Question about 2002 Chevrolet Suburban

Open Question

2002 Suburban rear glass will not open. The push button will not engage the latch. I need a diagram to see whether or not something is broken or missing.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 686 Answers

SOURCE: Need Diagram 93 suburban rear brake shoe springs

make sure your star wheel is moving freely. usually located at the bottom betwwen the shoes that's your adjuster and when it seizes up then you lose adjust

Posted on Feb 23, 2009

Ad
dennymulford
  • 1055 Answers

SOURCE: 98 K1500 suburban, can not engage 4wd, HI or Lo runs otherwise

your doing it right but your accuater is bad 59.00 auto zone easy install

Posted on Feb 23, 2009

  • 93 Answers

SOURCE: 2002 Explorer rear liftage latch replacement

Liftgate Latch Remote Control Removal and Installation

  1. Remove the liftgate trim panel. For additional information, refer to Section 501-05.
  1. Remove the watershield.
  1. Disconnect the actuator electrical connectors.
    a0023946.gif
  1. Disconnect the liftgate window glass latch release cable.
    1. Release the cable conduit.
    1. Disconnect the cable.
    a0023921.gif
  1. Disconnect the liftgate latch release cable.
    1. Remove the cable conduit.
    1. Disconnect the cable.
    a0023919.gif
  1. Release the exterior liftgate release handle actuating rod.
    1. Open the clip.
    1. Release the rod.
    a0023942.gif
  1. Remove the bolts and the liftgate latch remote control.
    a0023922.gif
  1. To install, reverse the removal procedure.
    • Transfer parts as necessary.

Posted on Jun 02, 2009

  • 1 Answer

SOURCE: 2002 camry - Need to replace broken console lid

Solved it. Found a small shank screwdriver that fitted into the opening with a little bending of the plastic frame. managed to replace it with a new one without trouble. No further help needed. dave

Posted on Nov 09, 2009

  • 540 Answers

SOURCE: Can't open 94 Suburban hood. Latch is no longer

you can open it with a long thin screwdriver. Look thru the center top of the grill. You should be able to see the cable running to the latch. Follow the cable to the end and you should be able to get in there with the screw driver and fish around to get it to unlatch. After you get it open you can tie a piece of wire to the latch sticking out of the grill to pull on and release it till you can get it repaired. Most likely the cable or pull handle is broken

Posted on Dec 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear hatch glass not open


try lubing it up and not with wd buy good penetrating fluid like kleen flow

Nov 23, 2013 | Mercury Mountaineer Cars & Trucks

1 Answer

2008 suburban Stuck Lift Gate Lock


I have a 2008 Suburban with the power liftgate disabled. I have had the power latch stop working, and the BCM report that the rear access open when it is closed (both gate and glass). Somehow the liftgate module thinks the gate is open, so I cannot open the gate at all, and the latch and rear wiper will not work. To reset the control module I pulled the liftgate fuse (#20) in the instrument panel fuse box, turned the car on, off, reinstalled fuse, turned car on, unlocked doors using drivers side switch, and the power latch will function again - at least for a while.

Jun 05, 2013 | 2008 Chevrolet Suburban

1 Answer

1986 suburban cargo door window replacement


Since you have a the original rubber seal from your broken glass, cut the seal from the outer edge of the replacement glass and just push it out of the remainder of the rubber. With the original rubber still in the opening on the one your putting it in, lay a strong string from top corner, inside the space where the glass goes, and across the bottom. Push the glass into the seal on opposite side from the string side as much in as possible and begin to pull the string straight out while holding the glass in and this will pull the rest of the outer rubber lip to the outside of the glass and your done. Just a little trick I learned in my youth that I've used many times.

Aug 29, 2017 | 2003 Renault Renault Scenic 1.6

1 Answer

When i use the key fob to lock the doors the back glass dont lock, ???????


