Question about 1996 Mercury Grand Marquis
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Haynes lists the entire procedure for setting the position of the cams etc. Positioning of these is critical...If off by even a slight amount the valves WILL strike the pistons and destroy the engine. DO NOT use any parts made by SA Gear...They have no quality control and will deny any claim made against them. Make sure that the chain guides are in good condition and that the chain tensioner is operating properly.
Posted on Apr 15, 2009
SOURCE: mercury grand marquis
it is on the fender near the battery and is also referred to as the starter solenoid (if you follow the large wire from the positive terminal of the battery at the other end will be your relay/solenoid)
hope this helps!
Posted on Feb 28, 2009
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
Posted on Mar 30, 2009
I'm not sure if yours is identical to mine since yours is second gen and mine is third gen, but with mine (1998 MGM), the heat was stuck on all the time. Full heat would practically cook your feet and you couldn't shut it off.
It was a servo/servo arm that controls the hot/cold mix door. The part was $15. The labor was $700. They had to take the entire dash out of the car to get at the part. Required two more visits due to a missed electrical connection to a daylight sensor and a vacuum issue that made the car stall when put into reverse.
My car had 150K on it at the time. Has 165K on it now. Still runs great and looks great. It's now my wife's auto and I drive a 2006 MGM.
Posted on May 13, 2009
Tips for a great answer:
Apr 28, 2011 | 2000 Mercury Grand Marquis
Mar 12, 2011 | Mercury Grand Marquis Cars & Trucks
Dec 15, 2010 | 1999 Mercury Grand Marquis
Aug 29, 2010 | 1993 Mercury Grand Marquis
Aug 28, 2010 | 1995 Mercury Grand Marquis
Feb 19, 2010 | 2000 Mercury Grand Marquis
Nov 26, 2009 | 1987 Mercury Grand Marquis
Oct 18, 2009 | 1988 Mercury Grand Marquis
Aug 09, 2009 | 1978 Mercury Grand Marquis
403 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: