Question about 2001 Audi TT

Open Question

How to replace Audi TT headlight bulb - 2001 Audi TT

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
j_del
  • 1586 Answers

SOURCE: 2002 Audi TT

Nothing special at all - just remove the back cover on the headlamp and you'll see inside that the bulbs are pinned in place with hinged metal wire clips. Release the clips and the bulbs should come right out.

Posted on Sep 15, 2008

Ad
Scorpedo
  • 111 Answers

SOURCE: bulb replacment

The bulbs are changed from the rear. There might be a weather cover, once its removed you will see a ring or clip holding in the bulb , remove that to remove the bulb. Install in reverse order. And a little known fact most parts stores will install bulbs for free when you buy them.

Posted on Dec 16, 2008

JettaRed
  • 7 Answers

SOURCE: Audi TT HID bulb needs replacing

You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.

Good luck.

Posted on Nov 21, 2009

  • 1 Answer

SOURCE: 2004 Audi A4 headlight replacement

you have to loosen the whole headlight assembly to open the covers behind the lights to actually get to the bulbs. 4 screws, 2 are on the top of the assembly(phillips screws) the other two are hex and attach the bottom of the assembly to the car. somewhat difficult to see but look behind the assembly and down into the compartment and loosen the screws(they don't fully come out) just enough to pull the assembly out. open the black cover behind he low bean and there is the bulb

Posted on Feb 05, 2010

  • 1 Answer

SOURCE: 2000 Audi a4 headlight bulb replacement

At least on the driver side, there really is no reason to remove the entire headlight assembly. I was able to swap out the bulb fairly easily but simply removing the dust cap, popping the connector off the bulb, and then undo the clip holding the bulb in place. The just reverse order to install the new bulb. Took about 3 minutes.

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The xenon headlights on my 2002 Audi TT quattro are aiming down. Can only see about 10 feet in front at night. Recently had the headlight sensor replaced & was told that the headlights would adjust...


go back to were you had the sensor replaced and have them repair the problem this should have been working properly before it left the shop.it could even be a bad sensor.

Sep 10, 2011 | 2002 Audi TT

1 Answer

Cant find manuel waring light circle with X


Photo of a lamp failure icon on 2001 Audi TT. This is what you should get with the high pixel cluster. Check all car lights bulbs & replace bad bulb(s).

e8f9798.jpg

See also for the next Audi TT model:
54590ef.jpg

Oct 11, 2010 | 2001 Audi TT

2 Answers

Can't adjust the height of the headlights


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Sep 13, 2009 | 2004 Audi TT

2 Answers

Audi TT Intermittent headlight


Did exactly as you said, replaced both bulbs with the d2s as you said and got them on ebay, driver side was clearly more difficult to put in, passenger side very easy, worked perfect for 1 day and the intermittent problem returned. What to do.

Aug 22, 2009 | 2005 Audi TT

1 Answer

Audit TT passenger headlight goes out


The ignitor or ballast must stay energized for the bulb to stay lit..If the bulb comes on then goes off, or flickers, then the ignitor is defective. You are in the early stages of failure, it will eventually stop working altogether

Jun 27, 2009 | 2005 Audi TT

1 Answer

Audi TT HID bulb needs replacing


You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.

Good luck.

Mar 14, 2009 | 2005 Audi TT

1 Answer

2002 Audi TT


Nothing special at all - just remove the back cover on the headlamp and you'll see inside that the bulbs are pinned in place with hinged metal wire clips. Release the clips and the bulbs should come right out.

Sep 15, 2008 | 2002 Audi TT

Not finding what you are looking for?
2001 Audi TT Logo

Related Topics:

4,758 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14362 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...