Question about 2005 Lincoln Navigator

Open Question

2005 lincoln navigator air suspension does not lift

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 lincoln navigator, check air

Check your Suspension relay under you front bumper on the passenger side most of the time it get loose or just corroded from the weather (snow , Water)... clean it up and put dielectric grease in it

Posted on Sep 24, 2008

Ad
  • 4369 Answers

SOURCE: lincoln navigator air suspension is all the way down

that should not happen. Did you turn the switch off in the back for the suspension? Did you do something else at the same time, like check the spare tire for air pressure?

I have info on 2003 navigator 4 wheel air suspension. Maybe similar

SECTION 204-05: Vehicle Dynamic Suspension — 4-Wheel 2003 Expedition/Navigator Workshop Manual
DESCRIPTION AND OPERATION Vehicle Dynamic Suspension The four wheel air suspension system is comprised of the following components:

  • service switch
  • control module
  • two front height sensors
  • one rear height sensor
  • compressor and drier assembly (includes vent solenoid)
  • air lines
  • front and rear air spring and shock absorber assemblies
  • four air spring solenoids
WARNING: The service switch for the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the jack storage area in the rear of the passenger compartment. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.

WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.

Air Suspension Pneumatic Diagram 801e0c4.gif
Item Part Number Description 1 5319 Air compressor and drier 2 5B322 Air line T-fitting 3 5B321 Air line union 4 — Air line Y-fitting 5 18945/5311 Air spring and solenoid
------------------------------
Principles of Operation
The 4-wheel air suspension (4WAS) module commands changes in vehicle height that are necessary for both the load leveling and the vertical height adjustment features.
The 4WAS load leveling feature automatically makes adjustments in vehicle height so that the vehicle is always at trim height, and that constant front-to-rear vehicle attitudes are maintained over the load range of the vehicle. Adjustments in height that are necessary to correct height differences between the vehicle left and right sides for the 4WAS system are restricted to what can be reliably achieved with three height sensors.
The height adjustment feature has three vehicle heights within a two-inch span:
Kneel height — improves the ease of entering and exiting by lowering the vehicle one inch below the trim height in the front and rear when the vehicle ignition is in the OFF or LOCK positions and the vehicle is stationary.
Trim height — normal vehicle ride position; vehicle moves to trim position when the ignition is ON, when the transmission is initially shifted to DRIVE or REVERSE mode, when all doors are closed or when speed of more than 24 km/h (15 mph) is detected.
Off-road height — improves ground clearance by raising the vehicle one inch above trim height in the front and rear when the vehicle is at 4x4 low modes and the vehicle speed is less than 40 km/h (25 mph).
The 4WAS module uses the universal bus protocol, (UBP), module communications network for sending and receiving various signals with the exception of speed, information from the three height sensors, and the air suspension service switch. For additional information about UBP, refer to Section 418-00 .
The 4WAS system holds vehicle height when any door or rear hatch is opened. The system stores front and rear vehicle height the moment any door is detected open. The system then maintains this height regardless of the addition or removal of a load. The system returns to its commanded height when all doors are closed or vehicle speed exceeds 24 km/h (15 mph).

-------------------------------
Air Suspension Service Switch
The air suspension service switch signal is needed to wake up the 4WAS module. Without the module receiving this signal, the 4WAS system is inoperative at speeds below 24 km/h (15 mph) and will not react when the vehicle is raised or lowered. At speeds above 24 km/h (15 mph), the system will be active as if the air suspension service switch is in the ON position.
Vehicles without message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, a "CHECK SUSP" will appear in the RH corner of the instrument cluster.
Vehicles with message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, the message center will display "SUSPENSION SWITCHED OFF"
-------------------------------------------
Inspection and Verification
  1. Verify the customer concern.
  1. NOTE: If the door ajar indicator is illuminated when all doors, liftgate, and liftgate glass are closed, the air suspension will not work correctly. Repair door ajar indicator; refer to Section 413-01 .
    Visually inspect for obvious signs of mechanical and electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Restricted suspension movement
  • Excessive vehicle load
  • Cut, severed, crimped air line(s)
  • Unmounted height sensor(s)
  • Damaged front air spring(s)
  • Damaged rear air spring(s)
  • Battery junction box (BJB) fuses 20 (30A), fuse 27 (5A), and fuse 111 (50A)
  • Loose, corroded, or disconnected connectors
  • Air suspension service switch is in the OFF position
  • Damaged solenoid valve(s)

-------------------------
I fthis does not help, the dealer can hook up his diagnostic equipment and download fault codes. Good luck. Please give best rating if this helps.

Posted on Apr 20, 2009

  • 740 Answers

SOURCE: 2000 lincoln Navigator air suspension

There are level control sensors they look like little arms (with joints like your elbows) mountesd on lower control arms. They may be at fault they control the height and turn the pump off when the height is reached. try adjust height first before you replace, they can be adjusted. Good Luck

Posted on Dec 17, 2008

fastboyz
  • 674 Answers

SOURCE: 03 lincoln navigator air suspension

you need to check your real axle sensor it may have come loose or broken

Posted on Jan 02, 2009

chrischronic
  • 235 Answers

SOURCE: Air suspension pump on 2003 lincoln navigator

the little orange or red ring around the air hose whare it goes in compressor, must be pushed in while pulling out on air line. a small flathead screwdriver works fine

Posted on Apr 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the switch for the air suspension


Turn Off Suspension Switch Before Jacking/Lifting Vehicle ...

repairpal.com > Problems > Lincoln > Navigator
Turn Off Air Suspension System Before Jacking/Lifting Vehicle on Lincoln Navigator. Prior to jacking or lifting a vehicle with air suspension, you must turn off thesuspension switch. The switch is generally located in the trunk or on the right side of the passenger foot well. RepairPal Verified.

    GMC Envoy Air Suspension Sensor - YouTube

    ? 4:25
    https://www.youtube.com/watch?v=mh8rieTxFEM
    Sep 27, 2013 - Uploaded by klondikerabbit
    In this video, I am trying to diagnose and adjust the rear air suspension sensors on a 2003 GMC Envoy. The ... images for envoy where is the air suspension switch

Nov 01, 2015 | GMC Envoy Cars & Trucks

2 Answers

How do I know if the suspension control module is bad in a 2005 lincoln navigator?


This is a very complicated and expensive system to maintain. I would strongly recommend doing a air suspension conversion on your Navigator and be done with the problem forever.

Lincoln Navigator Air Suspension Conversion 03 06

Apr 20, 2015 | 2005 Lincoln Navigator

2 Answers

Air suspension strut


fill your info at www.starbaja.com or call.

California air ride repair

Apr 14, 2013 | 2003 Lincoln Navigator

2 Answers

2005 Lincoln navigator suspension problem


MAY CHECK TO SEE IF LINES ARE PLUGGED WITH DEBRIE OR SUGGEST DISCONNECTING THE AIR LINES WITH VEHICLE OFF START VEHICLE MAKE SURE AIR FLOW IS COMMING OUT BOTH LINES SHUT OFF AUTO RECONNECT LINES THIS SHOULD BLEED THE SYSTEM THEN RESTART AUTO.

Jan 02, 2013 | 2005 Lincoln Navigator

2 Answers

My 2005 lincoln navigator air suspension doesnt want to work how do i make it lift up?


my 2005 lincoln navigator air suspension doesnt want to work how do i make it lift up?

Sep 11, 2010 | 2005 Lincoln Navigator

3 Answers

03 lincoln navigator air suspension


you need to check your real axle sensor it may have come loose or broken

Jan 02, 2009 | 2003 Lincoln Navigator

1 Answer

2000 lincoln Navigator air suspension


There are level control sensors they look like little arms (with joints like your elbows) mountesd on lower control arms. They may be at fault they control the height and turn the pump off when the height is reached. try adjust height first before you replace, they can be adjusted. Good Luck

Dec 17, 2008 | 2000 Lincoln Navigator

1 Answer

AIR SUSPENSION QUIT


TOOK IT TO A LINCOLN DEALER:
REPLACED AIR SUSPENSION PUMP
(THEY FOUND PUMP TO BE "SUDDENLY"BURNED OUT) (heart-attack)...
1.) 6L1Z*5319*AA COMPRESSOR $433.10
2.) LABOR 287.00

YUCK $$$ GONE/ +TAX...

NEEDED TO HAPPEN/ FRAME WAS ON FRONT WHEELS/WOULD NOT LIFT.

THANKX FOR THIS FORUM...

lkah1218@AOL.COM


Sep 19, 2008 | 2003 Lincoln Navigator

Not finding what you are looking for?
2005 Lincoln Navigator Logo

Related Topics:

860 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

fordexpert

Level 3 Expert

5626 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...