Question about 2001 Pontiac Aztek

1 Answer

How often should the brake fluid in my Aztec be

How often should the brake fluid and power steeling fluid in my Aztec be flushed? I just made the 100000 mark.

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 415 Answers

Well once a year should be ok

Posted on Jul 28, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Dodge Caravan sport brakes won't release in the front

Check the cap to see if rubber seal is swollen if so some one has put other fluids in other than dot3 brake fluid,thus causing all rubber parts in the system to swell causing brakes to not release this is the most likely cause.Repair is to replace all related rubber brake parts,hoses,calipers,master,wheel cyl etc etc flush the steel lines also.

Mar 17, 2015 | Dodge Cars & Trucks


Flush Brake Fluids and Power Steering Fluids Economically

Many vehicle maintenance schedules require flushing of BRAKE FLUIDS, as well as HYDRAULIC POWER STEERING FLUIDS. An inexpensive way to do this yourself is to go out, and buy 2 TURKEY BASTERS. Mark each separately, one P/S and one Brake Fluid. DO NOT INTERCHANGE. As per maintenance schedule, siphon brake fluids from MASTER CYLINDER, ( recycle properly ) and replenish with fresh , clean fluids, Do the same with the power steering fluid in the pump. Of course you won't be removing all of the fluids, but a sufficient amount will be replaced. You can do it 2x after running if so inclined.

on May 08, 2009 | 1993 Cadillac DeVille

1 Answer

Ringing brake alarm wont shout of pontiac aztec

look for ABS trouble code and if you have enough brake fluid level.
hope it helps

Mar 14, 2014 | 2001 Pontiac Aztek

1 Answer

Bleeding brakes on my 2001 montero sport mitsubishi

I have very bad news brake system + atf = complete brake system replacement. the rubber o-rings and seals that are used in brake systems that are compatible with brake fluid are absolutely not compatible with any other fluid in a vehicle. if you haven\'t used your brakes at all since the atf was put in then suck it out remove and clean brake master reservoir. but if you\'ve driven it and used the brakes it\'s all got to go except the steel brake lines which can be flushed out once you remove the rest of components. and I mean all of them calipers, hoses, master cylinder, abs hydraulic unit it\'s all junk now.

Dec 31, 2012 | Cars & Trucks

2 Answers

Should I have brake fluid flushed in my 2007 tiburon

not really needed unless you have had a major failure with either system...its a gimick alot of shops use to make quick money with uneeded repairs

Btw, I’m available to help over the phone in case u need at

Dec 03, 2012 | Hyundai Tiburon Cars & Trucks

1 Answer

I accidentally put brake fluid in the power steering pump of my 96 Dodge Ram

Do not start it brake fluid in the power steering. Will destroy the seal in the whole unit if you have started it you will need to take the return line off at the pump and flush it asap you can use trans fluid it has cleaner in it

Nov 03, 2012 | 1996 Dodge Ram 1500 Club Cab

4 Answers

I put power sterring fluid in my brake master cylinder,what can happen?

It will cause the breaks to not work at all u would have to flush the hole break system out by usein break fluid an bleeding them out till nothing but break fluid comes out I hope this helps buddy

Apr 04, 2012 | 2003 Jeep Liberty

2 Answers

I recently took my 2006 toyota tacoma to the tacoma dealership where i regularly have my oil changed. They recomended to me that I get my power steering flushed, brake fluid flushed, recharge the K&N...

their job is to sell work.however its a good idea to have the brake fluid flushed and the fuel system cleaned.the power steering fluid you don`t have to have flushed,you can if you choose don`t have to have it done at a dealership and it will not void any warranty,if you have extended.

May 22, 2011 | 2006 Toyota Tacoma

1 Answer

My ex wife put power steering fluid in the brake master cylinder and drove the car across town..... what should i do

Immediately **** out the contents of the master cylinder, replace with fresh brake fluid, and flush the system.

Flushing can be done by doing a good old fashioned manual bleeding consisting of one person opening and closing the bleeder screws and one person working the brake pedal or many shops will have a brake flush machine that will make quick work of the job.

The P/S fluid in the brake system will cause the seal to bloat and eventually fail. We see several cars every year that this happens to. If its caught early a system flush will take care of it. If ignored everything gets replaced (master cylinder, brake hoses, calipers, and wheel cylinder). We have had a few over the years that where ignored for so long that the brakes eventually locked up.

I’m happy to assist further over the phone at

Sep 30, 2010 | 1991 Mercury Cougar

2 Answers

Fuel injector flush how hard is it to do it yourself? That and power steering and brake flsuh. 2005 Avalance V-8

depending on how bad the injectors are you can put some Lucas fuel treatment in your gas tank and it will clean them up for you. I use it every other fill up and have had no problems. My avalanche has 88,000 miles and I have never had injector problems. The power steering flush and brake flush you will need a vacuum pump.

Brakes: Locate the bleeder valve on each caliper and hook up your vacuum pump to it and pump it 4-5 times. Make sure your fluid reservoir is full. Put clean fluid in reservoir as needed. Repeat this again. ON bake brakes you will want to give it a few more pumps than the front because they are farther away from the master cylinder. You will need 2 of the small bottles of brake fluid or 1 large bottle. Sorry, I dont remember the oz. on each size.

Power steering: place a hose into the reservoir and pump all fluid out. Turn wheels all the way both ways and repeat twice. You will need several courts of power steering fluid.

Oct 27, 2009 | 2005 Chevrolet Avalanche

Not finding what you are looking for?
2001 Pontiac Aztek Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides