Question about 1986 Nissan King Cab

1 Answer

Navara king cab 1986 idle problems

Engine won't idle..runs rough

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Check on the timing.

Posted on Oct 20, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can make a Nissan z24 engine give bad noice and how can it fix


1986 Nissan 720 King Cab with 2.4 Naps Z engine (Carb ...

community.ratsun.net > Technical > Engine

Jul 1, 2009 - 14 posts - ‎5 authors
1986 Nissan 720 King Cab with 2.4 Naps Z engine (Carb based) ... Just yesterday it made a real weird loud panging noise (Kind of ... If you dont surface the head it will usually form better to the bad block deck giving you as much as another 100k !!!!!!!! before it ... Also the z24 HATES head gasket coating.

Idle problem? - Engine - Ratsun Forums - Ratsun.net

community.ratsun.net > Technical > Engine

Nov 17, 2009 - 14 posts - ‎6 authors
I am new to this forum along with Datsun/Nissan trucks. ... doing a lot of reading and trying to become more familiar with the Nissan 720 /z24 engine. ... also if the mixture is out of adjustment it can cause the same symtoms also.the ... Listen near the back of the carb and you should hear a light clicking sound.

nissan hardbody engine rattle - YouTube



Dec 03, 2015 | Nissan Cars & Trucks

1 Answer

Rough idle on 1986 honda civic 1.5 carb


CHECK FOR VACCUM LEAKS , BROKEN HOSES , OR DISCONNECTED HOSES ON THE MANIFOLD OR CARBURETTOR .EVEN A DIRTY CAB CAN CAUSE THIS SYMPTOM .

Jul 31, 2012 | 1986 Honda Civic

1 Answer

97 nissan king cab running poor rough idle it surges/stumbles about every 15 to 20 second


I would start with the IAC (Idle Air Control) valve. The IAC valve usually, USUALLY, trips the Check Engine Light, but, sometimes may not.

Aside from that, it could be other issues: spark plugs, ignition wires, distributor components/assembly, etc.

BTW, is the Check Engine Light on?

Nov 27, 2011 | 1997 Nissan Pickup

1 Answer

1986 Nissan King Cab pick up. Runs good when giving gas, but cuts off at an idol. Have replaced Altenator.


Based on the information provided, it sounds like a bad TPS (Throttle Position Sensor). The TPS controls your idling speed under all conditions. When a TPS goes bad, you will usually notice the vehicle will idle when the engine is cold but once warm or with the AC on, it will sputter or stall.

Jul 18, 2011 | 1986 Nissan King Cab

1 Answer

How to take out old front pads and replace with new ones...nissan navara 4x4 1986


remove two bolts holding disc caliper to strut assembly. remove discpads.use a g-clamp to push brake pistons back so that when you insert new pads the caliper will easily fit over disc.tighten bolts securely

Feb 27, 2010 | 1986 Nissan King Cab

1 Answer

1986 king cab


I've had similiar issues with a different vehicle. I had to purchase new plugs, rotor, and distributor/spark plug wires. I was running on three cylinders verses four. I did not notice until I was going up hills, where it required more power. If you have a tachometer, keep an eye on it. If it is running slower than it should that could be an indication that there is a problem with the wiring. (probably should be doing about 2500 rpm)

I had a Hyundai that did just the opposite. It would peg the tach to 3,000 rpm well before it was time to shift. Ended up being an ignition coil went bad, which takes the place of the distributer. I replaced the ignition coil and now the engine doesn't have to run as high.

Sep 28, 2008 | 1986 Nissan King Cab

Not finding what you are looking for?
Cars & Trucks Logo

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...