Question about 1998 Ford Explorer

1 Answer

Poor Output from my AC

I have a 1998 Ford Explorer (4 door, V-6). My AC feels cold but not much is coming out. Do I need to clean a filter? I sprayed the front of my grill with a hose, as instructed by a mechanic, and it didn't help. I took my truck in, and was told that there is enough free-on.

What should I do?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 249 Answers

They do not have a cabin air filter , does it blow better on heat ? or is it the same ?

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1999 olds aurora an when ac is on it only blows hot air the refrigerant is full an ac clutch comes on


If you say clutch comes on, did you try feeling the suction pipes. If its not cold enough, you may have a poor ac compression. If its cold indeed, then the cold air may have been diverted elsewhere and this is caused by faulty hvac door actuators or faulty air mix controller. ?

Jul 10, 2018 | AC Cars & Trucks

1 Answer

Hot to cold door wont move for ac


In most case this is caused by a defective air temperature control blend door actuator motor and blend door being stuck due to heat warping from the heater core. The parts are located inside the dash and the dash must be removed to service them. My suggestion is have a well trusted shop that knows AC systems problems on Ford check it first before you pay the $1000.00 for the repair of the above parts.

Jun 06, 2012 | 1998 Ford Explorer

2 Answers

Ac is blowing out of defrosterandnot panels in the dash. Air is cool cold air will blow out of rear seat panel/vent 1998 ford explored


The most common cause is a bad blend door actuator which controls air flow throughout the cabin. When air flow only flows from 1 section (either floor, vent, or defrost) it's an indication that the blend door actuator is either stuck or broken.

Jun 02, 2011 | 1998 Ford Explorer

2 Answers

Heater hot/cold control knob doesn't work need to have the hot air.


Check the motor on the top of the heater plenum. It turns a shaft to shift the blender door which controls the input to this plenum either the heater core or the evaporator core (ac). You may find the motor is OK but the shaft (plastic) has broken and the blender door has to be replaced. This is a costly job that involves removing this plenum after removing the dash. A shortcut I found online was to cut a hole under the blender door and replace it through this opening. After replacing you can seal up the hole with epoxy. I cut three sides of a square hole leaving the back uncut. Pull down and the blender door can be removed. My problem was on a 1997 Explorer. _6.gif

Nov 22, 2010 | 1998 Ford Explorer

1 Answer

1991 Explorer: need to know 1991 ford explorer firing order...


For the 1991 Ford Explorer 4.0L SOHC V6:

Firing Order:
1-4-2-5-3-6

Cylinders:
...(back)
3...........6
2...........5
1...........4
...(front)

Coil Connections:
...(back)
1....2....3
5....6....4
..(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

May 18, 2010 | 1991 Ford Explorer

1 Answer

AC only works on max, but blows hot air in all other settings


your problem is in the blower motor speed controller and it is near blower motor

Aug 02, 2009 | 1998 Ford Explorer

1 Answer

Back door will not lock or unlock when using key remote only front passenger side and back drivers side opens with remote


needs door lock actuators... and all the door latches need cleaned and lubed... spray brake cleaner on latch let dry then spray some wd-40 or equialant on latch... it may need latches too but usually cleaning them will fix them

Jul 14, 2009 | 1998 Ford Explorer

1 Answer

98 ford explorer AC isn't blowing out of the front vents


can't help you w/ fuse panel diagram-- but it may be your front blower motor door. sometimes they stick in the closed position. good luck!!

Jul 07, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
1998 Ford Explorer Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...