Question about 1994 Pontiac Bonneville

1 Answer

1994 bonniville 3800 engine problem cranking problem. installed feul pump,fuses. still want start. i am not a mechanic so please inform me

Posted by on

  • damuhammad58 Jul 22, 2010

    show me how to install the easier one

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 78 Answers

FIRST WE HAVE TO GO BASIC. THE MOST COMMON PROBLEMS ON THOSE MODELS WERE CRANK SENSORS AND IGNITION MODULES 99.9% OF THE TIME. U ARE NOT A MECHANIC SO ITS KIND OF DIFFICULT TO DIRECT U. THE IGNITION MODULE IS VERY EASY TO REPLACE BUT THE CRANK SENSOR IS A LITTLE MORE DIFFICULT. TELL ME THE DIRECTION U WOULD LIKE TO TAKE. I DONT WANT U TO GET DISCOURAGED

Posted on Jul 22, 2010

Testimonial: "show me how to install the ignition module"

  • 'G' Jul 22, 2010

    I DONT WANT U TO SPEND UNNECESSARY MONEY. CHECK TO SEE IF U HAVE FIRE OR FUEL FIRST. FUEL FIRST. IF U TURN THE KEY TO THE ON POSITION DO U HEAR A 3 SECOND HUM FROM THE BACK SEAT. AND IF U CAN GO TO AN AUTO PART STORE AND TELL THEM U NEED A SPARK TESTER. ITS ALOT SAFER THEN A SCREWDRIVER IN THE SPARKPLUG WIRE TRICK. ONCE WE HAVE FIGURED WHICH ONE U HAVE OR DONT WE CAN GO FROM THERE. HE IGNITON MODULE ISNT CHEAP. THE CANK SENSOR GOES FOR AROUND FORTY BUCKS

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

91 Geo tracker no feul to engine. Checked fuse. Feul pump rely is good but has no power to it.


Security light on? Turn the key on for ten minutes, off for thirty seconds. then try to start

Jan 31, 2015 | Geo Cars & Trucks

2 Answers

Feul problem


Lots of things could cause a no-start, Hendrik. Is your "Check Engine" light on? If so, please have someone get the OBD error codes from the car's computer.

Does it crank but not fire?

If it doesn't crank, check the battery condition, battery connections, ground connections to frame and engine block, starter solenoid, starter motor.

If it cranks, doublecheck your fuel pump installation. Make sure the new fuel pump is properly connected and properly electrically grounded. Look for a fuel pump fuse. Check for proper fuel pressure at the fuel rail, check the fuel flow rate. Check for spark, check or replace spark plugs, distributor cap, rotor, plug wires. Check valve timing, replace timing belt or chain if necessary. Check compression.

Aug 03, 2014 | 2001 Kia Sportage

1 Answer

Ingnitionfuse and relay checked its ok.fuelis not coming to injectors during crank .pls give a proper solution


the feul filter get a book and look were its located but it wouldnt be the ignition fuse it would be feul pump fuse when u turn the key in on position not starting the car youll hear the feul pump at the back of car kick on if u dont hear it replace the feul pump if it dose then its ur coils

May 17, 2013 | Cars & Trucks

6 Answers

Nissan NP200 bakkie is cranking , fuel is there but there is no spark, what else can i check?


Np200 has spark has feul but still wont start and the engine light is off any help please

Aug 31, 2011 | 2004 Nissan Altima

2 Answers

I think my starter is bad on my 1994 GMC Jimmy Vortec. I turn the key and it cranks but will not start. I CAN NOT find the starter on this vehicle in order to tap on it and see if that is the problem....


if it cranks the starter should be good. remove the air intake from the intake manifold. you need to spray starting fluid down the throttle body and see if it starts. the feul pumps go bad on these because of bad wiring. you probaly have a bad pump

Dec 26, 2009 | 1994 GMC Jimmy

1 Answer

I have a 2001 camaro with a 3800 v6 it cranks but wont start. no feul and the injectors are not firing. i can jump the feul pump relay and get feul pressure but the injectors will not fire.


The crank sensor is what pulses the ijectors,and makes the spark,so I would start at the crank sensor.Let me know how you come out.Check for any blown fuses also.Ecm fuse would cause this,but it may be called anything ,so check all fuses.

Sep 10, 2009 | 2001 Chevrolet Camaro

3 Answers

Moved my rx8 yesterday.i got ack in it this


verify condition by spraying some starter fuel in it.it should start and die if its a fuel problem.
if it still does nothing start checking any and all fuses.if all the fuses are good take out a spark plug and verify no spark.
if no spark check the ignition module.
it might be able to have it checked at autozone for free.but you will have to remove it.

Jun 12, 2009 | 2005 Mazda RX-8

Not finding what you are looking for?
1994 Pontiac Bonneville Logo

Related Topics:

404 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8825 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...