Question about 1989 Peugeot 405

1 Answer

Spark plugs coverd in oil cat glowin red hot on a peugeot 406

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Peugeot Master
  • 22,156 Answers

Time for a engine rebuild ,its rings have gone

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 sunfire 2.4 exhaust glowin red 5 mins after crank,coil packs,cover,plugs,tps,all replaced..time cat to come off


I would suspect the ignition timing is too far retarded or the wrong fuel octane.

Jul 24, 2017 | Cars & Trucks

2 Answers

My 406 1.8liter engine has a tendency to shot down when in idle and cold. after 5 miles it runs fine.


Sounds as though it may be the Throttle Position Sensor. TPS. It is on e the throttle body and sets the idle of the engine.

Nov 22, 2013 | 1999 Peugeot 406

1 Answer

My 406 peugeot shows oil pressure insufficient on display, what is the cause


My 406 peugeot always go off after on my A/C it we show me oil pressure insufficient! Please what can I do?

Mar 09, 2012 | 1999 Peugeot 406

3 Answers

What the normal operating tempature of peugeot 406


as with all cars it depends on the thermostat that has been installed but should be about 180 to 200 degrees F. this is pretty much standard in all autos due to the boiling point of water and the need to prevent too much pressure from building up in the system which could damage gaskets ans seals etc. check the specification section in your glovebox manual as it may have the answer for you as well. be careful not to open up the system if its hot to prevent burns.

May 31, 2010 | 2005 Peugeot 405

2 Answers

Are there catalytic converters fitted on 406 2.0l


Its a dpf not a cat.Easy way to clean out[regenerate]First bring the engine to normal temp bring up the rpm to 4000 for 2 mins,then allow to idle for 30 seconds then bring the rpm up to 3000 rpm for 3 mins and yourfilter will have regenerated [fancy word for clean itself out. DPF = diesel particulate filter.Its important to use good quality low ash oil for your oil changes.

Mar 03, 2010 | 2005 Peugeot 405

1 Answer

I'm trying to figure out where the heck is the oil filter and spark plugs for a Peugeot 406 Year 2004. Any help mostly appreciated!! J.F.


the spark plugs are located between the cams you will need to remove the cover from the middle of the head by turning the 6 screws 90 degrees them unbolt the coil pack, unplug in then remove it to get to the plugs
as for the oil filter it is located on the front of the engine in the middle just above the sump (if it is a metal canister type) or to the left of the head at the front (usually under a black plastic cap with a big nut on it) if it is a paper type
hope this info helps you out mate

Aug 23, 2009 | 2006 Peugeot 604

4 Answers

Peugeot 406 loses power -1991 PEUGEOT 406 executive; 1997cc


Yes i think that i can help you.Please just send me yuor car chassis number and mor details about the symptom

Mar 18, 2009 | 1991 Peugeot 405

2 Answers

Transmission fluid in pegueot 406


How do i top up my auto gearbox oil on a peugeot 406

Jul 20, 2008 | 1989 Peugeot 405

2 Answers

Injectors


Injectors from the same ccm engine are most probably sounds same but to be on the safe side check not only the shape but code on the top of injector too. Because they are piezo effect injectors and set by the manufacture for a specific pressure for specific engine codes.

May 22, 2008 | 1990 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

mike hayward

Level 2 Expert

279 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...