Question about 1997 Chevrolet S-10 Pickup

1 Answer

1997 s10 pickup after lights have been on for about 20 minutes they will cut off and then come back on. I can cut them off for about 30 seconds and they usualy stay on. What might be the problem

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

The delay lamp control module is at fault and needs to be replaced

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil pressure sensor lacted on a 1996 s10 2.2 Pickup


How much below 30 is it dropping? Oil pressure when in DRIVE at idle on a hot engine, is NORMAL at around 18 to 20 Psi. The warning lamp does not come on until around 7 Psi.

With that said, the oil pressure switch (for the light) is located on the lower left front of the engine. The fuel pump oil pressure switch and sender (for the gauge and fuel pump operation) is on the lower right front of the engine.

May 20, 2012 | Cars & Trucks

2 Answers

Need a wiring diagram for a chevy s10. brake


your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.

Nov 24, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

The fuel pump on my 1997 s10 pickup seems to keep running for up to 30 seconds after I turn off the engine.


the fuel pump is probably getting ready to go out ! the best thing to do is go ahead and replace it before it goes out on u then u will be out of luck! if the fuel pump is in the tank its a lot easy-or to unbolt the bed and pull it back about a foot to get to the fuel pump!

Nov 20, 2009 | 1997 Chevrolet S-10 Pickup

2 Answers

2000 s10 Blazer dies very 3-6 weeks for no reason


i would check your ignition system. you would need a meter for this but look for broke or loose connections. if it was a fuel problem i dont think it would just start up after 20 minutes. or you might try your ignition switch. if its shorting or something then ya well it would cut your engine off real quick

Mar 20, 2009 | 2000 Chevrolet Blazer

1 Answer

Starting probles


have them check the ignition !!!

I had a 1990 Cutlass that did the same thing. It would turn over but not start when it got hot too or just cut out on me right on the road. I had it in the shop 2x's , thought it was fixed and got it out of the shop only to have it die later that night in the pitch dark. I had it towed back to the shop , they let it run , hoping it would cut out and it did. It was the ignition.. when it would overheat it would just shut off the car ... you couldn't start it peroid! Like you said 20 to 30 minutes later when it cooled down the car would start back up just fine ... then you'd drive it , it would heat back up, the car wouldn't start again for another 20 to 30 minutes !

hope that helps !

Mar 12, 2009 | 1997 Hyundai Elantra

1 Answer

1997 S10 Antilock light comes on


Has there been any break work done to it lately? It could be one of the break sensors malfunctioning. or the abs needs to be reset. I have never tried this, but a friend of mine had a problem somewhat simmler to yours, he took the neg. battery cable off for about 5 minutes and hooked it back up and solved his problem. I can't say that will solve yours but its worth a shot and it don't cost anything.

Feb 05, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

1997 chevy S10 died


can you hear the pump in tank running? it should come on for a few seconds when you cut key on. sometimes you can beat on tank with your hand while someone cycles key on and get the pump to kick in. this is a temp fix though if you need a pump i find it easier to remove the bed to gain access to tank.

Jan 22, 2009 | 1997 Chevrolet S-10 Pickup

2 Answers

No tail lights


Try checking the headlight switch it may have broken contacts in it. Easy fix go to a salvage yard find same make and model truck, swap headlight switches.

Dec 27, 2008 | 1997 Chevrolet S-10 Pickup

1 Answer

1997 S10 pickup starts then shuts off in 2-4 seconds


fuel filter could have picked up garbage in the tank

Nov 11, 2008 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
1997 Chevrolet S-10 Pickup Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...