Question about 1984 Pontiac Fiero

1 Answer

How would I go about replacing the starter on a 1984 Fiero SE?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 977 Answers

Disconnect the battery lead from the starter plus any other wires undo the starter flange bolts that hold it onto the motor then it should pull straight out.....hope this helps .....cheers

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the maximum speed pontiac fiero 1983


In December 1983, Car and Driver clocked a four-speed Fiero SE from 0-60 mph (0-97 kph) in an uninspiring 11.3 seconds, reaching a top speed of 105 mph (169 kph).

Pontiac Fiero The Definitive History

Below are speeds related to 1984 and above.
Fiero Top Speed once and for all

Sep 03, 2017 | Pontiac Cars & Trucks

1 Answer

After hooking up a new starter on a 1984 fiero the starter engages as soon as I hook up the battery post


remove the small wire from the solenoid and try it again if it cranks then you have a defective starter

Jun 19, 2012 | 1984 Pontiac Fiero

1 Answer

How do I replace my alternator on my 1984 Fiero


you can do it from underneath, its a tight fit. I have a 1987 4cyl and had to replace the water pump and alternator.

Sep 04, 2010 | 1984 Pontiac Fiero

1 Answer

My 86 Fiero SE clutch master cylinder is weeping


Replace it. Not a difficult job. Be careful the bracket on the V6 4spd. isn't strong so don't break it while loosening the slave cylinder retaining nuts.

Good luck,

Rebel Faggioli

Dec 30, 2009 | 1986 Pontiac Fiero

1 Answer

Where is the brake light relay on a 1984 Fiero


Check the brake light switch. It's located under the dash by the brake pedal. Disconnect the electrical connector from the switch. Jump the connector with a paper clip. Be careful not to let the paper clip touch a metal surface. If the brake lights come on then the problem is a faulty brake light switch.

Sep 27, 2009 | 1984 Pontiac Fiero

2 Answers

1985 fiero been having problems getting in gear. Now wont turn over starter. New starter didnt fix problem. Dont know if 2 problems are related. Can push start.


Have same car, same problems, easy solutions.

Getting into gear has been improved by putting in neutral with engine running to warm up fluid. The Fiero has very little room in the pedal area. I'm shifting a lot better with smaller shoes.

The problem with starting may well be related to the same issue. There is a neutral safety starting switch. If you're not pressing hard enough on the clutch - starter won't run. According to the Fierostore.com stock clutch pedals tend to bend. They sell a stronger replacement.

My Fiero has been starting just fine the last few days. The last time it didn't I was wearing boots.

I've almost always been able to get it to start using a booster battery, but Walmart's tester indicates that the battery and charging system are fine. It recommends tightening connections. I did this, but still had problems for a while.

Jul 05, 2009 | 1985 Pontiac Fiero

1 Answer

Removel of fuel pump on an 1984 pontiac fiero se


Remove the fuel tank, sits under the car, looks like a casket.

You actually sit to either side of it when you're in the car, that's why it has such a big hump in the middle. Any GM fuel pump works for it.

Mar 25, 2009 | 1984 Pontiac Fiero

1 Answer

My 1984 fiero turns over but wont start...


9 times out of 10 its a timing issue when ive changed headgaskets;)

Nov 07, 2008 | 1984 Pontiac Fiero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...