Question about 1996 Chevrolet Corsica

Open Question

1995 corsica that wont shift into reverse

I have a 1995 chevy corsica that wont shift into reverse by gear shift but will shift unto reverse if i shift arm on tranny by hand engine is a 3.1

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: 1995 crown vic gear problems/gear shift wont lock

if the shifter is loose and sloppy feeling then the shift cable bracket has come loose under the dash at the steering wheel. remove the lower panel under the steering wheel so you can see under the dash then get flash light and look while jiggling the shifter. you should be able to see the cable and bracket. if the bracket is loose then tighten the bolts. note this bracket is at the steering colum.

Posted on Jan 22, 2009

Ad
emissionwiz
  • 76164 Answers

SOURCE: 4L60E won't shift to 3rd on 1995 Chevy Astro 2wd

do the pin point tests, these start witjh running a trouble code test, autozone and kragen will do this for free, if u haven't had the trans apart then cross out any crossed wiring issues, but I do think you will find a problem with the 2-3 shift solenoid, either the solenoid has failed or the connector has a problem on the outside of the trans.

Posted on Feb 25, 2009

  • 180 Answers

SOURCE: 1995 Chevy k1500 Transmission Problems

If check engine light is on ,remove battery cable, you have an electrical problem, maybe fuse?

Posted on Mar 16, 2009

Molson02536
  • 3854 Answers

SOURCE: transmission will not shift

Check the Vehicle Velocity Sensor (V V S)-(Speed Sensor) or the wire harness to the VVS. IF the ECM is not getting a signal from the V V S, the PCM can not give the signal to switch gears. The V V S is on the drivers side of the end ot the transmission that is held on by one bolt. Best thing to do is to have the truck scanned at Auto Zone for a DTC code and to confirm that the V V S has gone bad and they can give you the step by step instruction to replacing the sensor and takes about 15 min to do. Good luck and keep me posted. Keep an eye on the transmission fluid, make sure you don't run the transmission to hard and burn it out over a $40.00 sensor which is better then $1,800 for a transmission replacement. 

Posted on Jun 22, 2009

  • 12173 Answers

SOURCE: Chevy Corsica 1995 gearshifting speed problem

ur computer probably wont show anything ur tranny problem can be anything fron needing a filter changed to vacuum problem to torque converter check the fluid for level if low fill up- before filling look and smell fluid it should be reddish in color not brownish [fluid burnt]if it smells burnt- need trans service can be just a filter and flush ,bad sensor-actuator or rebuild

Posted on Feb 13, 2010

Testimonial: "Thank you for your answer. My friend though almost the same about some of what you wrote and I will check it out. Thanks! :)"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 chevy regular cab 4.3l v6 2wd wont go into overdrive


Sounds like it is stuck in second gear. Overdrive only drops rpm by a couple hundred. In third gears you should still be less than 3,000 rpm.

Second gear is a default gear when the transmission is in limp mode. Is the check engine light on? Does it shift if you manual shift through the gears with the gear selector?

Sep 21, 2014 | 1995 Chevrolet C1500

1 Answer

How to replace a shift cable on 1995 Chevy Silverado 1500 series


You first need to unhook the shift cable from the top of the gear box , then carefully remove it from the gear liver linkage and follow the reverse step to fix the new one. I am sharing a video of GM hope it will give some refrence .

Jun 01, 2014 | Chevrolet Cars & Trucks

1 Answer

My 1995 2500 chevy trans shifts good from forward to reverse but don't shift to any higher forward gears sat for a couple months before that no issues this truck has the 6.5 turbo


Thats not good !
I suggest that the truck be started and warmed up a while.
Then try to drive it around a bit in the yard or where ever.
If that doesnt work out the suspected clog, then I would roll under the truck and look to see if something hasn't eatten away at the wire harness for the trans.

Nov 28, 2011 | 1995 Chevrolet C/K 2500

1 Answer

1991 Corsica: Where do I find the trunk release lever in my 91 c...


My 91 has a button located to the left of the gear shift (center console). It's an electric control that, when pushed, opens the trunk.

May 18, 2010 | 1991 Chevrolet Corsica

1 Answer

Chevy Corsica 1995 gearshifting speed problem


ur computer probably wont show anything ur tranny problem can be anything fron needing a filter changed to vacuum problem to torque converter check the fluid for level if low fill up- before filling look and smell fluid it should be reddish in color not brownish [fluid burnt]if it smells burnt- need trans service can be just a filter and flush ,bad sensor-actuator or rebuild

Feb 13, 2010 | 1995 Chevrolet Corsica

1 Answer

1995 crown vic gear problems/gear shift wont lock


most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.

May 30, 2009 | 1995 Ford Crown Victoria

2 Answers

1995 Chevy k1500 Transmission Problems


If check engine light is on ,remove battery cable, you have an electrical problem, maybe fuse?

Mar 16, 2009 | 1995 Chevrolet K1500

1 Answer

1995 chevy s-10 blazer does not shift gears


Tell me something. Does it seem like the truck is in 3rd gear when you shift in D.If is it I know what it is.

Jan 22, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

1995 crown vic gear problems/gear shift wont lock


if the shifter is loose and sloppy feeling then the shift cable bracket has come loose under the dash at the steering wheel. remove the lower panel under the steering wheel so you can see under the dash then get flash light and look while jiggling the shifter. you should be able to see the cable and bracket. if the bracket is loose then tighten the bolts. note this bracket is at the steering colum.

Jan 21, 2009 | 1995 Ford Crown Victoria

1 Answer

I have a 1995 Chevy corsica it starts up fine, i went to go put it into gear and it wont go i tried all, reverse, drive, overdrive, low and it wont even budge


call a garage,this could be a multitude of faults but most likely the problemis the front clutch has gone or the pump

Jan 01, 2009 | 1995 Chevrolet Corsica

Not finding what you are looking for?
1996 Chevrolet Corsica Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...