Question about 1998 Chrysler Sebring

1 Answer

Engine stalls, wait awhile to restart, runs a little then stalls again, no AC running, tank full of gas, no check engine light on, mechanic says no code fault. No obvious problems when running, runs good. Please advise.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Look into replacing the Crankshaft Sensor and/or Camshaft Sensor. Could also be a relay/fuse in the panel under your hood.

Posted on Aug 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

N80 start


You have to find the reason the check engine light is on. This will aid in diagnostics. Also, are you buying fuel at the same place both times?

Apr 23, 2014 | 2007 Hyundai Elantra Limited Sedan

1 Answer

1995 Buick Century. Engine stalls after ~5 minutes when started warm. Engine runs rough for a few seconds before stalling. Happens even at highway cruising speed. Will crank and fire and stall when you...


Using excessive fuel cleaner can damage injectors and the fuel pump - sounds like your problem is the fuel pump bearings, and you will probably have to have it replaced.

Jun 13, 2017 | Buick Century Cars & Trucks

1 Answer

Fixya


Code F48 is for low freon in the ac, and code F49 is for the computer turning off the ac compressor because the pressure is too high or the engine temp is too high. So neither code would have a direct effect on the engine running.
You may have to get a mechanic involved that can watch the data stream coming into the computer and check the exhaust gas to see if it is too rich or too lean.

May 09, 2013 | 1990 Cadillac Deville

1 Answer

1991 Ford e350 Class C RV stalling out while driving, starts up again after 40 minutes fine. Any ideas?


The first thing you must do is check the engine control system for fault codes. To do that go here and read instructions.

Oct 26, 2012 | 1991 Ford Econoline

1 Answer

2000 legacy sudden loss of power


I'm not sure which sensor your referring to but the fuel pump & regulator are located in the tank. Did anything bang into the car or tank causing it to be on an angle? Get fuel PSI reading while running & stall & go from there. Where is this suction/clicking sound coming from?

Mar 25, 2017 | 2000 Subaru Legacy

1 Answer

Engine stalls, then runs after pressing accelerator


If you were low on gas at the time, it could have shifted the fuel in the tank when you turned. The engine can stall for a couple of seconds and then restart as the fuel pump primes again.

Jun 01, 2010 | 1998 Ford Taurus

1 Answer

The truck starts up and during traffic driving or idling, the truck just dies. I need to stop and place in park and restart the engine. A few moments of minutes later, if left idling, the engine will stall...


the gas cap can make your check engine light come on do to not enough vaccum in the take for your evap system and it could cause the vehicle to run a little funny. but highly unlikly this is your problem.if there are no trouble codes or no check engine light this could be very hard to diagnose on-line you may want to take it to a respectable mechanic and have them run an on board diagnostic test on it

Dec 30, 2009 | 2006 Nissan Frontier

1 Answer

03 Chevy Tahoe, ran a little rough, than check engine light came


when the check engine comes back on get it right to a computer at your local mechanic so you can tell what the problem is

Mar 19, 2009 | 2003 Chevrolet Tahoe

3 Answers

98 buick centry 3.1 6 cyc one owner family owned


Unfortunately, you've got serious problems. The GM 3.1 and 3.4 engines have a nasty habit of breaking camshafts. For some reason, which I have yet to determine, the cam bearings seize on the cam and the camshaft ends up breaking in half. The engine will continue to run, albeit very poorly since all the cylinders are not working because the rear half of the camshaft, which runs the oil pump, is not spinning.

Aug 29, 2008 | 1999 Buick Century

Not finding what you are looking for?
1998 Chrysler Sebring Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...