Question about 2003 Buick LeSabre

Open Question

2003 buick lesabre wont start!

So i replaced the left low beam bulb in my moms 2003 buick lesabre, and now it wont start. I replaced the bulb with the same part number except the wattage was 55 instead of 51, i didnt think this would be much of a problem other than it might draw more electrical power to run the bulb which could in worse case seniro blow something earlier in the circuit. the battery reads around 4-6volts connected in the car, but when i pull it out and test it reads 12? Something is drianing the power before the starter... I do not know this car at all. Could it be a relay somewhere? Is there something on the buick lesabre that is notorious for breaking? Any help would be great. Thanks and sorry about the spelling and gramar.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
cartersintn
  • 62 Answers

SOURCE: 1995 BUICK LESABRE WON'T START

bad fuel pump, or fuel fuse/relay check fuse or relay first

Posted on Sep 27, 2008

Ad
  • 32 Answers

SOURCE: where is the blower fan located on 2003 buick lesabre

try tightened the belt or check for rips then replace otherwise tighted should solve the problem

Posted on Dec 18, 2008

  • 1 Answer

SOURCE: 1993 Buick LeSabre wont turn over.T

try the starter

Posted on Apr 23, 2009

  • 55 Answers

SOURCE: Parking light burnt out

You should be able to get to it by removing the headlight

  1. Remove the headlamp fasteners.
  2. Using a pry bar, gently pry in the center area of the headlamp assembly. Pry the headlamp assembly straight forward in order to unsnap the headlamp ball stud from the ball stud socket.
  3. Slide the headlamp straight forward and disconnect the headlamp electrical connectors from the forward lamp wiring harness.
  4. Remove the headlamp from the vehicle.

Posted on May 04, 2009

yotaguy
  • 232 Answers

SOURCE: broken steering collumn 95 buick lesabre

Okay well here is your most likely problem,the nuetral safety switch it's located on the transaxle(transmission where the shift linkage comes in)you can test this to make sure its working but it will require conituity tester,a parts store might also test it for free,this is a $100+ dollar switch,so if needs to be replaced check with the local salvage yards to see if you can get one used.0ccdc81.gif

Posted on May 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The low beams on my 2006 buick lacrosse wont work the bulbs and fuses have been replaced but they still wont work


Shannon, you did not state if you checked for voltage at the fuse location-or better yet at the bulb location-
If a connection at the relay that feeds power to the low beams has come loose, then the low beams will stay out. Suggest that you locate the headlight relay (in a box under the hood) and verify that it is operating. If an assistant can operate the headlights while you listen (and feel) for relay operation, then you can eliminate that as an issue. Next would be the output of the relay (contacts could be bad) - and if you cannot open the relay to verify good contacts, then purchase a replacement relay (possibly from a junkyard) and plug that in.

Remember, the relay supplies the power to the headlights.
-Jim

Dec 15, 2011 | 2006 Buick LaCrosse

1 Answer

Need to replace drivers side low beam light. I see two bolts than when removed should release lamp module. But, it is not feels like there is a third I'm not seeing. Is this the case? How ho I remove the...


The bulbs in your car are replace from the back side. They are sealed units. The bulb will come as low and high beam built in one bulb. Go to an auto parts store and get the bulb first so you can see what you are looking for, there is a ring that holds the bulbs in the assembly. The ring will turn about a quarter turn and unlocked the bulb will then pull out from the rear and you can replace it. Hope this helps you out. Roger

Feb 07, 2010 | 2003 Buick LeSabre

1 Answer

How does one replace the low beam healdlight bulbs on a 1997 Buick LeSabre?


U have to go under the hood of the car an there should be the light bulb encasing that holds the bulb turn it to the right or the left it will come out .most newer cars low beam an high beam bulb are to gether as one bulb .

Nov 27, 2009 | 1997 Buick LeSabre

1 Answer

1988 buick century headlights


To change the low beam headlight on the 2001 Lesabre, the headlight assembly must first be removed from the car. It is really quite simple to do. There are two bolts on the top of the assembly that must be removed - that is all! The entire assembly comes out and gives easy access to the low beam bulb. Give it a 1/4 counterclockwise turn to remove it. Plus in the new one (#9006) and reverse the procedure.

Jun 19, 2009 | 1988 Buick Century

1 Answer

Left low beam headlight on Chrysler 2003 T&C wont work while engine is on


Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.

Apr 18, 2009 | 2003 Chrysler Town & Country

1 Answer

Relacing low beam bulb in 2006 Buick LeSabre


the headlight lens assemblies come out by just releasing two plastic retaining tab's under the hood, look closely u will ee them, then bulb replacement is a snap..

Mar 15, 2009 | 2006 Buick LeSabre

2 Answers

NO High Beams only Low Beams..


When I try to use the high beams on my 2003 buick century they will not stay on when I let go of the lever and when I do let go of the lever sometimes my headlights will all go out. I just gave up on using the high beams at all

Mar 02, 2009 | 2001 Buick Century

3 Answers

REPLACEMENT OF [LOW BEAM] HALOGEN BULB IN 2004 Buick LeSabre


I just Replaced a Low Beam Light bulb on a 2005 Buick La Sabre.

If You use a Metric socket and Remove the Two Silver bolts Attaching the headlight Assemble onto the metal surrounding the the lamp assembly it comes out to the front. This makes it much easier to access the bulb. Twist it counerclockwise & it comes out by pulling gently on the bulb. Then by realeasing a tab that is the socket holder bulb can be removed & replaced with a New #9006 low beam halogen light bulb. Wrap a Paper towel around the bulb & do NOT touch it with your bare hand as this wiil ruin a halogen bulb,

Jan 22, 2009 | 2004 Buick LeSabre

Not finding what you are looking for?
2003 Buick LeSabre Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...