Question about Honda Odyssey

1 Answer

Rear wiper skips across window and leaves streaks what needs to be replaced

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,070 Answers

It could be because of too much pressure of the wiper on the glass. Or the blade needs replaced. There should be a screw in the wiper that controls the tension on the spring.

Posted on Jul 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need instuctions to replace the rear wiper blade on a 2003 Jeep Grand Cherokee.


Take it to any parts store and they will do it for you for free, there are three types, the rocker type which you have to raise the wiper arm away from the glass then pull the tab up then slide the wiper down and slide the wiper off the wiper arm. but the best thing is have someone show you how to do it for the first time sometimes they can be tough to get off.

Jan 19, 2010 | 2003 Jeep Grand Cherokee

1 Answer

Rear wiper dosent clear whole window the wiper skips parts of the window


the wiper arm has a spring pulling in tight towards window the arm has a pin at one end where spring connects to the pin acts as a hinge it must be seized spray some lubricant on it and move it around to get it to break free.

Jan 12, 2010 | 2003 Buick Rendezvous

1 Answer

How can I fix my rear wiper. It doesn't go across


no problem,
you need to find the base of the wiper arm where it connects to your window.lift up a plastic flip piece that covers a 13mm nut,loosen the nut just a little bit them move arm where the it should be"in the stop position".
and re-tighten nut tight.

Dec 28, 2009 | 2005 Dodge Caravan

1 Answer

My 07 nissan murano rear windshield wiper doesn't work properly it goes the wrong way, not on the window.


You need to adjust the wiper arm location. Loosen the 12 mm or 10 mm nut that holds the rear wiper arm. Wiggle the arm until it comes off. Then turn on the rear wiper for a second and turn it off, leaving the key on. This way the rear wiper motor will do it's sweep, and them park where it's suppose to. Then reattach the rear wiper arm and secure the nut and recheck.

Thanks Jay!

Jul 20, 2009 | 2007 Nissan Murano SE

1 Answer

Rear wiper motor not working


most likely the wiper motor is bad the second wire sould be a ground if you set meter to ohms you sould be able to get a low resistance to any good ground on the vehicle if the hot wire is hot any time key is on the bcm is controling the ground to operate moter and you should have a steady continuity on the ground side with switch on the fast postion an it will read on and off in the intermitant postion if both wires test good motor is bad when you replace motor let it cycle and shut it off before installing the arm on it

May 21, 2009 | 2005 Dodge Caravan

1 Answer

2008 Jetta wiper makes streak on windshield


go online and buy new front wiper arms, you get them fairly cheep 15$ for one. your old original arm may have had a defect or had just been bent a little some howk, this could be whats causing the streaks.

May 06, 2009 | 2006 Ford F 350 Super Duty

2 Answers

Rear wiper stopped working


my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

Feb 25, 2009 | 2004 Ford Expedition

1 Answer

Ford Escape rear wiper doesn't remove anything


rear wipers are horrid for that... i just bent the wiper arm a little toward the window... works fine

Robert

Please take a moment to rate this solution thanks

Jan 30, 2009 | 2005 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...