Question about 1997 Chevrolet Cavalier

1 Answer

Order for wires on starter for my 1997 cavilier 2.2l engine

Un screwed the four wires on the starter, had to take it off to do other work on the engine. I don't remember which wires go to what post.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 249 Answers

Shouldn't be to hard.. 3 go to the main cable and one to the start position on the solenoid .. ( the purple one goes on the small stud )

Posted on Jul 22, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I jump the starter on my 91 camaro?


hot wire starter you can short out ignition switch and wiring. to jump starter ignition switch start postion.you have to run 10 gauge jumper wire from the starter solenoid positive battery terminal to starter switch or S terminal on starter solenoid this procedure take two people but better remove starter replace starter solenoid. trying jumping off starter on camaro would be dangerous you have jack up car to get to starter and wiring person laying under car hot wiring starter while other person hold ignition start position put person under car in deadly position just remove starter have auto parts check it out first replace starter or solenoid if either bad. easier hot wire starter if starter under hood like my 1977 vega monza had starter at top could take long screw driver jump starter off.on the four cylinders engines back in the 70s. camaro starter under car dangerous trying to hot wire not a good idea.

May 07, 2013 | Cars & Trucks

2 Answers

Went through a puddle. Car died. Restarted a day


See these items:-

The starter must have been bad due to the water.

Bad PCM or ignition coil.

Corroded battery cables.

See timing belt.

Good luck

Feb 28, 2010 | 1997 Volkswagen Jetta

1 Answer

Starter or flyweel noises on chec cavilier 1997


if starter head isnt broken than its abroken flexplat/flywheel

Feb 13, 2010 | 1997 Chevrolet Cavalier

1 Answer

I have a 1997 pontiac grand am with a 2.4 dohc quad four engine.I need a wiring diagram showing how the starter is wired up.


you can call technical support for Pontiac and they can mail or email you the wiring diagram.. if not then you can get it from PepBoys the Repair Book which shows all diagrams for this particular vehicle

Sep 18, 2009 | 1997 Pontiac Grand Am

2 Answers

1997 z71 Transmission removal




  1. Disconnect the battery negative cable.
  2. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Disconnect the range selector cable from the transmission bracket and from the transmission range select lever. Refer to Shift Cable Replacement .
  4. Remove the rear propeller shaft. Refer to Rear Propeller Shaft in Propeller Shaft.
  5. Support the transmission with a transmission jack.
  6. Remove the transfer case if equipped. Refer to the appropriate Transfer Case Replacement in Transfer Case:
  7. Transfer Case Replacement (Selectable Four Wheel Drive) . • Transfer Case Replacement (Auto Four Wheel Drive ) . • Transfer Case Replacement (Manual Four Wheel Drive) .
    102329.gif
    tif.gif
  8. Gasoline Engine--Remove the following components:
  9. 7.1. Two bolts 7.2. Two washers 7.3. One nut 7.4. The transmission to engine brace
    102332.gif
    tif.gif
  10. Diesel Engine--Remove the following components:
  11. 8.1. Two bolts 8.2. Two washers 8.3. One nut 8.4. The transmission to engine brace
  12. Remove the transmission rear mount.
  13. Remove the frame crossmember.
  14. Remove the exhaust pipe from the exhaust manifolds. Remove the muffler assembly from the exhaust pipe, if required. Refer to Exhaust System.

  15. 102208.gif
    tif.gif
  16. For the 5.0L Gasoline Engine: Remove the six bolts securing the converter cover to the transmission.
  17. Remove the starter. Refer to Starter Replacement in Engine Electrical.
  18. For the 4.3L Gasoline Engine: Remove the dust plug at the end of the starter mounting port in order to gain access to the converter bolts.

  19. 102335.gif
    tif.gif
  20. For the Diesel Engine and 7.4L/5.7L Engines: Remove the four bolts securing the converter cover to the transmission.
  21. Mark the flywheel and the torque converter alignment.

  22. 102211.gif
    tif.gif
  23. Remove the bolts that attach the torque converter to the engine flywheel.

  24. 102339.gif
    tif.gif
  25. Remove the transmission vent hose.
  26. Disconnect the wiring harness connectors from the vehicle speed sensors and from the park neutral position switch.
  27. Remove all vehicle electrical harness wires, harness clips, tubes, and brackets that may interfere with the removal of the transmission.
  28. Remove the fluid fill tube and the fill tube seal from the transmission. Refer to Filler Tube Replacement .
  29. Plug the fluid fill tube opening in the transmission.
  30. Disconnect the transmission oil cooler pipes from the transmission. Refer to the oil cooler pipe quick connect fittings removal procedure in Oil Cooler Hose/Pipe Replacement .
  31. Plug the transmission oil cooler pipe connectors in the transmission case.
  32. Install the J 21366 in order to keep the torque converter from sliding off of the transmission turbine shaft.
  33. Support the engine with a suitable jack stand before removing the transmission from the engine.

  34. 102341.gif
    tif.gif
  35. 5.0L and 5.7L Gasoline Engine: Remove the studs and bolts securing the transmission to the engine.

  36. 102343.gif
    tif.gif
  37. 4.3L Gasoline Engine: Remove the studs and bolts securing the transmission to the engine.
  38. Pull the transmission straight back from the engine.
  39. Lower the transmission using the transmission jack.
  40. Flush the transmission oil cooler and the pipes whenever you remove the transmission for overhaul, or replacement of the torque converter, the pump, or the transmission case. Refer to Transmission Fluid Cooler Flushing .
  41. Clean the transmission case using a solvent dampened cloth. Do not allow solvent to enter the transmission.
  42. Air dry the transmission.
  43. Clean all hardware and the flywheel cover using solvent. Air dry all the parts.
  44. Inspect all the components for wear and damage.
  45. Inspect all the seals and the fittings for signs of wear.
  46. Inspect the torque converter for stripped or broken weld nuts.
  47. Inspect the transmission case for cracks.

Jul 06, 2009 | 1997 Chevrolet K1500

2 Answers

How do I replace the starter


disconnect the battery post....remove the bolts holding the starter and then disconnect the wires to the starter.. install in reverse order

Jun 04, 2009 | 1995 Geo Metro

2 Answers

Firing order for 1997 jeep cherokee straight 6 cyl.


153624 On cap #1 is two towers clockwise from right side hold-down screw, #1 is front cyl on engine. Firing order is clockwise.

Apr 15, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

Car smoking black smoke and has no power.


CHECK YOUR O2 SINCOR I BET THATS WHAT IT IS ITS ON YOUR MANFOLE COMEING OFF THE MOTER SHOULD BEE 2 OR MABY THREE WIRS IT JUST UN SCREWS LIKE A SPARK PLUG BUT TAKES A SPICHEL RANCH TO DO SO U DONT BRAKE THE WIRES

Mar 30, 2009 | 1997 Volkswagen Passat

Not finding what you are looking for?
1997 Chevrolet Cavalier Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...