Question about 1993 Subaru Impreza

1 Answer

My car starts to miss at high speeds. when I hit the gas it sputters. If I turn it off for a while it starts back up. I replaced the knock sensor but it is still doing it.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 40 Answers

Ideally a fault code scan / diagnostic session is required but from experience i have changed loads of crankshaft sensors and camshaft sensors, these cause a lot of running issues and usually sort them when replaced. hope this helps

Posted on Jul 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Subaru wrx is making a knocking noise when started. When I accelerate the knock gets louder and car doesn't seem to pick up speed. When the gas is hit rpms climb slow and my boost gauge revs high?...


Remove the front o2 sensor from the exhaust system and if performance improves that means you probably have a plugged catalytic converter which will need to be replaced

Dec 07, 2013 | Cars & Trucks

3 Answers

2002 Sable sedan choke/missing/sputtering intermittent


The PO 316 is still misfires om first 1000 revolutions
so the shop did a poor job for you on resolveing the
cylinder misfires

Try a diffferent shop

Have to clean the MAF Sensor & replace upstream
oxygen sensors if over 100,000 miles

Need the correct oem spark spark plugs/any brand

No reason the gas filter should be clogged unless it was in
the car for 10 years

Fuel pressure should be checked

Need to check for cylinder misfires on a road test of 20
miles or more with professional software in Mode#06

Jan 17, 2013 | 2002 Mercury Sable

1 Answer

Sputtering at high speed


i think only the link given visit their and your problem will be solved http://toolsnyou.com/

Aug 12, 2017 | 2002 Pontiac Aztek

1 Answer

Knock engine sensor light on truck is hesitating/


Did they replace the knock sensor?Check the wire going to the sensor(knock).Look for a bare place hiting up against something ,grounding it out.Make sure the plug to knock sensor is good.And make sure it is making a good connection,Knock sensors also ground a part of the computer to feed back imformation.This connection is a must,the truck will not perform at all,stumble,miss,and carry on.Sometimes even backfire.If they did not replace the knock sensor,replace it with high quality sensor from NAPA,or oem from dealer.This sensor has to be made perfect,no room for inperfection.The knock sensor is easy to replace,they just screw in a hole in the block.When removing the sensors,nothing will come out such as oil or water,this is a dry threaded hole.It is a bell shaped sensor.If you don`t know which sensor is bad,purchase one.replace one,and if there is no change,replace the other side with the old sensor you just took out,it will be a good one.I hope this helps you,Let us know if it does.

Oct 05, 2009 | 2000 Chevrolet Silverado 1500

3 Answers

92 astro runs rough


have mass airflow sensor cked.

May 28, 2009 | 1993 Chevrolet Astro

2 Answers

92 SL1 won't start, turns over but not getting gas, or floods


Try pulling the engine coolant temp sensor, They often crack not sure why but the ceramic tip cracks makes the car hard to start, the car's idle may race while shifting gears, and often smokes. The sensor is on the right side of the engine when looking at it on the head. Easy to change and get too

Dec 28, 2008 | 1992 Saturn SC

1 Answer

Car sputters


is it 4 cyl 6 cyl if it is the 2.4 quad four i would replace the plug tubes from the coils to the plugs if it is the 6 cyl i would replace the plug wires and inspect the coil towers for corrosion

Oct 17, 2008 | 1994 Chevrolet Beretta

1 Answer

98 Saturn SL 1 sputters


Have a scanner hooked up to your car and do a data stream to see if your knock sensor is still working. On a heavy load, if the ECM detects detenation in the engine, it will automatically want to ****** the timing to make it run better on a load.

Jun 10, 2008 | Saturn SL1 Cars & Trucks

Not finding what you are looking for?
1993 Subaru Impreza Logo

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...