Question about Cars & Trucks

1 Answer

2000 lincoln continental 3 airbags deployed frnt dash steering wheel and driver seat replaced all three but air bag lights still flashes please advise

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 6,826 Answers

I think that a scanner can clear the DTC (diagnostic trouble code).
It seems to me that if a problem is detected that the light will stay on to alert the driver until cleared.
General Information The supplemental restraint system was designed to provide increased protection in case of an accident for those in the front seat of the car, when used along with the safety belt system. The system MUST be disarmed before any work is performed on or around the supplemental air bag system. The system is an electronically controlled, mechanically operated system. The system contains two basic subsystems: the driver's side air bag module assembly and the passenger side air bag assembly, and the electrical system that connects them. The system consists of:

  • The crash sensors
  • The safing sensor
  • The air bag module(s)
  • The diagnostic monitor
  • The back-up power supply
  • The instrument cluster indicator
  • The sliding contacts (clock spring assembly)
The system is operates as follows: The system remains out of sight until activated in an accident that is determined to be the equivalent of hitting a parked car of the same size and weight at 28 mph (40 km/h) with the vehicle receiving severe front end damage. This determination is made by crash and safing sensors mounted on the vehicle which when a sufficient impact occurs, close their contacts completing the electrical circuit and inflating the air bags. When not activated the system is monitored by the air bag diagnostic monitor and system readiness is indicated by the lamp located on the instrument cluster. Any fault detected by the diagnostic monitor will illuminate the lamp and store a Diagnostic Trouble Code (DTC). Fig. 1: Air bag system component locations — 1990–91 vehicles 2000 lincoln continental 3 airbags deployed frnt - 84176001.gif
Fig. 2: Air bag system component locations — 1992–00 vehicles 84176002.gif
prev.gif next.gif

Posted on Jul 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I hit a deer didn't stop but car has head light out and needs bumper cover also has code 19 is 2000 Taurus we how do I turn out light for air bag?


The garage will turn it off when they fix the problems. You do it via the scanner. However, see the links

2007 Ford Taurus Airbag Light Code 19 - Taurus Car Club of America ...

www.taurusclub.com > ... > Maintenance and Repair
  1. Cached
  2. Similar
Jun 18, 2013 - 10 posts - ‎5 authors I have a 2007 Taurus that I have had for 3 years with no issues and all of a sudden the airbag light has started to flash a code 19. The car has not. Air bag light flashing code 19 - 2001 Tarus 5 posts 21 Jul 2013 Hit Deer At 55mph, Bag Code 19, Rcm Replace? 4 posts 16 Aug 2008 Airbag Code 19 7 posts 6 Jul 2008 2000 Taurus Airbag Flash Code 17 4 posts 10 Jan 2006 More results from www.taurusclub.com

2000 Taurus Airbag Code 19 - Ford Forums - Mustang Forum, Ford ...

www.fordforums.com/f138/2000-taurus-airbag-code-19-a-141036/
  1. Cached
Sep 29, 2006 - 2 posts - ‎2 authors My wife had a minor wreck and the drivers airbag deployed. The passenger side did not deploy even though there was and adult passenger. I replaced the wheel and airbag assembly but now I get the bag light flashing 19. Is this a passenger side sensor or passenger side airbag trouble code? Where do I ...

Code 19 - YouTube

2q==? 3:16 https://www.youtube.com/watch?v=t-d-EZvJR68 Dec 1, 2015 - Uploaded by Haley Cook HOW I RESET SOFT CODES ON FORD VEHICLES ABS, TRACTION CONTROL, ADVANCETRAC WITH OUT ...

how to fix ford air bag light on , most common issue code ... - YouTube

9k=? 2:27 https://www.youtube.com/watch?v=5Go_zoitzEI
  1. Similar
Jan 19, 2014 - Uploaded by beltstowing Published on Jan 19, 2014. THE AIR BAG SYSTEM IS A SELF DIAGNOSING SYSTEM , IF YOU COUNT THE ...
code 19 on 2000 Taurus Google Search


Dec 13, 2017 | Cars & Trucks

1 Answer

97 honda accord. Airbags on dash an steering wheel deployed. How do I repalce them and reset the system.


