Question about 1995 Acura Integra Coupe

Open Question

CLEAR CODES 1995 ACURA INTEGRA - 1995 Acura Integra Coupe

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1779 Answers

SOURCE: acura integra engine torque specs

56 ft lbs torque main bearings, NON v-tech engine.

Posted on Jan 15, 2009

  • 87 Answers

SOURCE: Remove the hatchback on 1995 Integra

Hi,welcome to fix ya.
heres how it comes off click [b][i]HERE[/i][/b]

Posted on Apr 05, 2009

  • 2004 Answers

SOURCE: Main relay location

The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release.

rate this solution fixya.

Diagram below:-

Acura Main Relay location and removal procedures.
mainrelaylocationacura.gifrz-0063.jpgIntegra EFI Main Relay for:

  • Honda Civic/CRX/del Sol 1984-1995
  • 1986-89 INTEGRA
  • 1990-93 INTEGRA #39400-SH3-003 RELAY (RZ-0063)
  • 1986-90 LEGEND #39400-SH3-003 RELAY (RZ-0063) (RZ-0046)
  • 1991-93 LEGEND (rz-0105)
  • VIGOR (behind the left front kick panel)
The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release. The First generation Legend main relay location is between the steering column and the fuse box. It's deep in there. There was a little difficulty drawing the relay so it's actually very deep in there. There is a device (a relay) blocking the main relay. You will need to remove it to get a view of the main relay. The removal procedure is the about the same as the Accord's procedure.

Legend, 96-98 Acura TL main relay
Acura Integra 98-01 main relay location:
Locating the main relay using your ears and fingers:

1. Turn the ignition to ON. You should hear two clicks (a thousand of a second apart) under the left or right side of the dash board. One click is for the ECU/Injectors the other is for the fuel pump. At this moment the check engine light should come on.
2. Listen carefully at the moment the clicks engage (usually somewhere underneath the dashboard.) Reach in and touch the main relay.
3. 2 seconds later you should feel a click if the main relay is at least working or wait until it works. At this moment the check engine light should go out.
4. Turn the ignition to start and you should feel a click, turn engine off you should feel another click.
5. Most main relays should have seven terminals. Please check if the location is already listed below.

How do I get the main relay out?
Steps: See four ways below so you can get it out. First you have to reach high up in there and do all this with one hand and a flashlight.
efiremoveinstall.gif A. Unbolt the bolt using a 10mm socket (picture A) or
Ab. Unclip the clip from the steel tab and slide it apart (picture A) or
B. Separate the steel tab from the plastic case (picture B) with a large flat screw driver jam and twist between the plastic case and the tab or
C. Disconnect the negative battery terminal. Unclip two clips I pointed with two arrows (picture C, or below) with a small flat head screw driver or with a strong thumb and then yank it out (D.) This is the preferred choice by many. Mechanics prefer choice A and maybe B. See detailed relay circuit photo.

Posted on May 24, 2009

  • 331 Answers

SOURCE: AC is not working

Warm air blowing from the air conditioner in your Acura Integra is frustrating. Fortunately, if lack of refrigerant is the problem, recharging the system will correct the problem. In most models, you can use an R134 recharge kit from your local auto parts store.
before you perform this please read below

Inspect your air conditioning lines for damage. Some auto parts stores have kits that will help you to find leaks in the system and possibly seal small leaks. If you see any visible damage, take your Integra to a professional to recharge the air conditioning system with Freon.
Step 2Locate the Low Pressure Side port. You can find this under the hood of the car. It will be near the front grill. When you are looking from left to right, the port will be almost directly in the center. Take off the port cap and set it aside.
Step 3Determine if your car uses R134 or R12 Freon. R134 compatible models will have quick connect port valves. Models made before 1995 may use the old R12 Freon. If this is the case, you must have your Integra's air conditioning system retrofitted to use R134 Freon.
Step 4Check the air conditioning system pressure using an auto air pressure gauge. Keep in mind that the car should be on with the air conditioner running full blast. If the pressure is in the normal or high range, lack of Freon isn't the problem.
Recharge the System
Step 1Attach the refill kit hose to the connector on the Low Pressure Side of the air conditioning system. Make sure you follow the manufacturer's directions.
Step 2Open the valve on the refill hose slowly to allow the Freon to enter the air conditioning system. Keep in mind that it can take as long as 10 minutes to empty a single can of R134 into the system. Your car can hold a total of 27.4 oz. of Freon.
Step 3Close the valve on the refill hose and remove it from the Low Pressure Side port. Remember to put the cap back on the port.
Step 4Leave the air conditioner on for at least 30 minutes to allow the Freon to circulate through the entire air conditioning system.

Posted on May 26, 2009

  • 153 Answers

SOURCE: timing belt diagram fo 1990 acura Integra

78338863have fun

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the A/C compressor RELAY located on my 1995 Acura integra LS ?

The fuses in an Acura Integra are located under the dashboard on the driver's side. The under hood relay panel, which is the one that controls the air conditioning, is found on the right of the engine compartment next to the battery. Replace it with only another 10-amp fuse to avoid damaging the electrical system.

Nov 28, 2010 | 1995 Acura Integra Coupe

1 Answer

I have a 95 acura integra ls with what i think is a timing problem but anyway it bogs at take off but around 3500 rpm it runs great

check the TPS voltage Auto Zone will provide a free scan to see what problem codes you engine has

Feb 14, 2010 | 1995 Acura Integra Coupe

1 Answer

Rpm unstable

Your Idle speed control or ISC needs to be replaced. Check for vacuum leaks.

Jan 22, 2010 | 1995 Acura Integra Coupe

1 Answer

How do I take off the shift knob and the bag surrounding it. the car is a 1995 Acura Integra

give these websites a try and if all fails stop your local acura dealership in the parts department and they will print you out pictures and diagram for free wish you the best of luck Michigan Man.

Nov 13, 2009 | 1995 Acura Integra Coupe

1 Answer

I need to know how to disconnect my 1995 Acura Integra's kill switch please.

This link will show you many posts on the Honda Acura killswitch bypass.

Sep 30, 2009 | 1995 Acura Integra Coupe

1 Answer

Cant find my oil filter, can someone help?

Underneath, on the DRIVER'S side of the engine, right above the axle.

Apr 12, 2009 | 1995 Acura Integra Coupe

1 Answer


have it scanned c what the codes r

Dec 24, 2008 | 1995 Acura Integra Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

746 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides