Question about 2000 Toyota Corolla

1 Answer

Corolla 2000 brakes, I did change master cylinder,

Corolla 2000 CE brakes, I did change master cylinder, all pads but the car does not brake like should do. What could be?
Without anti-lock brakes

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

System may have air in it bleed from farthest wheel to closest.
If rear shoes are out of adjustment re adjust them
Possible but most pads require a "bedding in" 20 stops 50 to25mph or so.

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1995 Toyota corolla gle 1.6 fuel injector problem is it started by binding ,, we changed master cylinder.. now only two opposite side apply brake & the other two don't work ==how


did you bleed all the brakes???

perhaps you need to check the distribution hub
all the pipes from the calipers go to a central hub then to the master brake cyclider
sometimes there is two slaves instead
so youll need to check perhaps one has failed
usually the O rings seals inside are worn
something stuck somewhere or air in the system

Dec 04, 2014 | Toyota Cars & Trucks

1 Answer

1999 corolla, brake pedal goes to the floor. how can we fix the brakes?


is the abs light on?the abs system only effects the pedal when you are stopping quickly to activate the system. you still have a hydrualic brake pressure problem. are the rear brakes shoes or pads? rear shoes out of adjustment can cause a low brake pedal.even though the master cylinder has been replaced doesn't mean you got a good part.if the part was a remanufactered part very likely it is bad. to determine if it is the master cylinder, plug off the lines from the side off the master cylinder and hit the brake pedal. if the pedal stays up look for a problem elsewhere in the system. if the pedal drops the the master cylinder is defective.

Jun 11, 2012 | Toyota Corolla Cars & Trucks

1 Answer

2003 Corolla brake fluid leak. Brake pads are new and there is no evidence of leak on ground. However, the brake fluid light comes on occasionally indicating low fluid. Sure enough, the fluid is low. Any...


If there is no visible leaking at the wheels around the braking assembly's, then the fluid will be leaking out he back of the blake master cylinder into the vacuum booster. The master cylinder is where you have been topping up the brake fluid and the booster is the big black thing the master cylinder is bolted to. You need to have this looked at by a mechanic for proper repair (unless you really trust someone),as brakes are something I think are important to a vehicles operation.

Just as a note, there is no need to buy a new master cylinder, as most brake places would have exchange units available.

Jul 10, 2011 | Toyota Corolla Cars & Trucks

2 Answers

Do 2000 chevy blazers with break pads have wheel cylinders?


brakes pads go with calipers and disc brakes,brake shoes go with drum brakes which has wheel cylinders.

May 21, 2011 | 2000 Chevrolet Blazer

1 Answer

2000 PLYMOUTH GRAND VOYAGER BRAKE SMOKING. IVE CHANGED ROTOR,PADS,CALIPER AND BLED THE BRAKES. AFTER DRIVING FOR A WHILE THE BRAKES START SMOKING FROM NOT RELEASING.


possible the master cylinder is not allowing the brakes to release all the way. also did you check the slider bolts on the brakes to make sure there not binding? if there new or all the brakes are smoking i would lean towards the master cylinder

Jan 21, 2011 | 2000 Plymouth Grand Voyager

1 Answer

Toyota corolla ae110 brakes binding


Please DO NOT drive in with the vehicle in this condition!!!!
What you have going on is that the brake caliper (part that holds your brake pads) is bad and sticking. Just remove it, get a NEW one from any chain autoparts store,and replace it. You will have to get a new set of pads as well,as due to the binding, the ones on there now are trashed.

Again,PLEASE do NOT drive in this condition as yours and your fellow drivers ,as well as your passengers safety is at stake.

May 01, 2010 | 1996 Toyota Corolla

1 Answer

Location of the emergency rear brake switch n a


Hello. I assume that you want to know the location of the switch that activates the brake light on the dash when the park brake lever is pulled. It is under the rear of the park brake handle; you need to remove the console to see it.

However...if your brake light in your dash is staying ON, I would first suggest that you look at the level of brake fluid in the master cylinder reservoir. If it is low, the light will come on, also. The fluid level in the master cylinder drops proportionally as the brake wear. I would bet that your fluid is low; about an ounce of fluid decrease will light up the brake light.

Dec 26, 2009 | 2002 Toyota Corolla

1 Answer

2000 toyota corolla ce motor trembling when on drive holding down brakes.


check the brake disks. surface should be cleaned. also check the brake pads.

May 20, 2009 | 2000 Toyota Corolla

1 Answer

2003 toyota corolla low brake fluid


The fluid level will drop when the brake pads and or shoes wear thinner. A good way to check for a hydraulic fluid leak is Shut engine off step down on the brake pedal and hold it for 3 minutes. The pedal should not slowly drop. It will go down and hold.

Feb 28, 2009 | 2003 Toyota Corolla

Not finding what you are looking for?
2000 Toyota Corolla Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...