Question about 2002 Dodge Ram Maxi

1 Answer

I have a 2002 Dodge Ram 1500 w/4.7L 98000 miles. When I start it up the rpms goes to 2000 and flucuates between 600 - 1500 rpms. When in drive the idle still flucuates between 500 -1000 rpms. Could this be the tps?

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 346 Answers

Idle Air Control Valve, most likely.

Is the check engine light on?

Posted on Jul 22, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

O/D Off light goes off and on


the overdrive is the 4th gear. considering that it may not be an issue with your computer switching gears to fourth but an issue with the transmission itself. this light could be a signal instead of and engine warning light where the engine is fine but the transmission isnt.

Sep 22, 2012 | 2003 Ford Windstar

1 Answer

2001 grand prix gtp rpm flucuating


Try this,pull the maf out ,if you look there is a hot wire going across the tube(maybe 2),if it has any white crusty stuff on it ,just use some spray throttle body cleaner to clean it up,even if you can't see it ,try it anyway!
Cleaning the MAF should be a part of every tuneup

Feb 13, 2012 | Pontiac Grand Prix Cars & Trucks

1 Answer

I have a 2002 Dodge Durango with 98000 miles on


it might even be more simpler than a sensor, have you checked the fluid in it recently? when the fliud gets hot it looses its viscosity thus as it gets warm it gets morry runny and thins out, and then the torque converter has trouble, try that first..i hope this is an auto lol

Feb 02, 2010 | 2001 Dodge Durango

1 Answer

My 2002 dodge ram starts with revolutions too high ( sometimes more than 2100 RPMs) I have already seen blue smoke coming out the exhaust pipes when the truck starts. after that truck idles fine at 600...


This sounds pretty normal since when you first start the truck the engine management system is probably in cold start mode by default. This will cause the engine to do what you are experiencing. It just takes a minute for the sensors on the engine to register with the computer and report on the parameters they are supposed to monitor. Please rate the helpfulness of my answer.

Dec 30, 2009 | Dodge Ram 1500 Cars & Trucks

1 Answer

When driving 50 mph and above the rpms flucuate 300 to 600 rpms also the cruise control kicks out when this happens


may have alternator problems cheak to make sure not over charging not over 14 amps under 12.7

Dec 16, 2009 | 2004 Chevrolet Cavalier

1 Answer

Masssive oil consumption


pan gasket on bottom of intake manifold may be leaking internally and causing oil consumption..remove air cleaner housing and open throttle plates and look for oil pooling inside manifold..if so..intakw ill have to be removed and all gaskets replaced

Mar 31, 2009 | 2000 Dodge Ram 1500 Truck

2 Answers

Transmission code P1740


The transmition is slipping, dodge trucks are noted for their tranny problems, I just replaced mine ($2400)bearly over 100,000 miles on the truck. Watch the engine temp if you keep driving it. It may start to over heat. Get it to a reputable transmition shop ASAP,Some place that garentees/warentees their work.
As for the heat/AC I would check for vacuum leaks. Get either a Hanes or Chilton's manual for it and it will tell you how to check the system.

Jan 19, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Engine stalls in drive after check engine light came on.


Have it sacnned for a code. it seems to be the speed sensor at the tranny.or the crankshaft position sensor. hope this helps. will you please vote ?

Dec 19, 2008 | 2007 Dodge Ram 1500 Quad Cab Sport

1 Answer

2002 dodge ram truck 5.9 engine


check if the fan works first,simple run a wire from the battery post positive to the positve wire on the fan if it starts then it works,next step clip the wires on the fan and conect the ground on good metal and the positive on ur fuse box,but not on any fuse,only on the fuse that turns on with the ignition,.

Sep 14, 2008 | 2000 Dodge Ram Maxi

Not finding what you are looking for?
2002 Dodge Ram Maxi Logo

Related Topics:

388 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

83054 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...