Question about 2003 Nissan 350Z

Open Question

Gas door won't release with button on my 2004 Nissan 350z -- any ideas? (Gradually seemed to be more "sticky" and would sometimes have to hit the button a couple of times before it would release, then one night last week -- no release!) Help!

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 6784 Answers

SOURCE: horsepower increase

Hi, you can upgrade to an K&N air filter and you can also add a chip that will electronically increase you HP threw tweaking the CPU. That should do it. Also, replacing the stock exhaust manifold with a aftermarket manifold will make this baby scream.

Please rate and god bless.

Posted on Mar 27, 2009

  • 232 Answers

SOURCE: Help with bulb wattage 2004 nissan 350z

The current draw is going to almost double,from 4.5 amps to 8.3,I wouldn't be so worried of the wiring ,it will handle the increase as I would of the your relays as this is where the increased draw is going to have the most affect.Generally all electrical componenets are designed to handle 33% over what they are rated at,they will work but this will shorten the lifespan of your relays by as much as 50%.

Posted on May 04, 2009

  • 1 Answer

SOURCE: convertible top sticks, will not fully open

The support bar right above your head has 2 elastic bands attached to it, one on the drivers side and one on the passenger side. After time they lose their elasticity and don't pull this bar (the one with the top attached to it) down when you retract. If it doesn't pull down, it will stay up (forward) as the frame retracts and get jammed up in the rest of the frame. Worst case it will pop the metal clip which holds the center of the cloth top to it (it is the length of the bar and spot welded to it) off. It will also put holes in your top on both sides as they don't fold down under and instead get crimped in the frame. Temp solution is to push that bar down as it retracts. Permanent solution is to repair the elastic sooner than later before it wrecks havoc with the whole frame and motor.

Posted on Oct 08, 2009

  • 1348 Answers

SOURCE: fan wont stop running after turning off 2004 nissan 350z

there is an after run module controlled by a fan switch that will run the fan if the engine compartment is hot.the switch could be shorted,or the module is bad.the fan normally runs for a few minutes then turns off.

Posted on Oct 23, 2009

  • 1 Answer

SOURCE: My power seat won't work on my nissan 350z.

It it most likely a blown fuse

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to release rear top latch without power

mike I have no idea but if you still need help get back to me, Cheers Greg.

Apr 10, 2013 | 2004 Nissan 350Z

3 Answers

The trunk latch on my 2005 350Z sticks sometimes and does not fully unlatch. I use the remote and after about five times it will open properly. I tried spraying WD-40 on the latch and it did not...

Look closely to see if anything was dropped or anything heavy placed on the latch. It may be bent ever so little. If not then your servo is losing its value and will have to be replaced.
I hope my suggestions helps and all the luck to you.

Dec 23, 2010 | 2005 Nissan 350Z

1 Answer

How to install a window 2004 nissan 350z coupe?

Remove inner panel carefully. find 2 black circle stickers and raise glass to access 2 screws holding glass. Door vent does not need to be removed.

Jan 30, 2010 | 2004 Nissan 350Z

1 Answer

Navigation lid fails to open fully

Mine doesn't even try to open. Have you resolved your issue? could you share?

Jan 19, 2010 | 2004 Nissan 350Z

1 Answer

2004 350z convertible Top

The engine has to be running the parking brake set if stick shift or in park if auto. and your foot hasto be on brake.

Jul 22, 2009 | 2004 Nissan 350Z

2 Answers

My nissan 350z sometimes stalls after starting

after i replaced the battery in my 2003 350z, it would stall immediatly after i cranked it on unless i gave it a little gas. I fixed this by cleaning the MAF and throtle body valve. Total supply costs were $15 and took about 20 minutes. My Z is not only fixed but runs smoother and cleaner.

Jul 11, 2009 | 2003 Nissan 350Z

1 Answer

Convertible top

make sure your car is in park and that you have your foot on the break....if you release your foot it will stop. So keep your foot on until it is fully open or fully closed and the passenger seat has returned to where you had it set prior to opening or closing

Jan 18, 2009 | 2004 Nissan 350Z

1 Answer

Poor Acceleration on Start 97' Tracer

check your crank/cam shaft sensors - they may be faulty

Nov 19, 2008 | 2004 Nissan Maxima

Not finding what you are looking for?
2003 Nissan 350Z Logo

Related Topics:

324 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

81400 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides