Question about 2000 Chrysler Grand Voyager

Open Question

My chrysler voyager interior lights wont go out. And when i take key out ignition it is still bleeping as though i have key in and door open

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 36 Answers

SOURCE: driver's door won't open

The problem is the door latch, you can use sawsall to cut the door stricker off this way you can open the door and replace the latch

Posted on Jan 04, 2009

Ad
  • 1 Answer

SOURCE: Central locking not working, Chrysler Voyager Limited 2005

hi this works on most voyagers disconect the possative terminal on the battery for ten minites excactly then reconnect and happy days your voyager centrol locking should work ok good luck

Posted on Feb 10, 2009

chuck943
  • 783 Answers

SOURCE: message says "door ajar" but no door open

There are 2 things we see on these models. 1st one is it could be a stuck door adjar switch. For this you can try and put WD40 into the latch on the side of the door, put a generous amount directly into the latch then close and open the door several times.This will un-stick a switch most of the time.
2nd thing it could be, open the door and look at the front of the opening between door and A pillar and you will see a black rubber accordian tube running between body and door,this is where the wires run from body to door. Sometimes a wire will break inside this.You can usually verify this by taking a screwdiver and trip the latch so that it shows the door closed(even though u have it open) then wiggle that harness and see if it effects the door adjar light.

Posted on Feb 11, 2009

  • 412 Answers

SOURCE: 2005 Chrysler Grand Voyager. Central locking

the body control module may need a software update..check with your local dealer

Posted on Jun 12, 2009

inkedsgt
  • 359 Answers

SOURCE: put key in ignition trunk open, gas door opens,

do you have spark and fuel in the right places on the engine?

Posted on Jul 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I'm new to this and looking for help , 2009 Chrysler town and country grand voyager rear doors and interior lights don't work from roof console .


sorry no idea not the common vehicle on spanish roads although they are here as well ,i think a mult`plug is loose but where ? you may be better off taking it to a dealer as one of there mechanics will surely have had this problem before so it could be cheaper in the long run

Feb 10, 2018 | Chrysler Cars & Trucks

2 Answers

2000 chrysler voyager. .audiovox system.. car is totally dead..no lights of any kind...alarm is chirpping, can not disengage


First put a booster pack or hook your booter cable on the car and there powerto the voyager take your remote and unlock the car if you dont have a remote simply unlock the rear door and passager door should remove the alarm good luck thans on using fixya

Mar 09, 2015 | 2000 Chrysler Grand Voyager

1 Answer

I have a Chrysler 300 2008 front door shows ajar and the inside light stays on


The door switch has failed / broken.
This is usually an easy fix, as long as you can find the switch. On my Grand Voyager, there is nothing obvious. If you cannot see any kind of plunger switch in the door shut (thats the frame the door closes into) then it is probably a part of the door loch mechanism. This might mean you have to buy a complete new door catch if I know chrysler, but if you are lucky, you may get the switch on its own.
The only thing I would say in the mean time though, take the bulb out of the interior light, or if you can, switch off the interior lights, because you will wake up to a flat battery every morning.

Mar 08, 2015 | Chrysler Cars & Trucks

2 Answers

Starter just spins after ignition wire replaces - no fire


Sounds like you have the starter wires hooked up wrong and to continuous power. If starter shuts off with the key now, but wont engage the motor, you may need shims so that the starter drive lines up with the motors fly wheel

Apr 09, 2014 | 1995 Chrysler LHS

1 Answer

My 2003 voyager front window wont open is there a fuse


I have a 2002 voyage and had a similar problem with windows not working and discovered that my ignition switch and key was the problem make sure your key when removing from ignition comes off at the correct position and everything will work if key is worn will come off from ignition at any point this will cause some windows not to open when inserted back in.hopes this helps.

Dec 29, 2010 | 2003 Chrysler Voyager

1 Answer

Minivan has no interior power or lights without key on


There are three possible situations I can think of. 1, there are usually switches on the main interior light that can be turned off to stop the lights from coming on when the door is opened unless the ignition is on. 2. There is a problem with the ECM or Alarm that was installed. 3. There is a fuse out. Check your fuses on the interior and under the hood of the vehicle.

Nov 20, 2009 | 1999 Chrysler Town & Country

Not finding what you are looking for?
2000 Chrysler Grand Voyager Logo

Related Topics:

267 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...