Get replacement airbag, and there is a electrical connector in the steering wheel, unplug old bag and plug new bag in. PLEASE disable the airbag system before doing this or new bag can deploy!
Then you should be able to mount bag and then rearm system

May 31, 2014 | Cars & Trucks

2 Answers

Airbag locations


In the steering wheel and passenger side dash.Due to the age of the vehicle probably doesn't have the curtain "side" airbags.The airbags were designed primarily for head on collisions. Here is some useful information to why the may have not deployed courtesy of http://www.asashop.org/autoinc/dec2001/collision.htm
How Air Bags Work To have a frontal (driver or passenger) air bag deploy, certain criteria must be met. One of these criteria is that the frontal impact must be within a 60-degree window, occurring within 30 degrees from the vehicle's centerline. Another key element is that the crash forces are equivalent to a head-on collision with an immovable barrier at 10-15 miles per hour. Because a typical automobile accident only lasts about 0.125 (1/8th) of a second, air bags deploy within 15 to 20ms after the initial crash impact. To create a protective cushion between the occupant and the vehicle's interior, the air bag inflates at speeds up to 200 mph within approximately 30ms after impact. This allows the occupant to contact a fully inflated bag within approximately 45 to 50ms after the initial crash impact. Approximately 100ms after impact the bag deflates.

May 30, 2010 | 2001 Buick LeSabre

2 Answers

The airbag indicator light flashes(3-blinks a pause then 2-blinks then repeats the sequence) at engine start then stays on after a minute or so


Code 32 on the airbag diagnostic circuit indicates a drivers side air bag wiring resistance out of range. This could be the connections on the clock spring in the steering or a loose connector to the air bag in the steering wheel. If you are not familure with the proper diagnostic proceedures I do not recomend attempting to repair it yourself. If the air bag circuit is not de-energized before removal there is a possibility of air bag deployment when removing it.

Nov 24, 2009 | 2000 Ford Explorer

1 Answer

2002 lincoln ls...front air bag indicator light stays on after flashing 3 times...sensor prob?...dai5190


You will have to get the airbag code read to be sure but I have had to replace the clockspring in my steering wheel and also the airbag wiring harness under the passenger seat on my 2002 Lincoln LS, all in less than one year. If you or someone you know can help you remove the seat you can do the wiring harness yourself, it is a simple clip.

Aug 01, 2009 | 2002 Lincoln LS

3 Answers

Airbag light stays on 2000 Lincoln LS


I hate to say this is one of the few times I recommend taking your car to the dealer. Messing with the airbag system could cause it to deploy in your face, which believe me is not a pleasant experience. If it does deploy, the cost of a replacement will come close to the book value of the car. The other alternative would be that whatever you did to the airbag would case it not to deploy when you most need it. In either of these situations you are much better off throwing a few bills at the dealer.

Jul 14, 2009 | 2000 Lincoln LS

2 Answers

Bmw 5 series 2.3L 2000 england how do i remove airbags from drivers side. i was told i would need a torx 30 to remove two bolts from behind steering wheel. my steering is a m5 wheel, and also how would...


to disable them,unplug the plugs after the battery has been disconnected for 2 minutes to avoid deployment. if you physically want to remove them,that is different,the one on the passenger side is part of the dash,a thin plastic line ruptures upon deployment and the airbag inflates.
the drivers airbag is disabled by the yellow connector at the bottom of the steering column

Jul 14, 2009 | 1999 BMW 323 Series

1 Answer

Airbag deployed


SECTION 501-20B: Occupant Restraints — Passive — Supplemental Air Bag System 2000 Villager Workshop Manual REMOVAL AND INSTALLATION Module —Driver Air Bag Removal
syv~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The backup power supply energy must be depleted before any air bag component service is performed. To deplete the backup power supply energy, disconnect the battery ground cable and wait three minutes.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again. If the vehicle was in a frontal collision and the air bag did not deploy, the air bag may not have been needed. Complete a diagnosis of the air bag system before installing a new driver side air bag module (043B13). Refer to Diagnosis and Testing in this section.
  1. Disconnect the battery ground cable (14301). For additional information, refer to Section 414-01 .
  1. Remove the two driver air bag module retaining bolt access covers (one shown).
  1. Remove the steering wheel bottom cover to access the driver air bag module electrical connector.
  1. Disconnect the driver air bag module electrical connector.
  1. syv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: After removing, discard the driver side air bag module bolts and install new driver air bag module bolts during installation.
    Remove the two driver air bag module retaining bolts (one shown) and discard.
  1. Remove the driver air bag module.
    1. Separate the driver air bag module from the steering wheel and disconnect the horn pad switch.
    1. Remove the driver air bag module.

Apr 16, 2009 | 2000 Nissan Quest

1 Answer

Remove d/s airbag


disconnect the battery, then find the air bag plug normally under the seat or around side of the seat, maybe under the carpet *bright orange cable*

once you have disconnected the battery and the cable start taking the steering wheel apart and remove it, after market steering wheel will be needed unless your just going to cut the air back out and re fit the wheel, do not connect the air bag cable, you will have a dash light on the dash for air bag doing this though.

Apr 10, 2009 | 2000 GMC Jimmy

1 Answer

Air bag light flashing


the most common cause of the airbag light is a defective rotoating ribbon contact under the steering wheel that connects the airbag to the steering column wiring harness, the contact is called the clock-spring contact.

Mar 31, 2009 | 2003 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...