This solution applies to models:
2002-2007 Chevrolet Trailblazer, Trailblazer EXT and Trailblazer SS
2004-2007 Buick Rainier
2002-2007 GMC Envoy, Envoy XL, and Envoy Denali
2002-2004 Oldsmobile Bravada
2005-2007 Saab 9-7x

Condition/Concern:
Rear liftgate glass will not lock when using the key fob or door switch unless the lock button is pressed a second time. All other doors will lock normally. This could be the result of the liftgate glass lock rod not adjusted correctly. This lock rod travels from the liftgate lock actuator to the glass release push-button cylinder.

Recommendation/Instructions:
Remove the inside rear liftgate trim panel. Disconnect the threaded lock rod clip at the end of the push-button glass release and rotate this clip 1 complete turn at a time making the lock rod longer. This will be the only threaded lock rod visible when the trim panel is removed and the liftgate is raised.
Note: For the rear glass to release, the rear liftgate latch must be in the closed position. For test purposes only, this latch can be made closed to make this lock rod adjustment.

Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

Apr 25, 2010 | 2006 Chevrolet Trailblazer

1 Answer

From rear-left side latches engaged-can't fasten


it will be a little difficult now, but you need to take a screw driver or something to pry on the left to unlatch and start over and do it the right way :)

Mar 11, 2010 | 2001 Chevrolet Suburban

1 Answer

95 suburban drivers side rear door won't open. top latch releases but bottom stays engaged


push at top of the stuck door and then at same time pull lever and the door should open, mine does that.

Dec 29, 2009 | 1995 GMC Suburban

1 Answer

2005 Suburban Liftgate will not open


HAVE A FRIEND PUSH ON THE GLASS WHEN YOU TRY TO OPEN IT THE NEXT TIME. THE LATCH INSIDE IS LOOSE AND NEEDS TO BE TIGHTENED. BY PUSHING ON THE HANDLE IN THE GLASS DOOR YOU CAN RELIEVE THE PRESSURE FROM THE LOCK AND OPEN IT THEN LOOK ON THE UNDERSIDE OF THE HANDLE IN THE GLASS THERE IS A SMALL METAL PEG WITH A NUT AT THE BOTTOM I THINK IT 7/16 OR SOMETHING LIKE THAT. TIGHTEN IT UP AND YOURE ON YOUR WAY

JAMESFWALKERJR2006@YAHOO.COM

Aug 25, 2009 | 2008 Chevrolet Suburban

1 Answer

2002 Explorer rear liftage latch replacement


Liftgate Latch Remote Control Removal and Installation
  1. Remove the liftgate trim panel. For additional information, refer to Section 501-05.
  1. Remove the watershield.
  1. Disconnect the actuator electrical connectors.
    a0023946.gif
  1. Disconnect the liftgate window glass latch release cable.
    1. Release the cable conduit.
    1. Disconnect the cable.
    a0023921.gif
  1. Disconnect the liftgate latch release cable.
    1. Remove the cable conduit.
    1. Disconnect the cable.
    a0023919.gif
  1. Release the exterior liftgate release handle actuating rod.
    1. Open the clip.
    1. Release the rod.
    a0023942.gif
  1. Remove the bolts and the liftgate latch remote control.
    a0023922.gif
  1. To install, reverse the removal procedure.
    • Transfer parts as necessary.

Jun 01, 2009 | 2002 Ford Explorer

3 Answers

2002 Jeep Liberty, rear window latch is ''locked'' & window is open


i was having the same type of problem. we just put a couple of washers behind the latch and then adjusted the latch and it solved our problem.

Nov 16, 2008 | 2002 Jeep Liberty

1 Answer

2004 trailblazer rear pushbutton for the rear glass went in and STUCK. It's still STUCK. The window will not open. The button will not pop out. I tried oil. I tried the emergency latch access at the...


I have the same problem all the time. Dirt gets caked in mine and gets stuck. I usually just pound on it or slam it shut several times to knock the dirt loose. Be rough with it.

Jul 31, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

679 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...