MY TURN SIGNAL IS NOT WORKING WHERE CAN I FIND THE FUSE OR RELAY

SOURCE: turn signals don't work

you should have a flasher for the turn signals as well as one for the hazard flashers turn signal flasher can be in fuse box on drivers side or mounted to steering column

SOURCE: turn signals wont work but flashers do

Hi.
On your 98 Dakota.
Is equipaded with a single Flasher.
If you replace all ready.
Check the FUSE # 10, 15 amp..
On the Fuse box. left side of Dash.
and the FUSE D 25, amp. On engine compartment Fuse box.
Check the proper funtion of the HAZARD switch.
Bacause if the Hazard switch is bad the turn signal don't will work. Match the OLD flasher with the New one.

If after of this still not work.
Remove the steering wheel cover, locate the Turn signal switch connector and with a TEST Light check power with the Key ON
12v. to the RED wire and PINK wire..
If you found 12v. check the connection with the switch.
If the connection is good. you will need to replace the turn signal switch.
But if you don't found 12v. You need to look a an open circuit.
And fix it..

I hope this help on your problem..
Thank you for use fixya...

Bill

• 424 Answers
• Posted on Feb 02, 2009

SOURCE: no turn signals

Check the multi function switch (turn signal/hazard) . Dirt gets in the contacts and causes your concern.Replace the multi function switch.

SOURCE: turn signals/hazards

replace turn signal switch.

SOURCE: turn signal problems

Most times the relay is in the fuse box or under the dash by the steering column.