switch at 1 second intervals 5 times. close and repoen drivers door.press lock and unlock on the vechicle lock control switch at 1 second intervals 5 times. insert key into ignition switch. switch ignition on and off twice to program a remote transmitter code whilst erasing the original codes or three timre to check how many remote transmitters are currently registered.remove key from the ignition switch.system should now lock and unlock.twice to indicate programming mode or one to four times,slowly to indicate number of remote transmitters registered.for the solara press and hold lock and unlock remote buttons together, press lock remote button for a second period of 1 second. system should now lock and unlock vechicle.once to confirm, twice to indicate registration has failed.if required repeat button procedure to program remaining remote transmitters.note to exit programming mode close drivers door or insert ignition key.maximum of 4 remote transmitters can be programmed.if akk failed let dealership reprogram remote transmitters.

May 18, 2011 | 1999 Toyota Camry Solara

1 Answer

2000 BMW 323I WONT UNLOCK WITH THE KEY OR KEY FOB, ANY IDEAS?


I had same problem. Driver door would lock/unlock with key in keyhole in door, but not with fob, and other doors would not lock/unlock. Even once inside none of the doors would lock/unlock with lock switch, or even by pulling handles. Mechanic (very trustworthy) explained I needed a new control module (cost me $600). Good Luck. $600 is better than having to roll down the windows so Grandma can Luke Duke it outta the car.

Feb 19, 2010 | 1999 BMW 323 Series

1 Answer

'98 Saturn SL1 won't start. Alarm system behaving strangely. Have power, turn key-nothing. Then it will start for no reason. Drove it home (20 miles), shut it off and it won't start again. Changed battery...


I had this same exact problem in a family member's Saturn. If you are opening the door with the key and not using the key FOB to unlock the doors, then the security system will not allow you to start the car. You will notice when this happens that the dome light will blink and you'll hear the relay in the BCM clicking.

In order to stop the security system from doing this: Make sure the car is locked with the key fob by hitting the lock button. Then hit the unlock button on the key fob once and then once again (I do it out of habit). Then open the driver side door, put the key in and it should start no problem.

Dec 31, 2009 | 1998 Saturn SL

1 Answer

Boot does not lock and drivers window does not go up to the seal


Possible reflash to the corresponding computers or the network that they communicate on. moz-screenshot-3.jpgVery complicated systems. I have fixed many problems via this repair. The boot problem may be related to a faulty latch assembly and this will not allow the security system to operate correctly.

Mar 31, 2009 | 1999 BMW 318 ti

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...