Question about 2000 Dodge Durango

Open Question

Dtc code po734 and p1728 on a 2000 dodge durango what are they and what can i do

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: my 2000 dodge durango turn signal lights stop working.

Had the same problem,its the hazard light relay,it's located under drivers side under dash, it has a relay that is maybe an inch in size (square). its alitle tuff to get to. hope this is helpful...

Posted on Apr 03, 2009

Ad
  • 1 Answer

SOURCE: transmission code PO753, how to repair?

PO753 code on a Durango can also be caused by a bad transmision relay in the relay -fuse block behind the battery in the engine compartment. (relay # 31 on 1999 Durango) Before you attempt to replace the 3-4 solenoid, or take to a transmission shop, try changing the relay out with another known good relay, reset the code and try it. I learned this today from an honest transmission shop. Shifts normally again, check engine light is out, and the shop did not charge me a dime. Kudos to Trans Medic in Gresham OR.

Posted on Apr 23, 2009

  • 1 Answer

SOURCE: I have a 2000 dodge durango, I have a code P0320.

I put in a new crank positioning sensor and it fixed my problem. 42.00 dollars from NAPA. took about 2 hours to change it.

Posted on May 02, 2009

  • 66 Answers

SOURCE: replace thermostat in 2000 durango

If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you will probably need to do this from under the car.
Perfect time to flush/fill all coolant. Check and replace any needed hoses/clamps.

Posted on May 05, 2009

  • 323 Answers

SOURCE: Dodge Durango DTC code p0404:EGR flow,CKT

Replace the EGR valve to correct this problem.

Posted on May 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1391 dtc on a 1998 dodge durango 4.7 with a no start condition


Repair your vehicle right away. Just click on the link I attached
1998 dodge durango

Oct 14, 2017 | 1998 Dodge Durango

2 Answers

What is code 700 on dodge durango


here you go E A T X controler dtc present "specific fault must be aquired from the EATX via CCD or from aisin via ISO 9141 ,i'm not sure i know what it is ,but this is the best i could do ,good luck hope it helped.

Oct 01, 2012 | 2005 Dodge Durango

1 Answer

Transmision codes p0700 and p2706 dodge durango 04


Both codes (obviously) point to transmission related problems.

DTC P0700 - Transaxle Control System Fault Conditions
The P0700 code is for information only and the next step is to check for transaxle codes in the Transaxle Control Module (TCM). So you'll have to have the dealer or another qualified shop/technician pull the transaxle codes from the TCM and go from there.

DTC P2706 - Shift Solenoid "F"
First check your wiring before you get inside and open the ****** up. Could be loose wiring, if not do the operation and make sure you do a heat test with the solenoid before you replace it.

Hope this helps and just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa.

Nov 01, 2011 | 2004 Dodge Durango

1 Answer

I have a 2000 dodge durango with a trouble code p1740 what does it mean


SYMPTOM
P1740-TCC O/D SOL PERFORMANCE

WHEN MONITORED
The Torque Convertor Clutch (TCC) and Overdrive Clutch (O/D) will be tested each time the PCM requests TCC engagement in 3rd gear and O/D.

SET CONDITION
The code will set if the expected RPM drop is not achieved while attempting to engage TCC or O/D. This indicates a malfunctioning torque convertor or overdrive clutch.

POSSIBLE CAUSES


Camshaft DTC Present
Engine RPM DTC present
Fuel level low
Misfire DTC present
Output speed DTC present
P1765 DTC present
Park/neutral DTC present
PTO engaged (if equipped)
Torque converter clutch DTC present
TPS DTC present
Transfer case in low range (if equipped)
Transmission relay DTC present
Transmission temperature too cold
Intermittent
Check transmission fluid-debris
Check transmission fluid-stall
3-4 shift solenoid
Oil pan contains excessive debris
Shaft or seal damage
TCC solenoid
Torque converter

Aug 15, 2010 | Dodge Durango Cars & Trucks

1 Answer

I have a transmission code PO732, PO734, and PO733 on my 2002 Dodge Durango. What do these codes mean?


Those three codes point to shift solenoid and/or clutch problems according to the Dodge Service Manual

Find someone with a Chrysler scanner and monitor the trans speed sensors, preferably the input one, make sure there is a rpm readings on both when you drive the vehicle, if ok, do a 2nd gear clutch test, if failed, internal clutch failure, if ok, replace the trans solenoid pack, it has an internal failure

Apr 12, 2010 | 2002 Dodge Durango

1 Answer

O4 DODGE DURANGO.. CODE PULLS UP MANUFACTURE SPECIFIC DTC ... WHAT IS THIS??


it means you reader does not decode the codes for you! you must look it up on the internet or ask the dealer! good luck!

Sep 08, 2009 | 2004 Dodge Durango

1 Answer

2004 dodge durango air bag light is on code B1BA6 and B223D


B223D OCM DTC PRESENT" ocm stand for occupant classification module, Both of these codes go together and show that the passenger seat sensor for the airbag needs to be recallibrated. This needs to be done by a dealership as they have the special set of calibrated weights and can run the tests to be sure it is done correctly. Call dealership to solve this problem.

Aug 26, 2009 | 1999 Dodge Durango

1 Answer

Need to know where is Low Output SPEED Sens RPM, Above 15 MPH located in 1998 dodge durango 5.9cc 4x4. dtc code p0720


as far as i know there is only one speed sensor and it is located on top of the rear differential should have one bolt holding it in. i believe that code says the speed sensor has a low output.

Aug 26, 2009 | 1998 Dodge Durango

1 Answer

Check engine light and no accelaration


all the codes starting p1 are manufacture specific codes you need to take it to a dealer. the p0734 relates to a transmission problem the person who serviced your vehicle only cleared the fault codes the prob is still there

Nov 16, 2017 | Dodge Durango Cars & Trucks

2 Answers

Diagnostic codes


p0068 is Throttle Position sensor inconsistent with Mass Air Flow sensor.

couldn't find the other 2.

Jul 19, 2008 | 2003 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

365 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...