Question about 1993 Honda Accord

Open Question

Which is the diameter of the exhaust pipe honda accord 1993?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 217 Answers

SOURCE: 1993 Honda Accord VSS replacement

Chiltons guide. It can be purchased at most all auto parts stores. It has everything about your vehicle from the ground up and front to back.

Posted on Jul 11, 2008

Ad
  • 1 Answer

SOURCE: Rear speaker size in my 1993 Honda Accord

I HAVE A 93 ACCORD LX AND ACCORDING TO HONDA MINDS COME WITH 6.5" SPEAKERS FOR THE BACK AND TO GET 6X9 IN YOUR GOING TO EITHER GET THE SPACER THE COME WITH THE EX OR YOU OR GOING TO HAVE TO CUT AND THEY DONT RECOMMAND IT CAUSE YOUR TRUNK WONT STAY OPEN AND YOUR GOING TO HAVE TO BEND THE BAR UNDER THE TRUNK. HOPE YHIS WAS HELPFUL.

Posted on Dec 23, 2008

  • 176 Answers

SOURCE: 1993 Honda Accord, needs cruise control on to start

i think that is a anti theft system for your car

to start you have to push the cruise button

other system are wired on the defrost to start car

if the car run ok it is just a anti theft system

Posted on Jul 16, 2009

thunderalley
  • 432 Answers

SOURCE: 1993 honda accord ex won't pass smog check. what

bad o2 sensor or clogged catalytic converter, several items

Posted on Sep 24, 2009

Ford Guroo
  • 71 Answers

SOURCE: what can i do to make my 1995 Honda Accord stop thick exhaust

That is caused from your valve seals. These seals slide over the valve stem and keep oil from getting into the cylinder. The reason that it stops after it warms is because these seals are rubber and when they heat up they are soft again as they are from the factory. When they are cold and have a lot of age on them they become brittle and hard. That is usually not to expensive of a job to do. Just depends what part of the US you live in. My daughter had a 93 Accord and I bought the seals for 35.00 and replaced the my self but I have been working on vehicles for 30 years. That job requires special tools. Hope this helped.

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Smells like raw gas I think the mechanic did not set the timing correct also waste more gas


raw where,
tail pipe
or injectors leaking on top of intake
or dripping for exhaust flanges.
or just black smoke, tell more get more.
im done, all 60days honda, done. no empty slots.
my anwers are for you and others that know how to search/

Sep 07, 2013 | 1993 Honda Accord

1 Answer

1993 honda accord acts like running out of gas step on gas pedal and it runs ok for about .5 mile does it again


check for plugged exhaust system, it could be that a pipe has collapsed or the catalytic converter may be plugged up. check back pressure at the o2 sensor ( req' special tool) or drill small hole in exhaust system just ahead of the converter and use heavy duty fuel pressure gauge. Reading should be no more than 2 1/2 psi. If pressure is greater install new exhaust system starting w/ converter. If back pressure is ok, check fuel pressure and go by book specks. P.S make sure to weld up hole in exhaust after back pressure test. If converter and rest of exhaust checks out.

Apr 18, 2013 | 1991 Honda Accord

1 Answer

I have a 1993 honda accord that will start but won't stay cranked...what's wrong?


A few things to check:

Wrong spark plugs installed - causing too many misfires
Timing problem - the ECC (Engine Control Computer) will give up after a short while if it cannot get the engine to operate in correct time
clogged fuel filter
clogged air filter
clogged fuel strainer
worn distributor cap/rotor
failing fuel pump
vacuum leak
faulty ECC (Engine Control Computer)
ignition coil failing - the ECC will stall the engine if too many misfires are detected.
wireset - faulty spark plug wire(s) causing too many misfires.
faulty fuel pressure regulator
EGR valve faulty

If the engine is misfiring alot, it will **** the resulting unburned fuel out the exhaust pipe, so check for this as well.

Nov 27, 2011 | Cars & Trucks

1 Answer

When parking ..the engine run smooth..but so rough on stop...D gear in? 1993 honda accord


its running weak and the to find the fault you will have to check the vacumn pipes that are connected to the inlet manifold for deterioration and splitting

Mar 08, 2011 | 1993 Honda Accord

1 Answer

I want to replace the oxygen sensor in my 1993 honda accord ex, where is this located and does it need special tools


it is located at the exhaust pipe before the catalyt converter. No special tool required, normal spanner will do, make sure the exhaust pipe is not hot...disconnect the electrical cable connected to the sensor first. Spray WD 40 or lubrication to the thread before unscrew the sensor.

Jun 04, 2010 | 1993 Honda Accord

2 Answers

Where is the oxygen sensor located in a 1991 honda accord


1991 Honda Accord 2.2L FI 4cyl
The Oxygen Sensor is located under hood, driver side, rear engine area, below exhaust manifold flange, mounted in exhaust pipe.
Application: EX model

Good luck.

Mar 16, 2010 | 1991 Honda Accord

2 Answers

Where can I locate the O2 sensor on a 1992 Honda Accord? I have a new one I need to install to pass emissions.


the ex, lx, dx model are located on the exhaust manifold
the exr, special edition models are located on the down pipe by
the flex pipe

Oct 26, 2009 | 1992 Honda Accord

1 Answer

Need to replace 02 sensor bank1 sensor 2


Bank 1 is the O2 sensor on the exhaust manifold just about where the exhaust pipe connects to the exhaust manifold.

Jun 01, 2009 | 2003 Honda Accord

2 Answers

Where is the o2 sensor located on a 1991 honda accord ex 2.2 engine


Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.

Jul 12, 2008 | 1991 Honda Accord

Not finding what you are looking for?
1993 Honda Accord Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...