Question about 1998 Ford Windstar

1 Answer

98 windstar I replaced fuel pump and filter and camshaft sensor and the van will run and drive for a minute and stall Fuel pressure is good, also i checked the relay and fuses but i lose spark so what other sensor controls the coil?I am going to change the crank sensor. Any other ideas would be helpful

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Sounds like you are on the right track with the crank sensor.

Posted on Jul 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 windstar stalls when driving, idles high in neutral, now 4 codes


ok so much done owell next is the mass air flow to be checked then the fuel regulator to check pressure and the fuel pump for pressure and then check the cat,s for back pressure wood be my next thing and Last is the how many Km,s does it Have ?sounds like filter needs lookin at in the tranny if she,s got High Km,s if not then check the intake for leaks it,s Plastic so don,t hurt gone this far Let me Know What Happens,s Thank,s

Apr 08, 2013 | 2003 Ford Windstar

1 Answer

2002 taurus 3.0L OHV stalls when hot have replaced IAC,camshaft position sensor,fuel pump and there are no codes on engine stall occurs most often when slowing and turning


If you have to wait to restart its usually a faulty coil or ignition module.
Someone would need to troubleshoot the ignition system when the engine fails to start to proceed. Could be a faulty relay too.

Sep 13, 2012 | 2002 Ford Taurus

1 Answer

95 ford windstar fuelmpump not pumping replaced it and still no start


Was the fuel pump new? When this much work is involved never use salvage parts. The fuel pump run function is interlocked with engine oil pressure sensor to indicate engine is running. On initial startup the fuel pump run is momentary to prime the injectors. Your problem is probably the oil pressure sensor or sending unit

Jun 15, 2017 | 1995 Ford Windstar

1 Answer

Winstar stalls


check fuel filter fuel pump pressure

Feb 03, 2012 | 2003 Ford Windstar

1 Answer

1998 park avenue cuts off sometimes i let it for a few minutes cut right back on i think its the fuel pump


CHECK FUEL PRESSURE SOON AS ENGINE STALL OUT.IF FUEL PRESSURE SHOULD BE 41 - 47 PSI. IF NOT OR PRESSURE ZERO OR LOWER FUEL PUMP FAULTY.FIRST REPLACE FUEL PUMP RELAY AND CHANGE FUEL FILTER SEE IF ENGINE STILL STALL OUT.IF FUEL PRESSURE OKAY HAVE CAR CODE SCAN FOR FAULTY CRANKSHAFT SENSOR OR FAULTY CAMSHAFT SENSOR.

Mar 30, 2011 | 1998 Buick Park Avenue

1 Answer

1993 satro van stalls when starting. runs about 5 seconds then stalls. takes between 5 and 10 times then it will run and will stall once in a while while driving. I put my ear to the gas tank and could...


Start with the simple and replace the fuel filter, a dirty fuel filter will also cause what you have described and a ICM (ignition control module) going bad will also do the same.

You can remove your ICM and have it tested free of charge at Auto Zone or Parts Source when you go and pick up the fuel filter. A bad ICM will cause your engine to stall out and eventually fail totally and your going to have a no engine run situation.

Be safe and thank you for using fixya

Sep 18, 2010 | 1993 Chevrolet Astro

2 Answers

Van stalls intermittently. When we take it to a garage, they let it idle for an hour and it won't stall. We have already replaced fuel pump.


did they check that the filter was clean if filter is partly chocked itl allow enough for tick over but starv the engine with open thottle

Jul 07, 2010 | 2000 Ford Windstar

2 Answers

Engine will crank but will not start and run.


Change the fuel filter first! It is located on most models passenger side center to rear center of van & tucked up near frame rail. Good luck!

Dec 01, 2009 | 1999 Ford Windstar

2 Answers

325i BMW, 2003 (Automatic) Fuel Pump/Filter or fuel pressure regulator problem? 3 weeks ago car would stall when shifted in Drive mode. After a couple of retries it would pull away. 500 feet later would...


put your BMW on a diagnostic machine,it will be cheaper in the long run.Believe me I own one and would not have any other car.My 98 just had a problem I parked it the next day it would start but not run,I had it put on a diagnostic machine found out the MAF sensor was bad,got one from the junk yard for $125 and the car runs fine again.

Jul 25, 2009 | 1996 BMW 318

Not finding what you are looking for?
1998 Ford Windstar Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5610 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...