Question about 2001 Kia Sportage

1 Answer

How do u replace a fan clutch on a kia sportage

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 6,927 Answers

Just leave the belts on the engine and use a open end wrench,I think a 10 mm,might be a 8 mm,and use another wrench to hold one of the nuts,and loosen all the nuts,then remove them by hand.Of course the fan shroud needs to be removed at the same time you lift the fan and fan clutch up,and out of the vehicle.Then just unbolt the fan from the fan clutch,install in reverse order.If this was at all helpful,please rate,thank you.

Posted on Jul 20, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
c17hydro
  • 2984 Answers

SOURCE: 1999 kia sportage timing marks

dfd3ea1.gif Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks
9f1c7ef.gif

  1. Align marks on camshaft pulleys with alignment marks on seal plate.
  2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
  3. Loosen tensioner lock bolt.
  4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
  5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
  6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
  7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
  8. NOTE: Replace tensioner spring if timing belt deflection is excessive.
Timing Belt Installation


eb770f2.gif
  1. Install lower timing belt cover.
  2. Install upper timing belt cover.
  3. Install power steering drive belt and adjust belt tension.
  4. Install fan pulley.
  5. Install generator drive belt and adjust belt tension.
  6. Install A/C drive belt and adjust belt tension.
  7. Install splash guard.
  8. Install fan and fan shroud.
  9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
  10. Install fan shroud mounting bolts.
  11. Install fresh air duct.
  12. Connect hose to resonance chamber.
  13. Connect battery negative cable.

Posted on Jul 26, 2009

  • 250 Answers

SOURCE: 199 kia sportage heater blower motor stops then

a bad earth or chaffed wire

Posted on Aug 15, 2009

  • 14036 Answers

SOURCE: 2005 Kia Sportage serpentine belt

YOU NEED THE BELT TENSIONER TOOL ITS FITS IN THE SQUARE SLOTS IN THE TENSIONER.YOU ROTATE TENSIONER CLOCKWISE TO REMOVE BELT.

Posted on Aug 23, 2009

  • 145 Answers

SOURCE: 1997 kia sportage

The clutch is a fluid clutch. The only adjustment is to make sure the fluid is full. The ones I have worked on use a combined resoveir that holds brake fluid for both the brakes and the clutch system. So check the fluid in your master cylinder.

Posted on Feb 22, 2010

  • 55 Answers

SOURCE: Replaced blower motor in my 2001 kia sportage ex,

It could be the blower motor resistor, the high position feeds full 12 volt power directly to the blower motor. All lower settings route through the blower motor resistor. It is usually located under the passenger side dash, not far from the blower motor. Two screws secure it to the heater box.

Posted on Mar 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Kia spotage get hot when setting still


you might need to replace the fan clutch or your thermostat. The fan may not be spinning hard enough to cool the motor or spinning at all, lift the hood turn the car on and see if the fan is coming on.

Aug 14, 2010 | 2000 Kia Sportage

2 Answers

KIA SPORTAGE 2001 OVERHEATING WHILE IDILING


Visco fan or termostat problem. Fan not working 100% or stuck termostat

Mar 26, 2010 | 2001 Kia Sportage

1 Answer

2000 kia sportage engine fan not turning on


I assume all the belts are on the vehicle, alternator, power steering,etc. If so than you have a bad fan clutch and it time for a new fan.

Jan 14, 2010 | 2000 Kia Sportage

2 Answers

KIA sportage 2001 overheating with a/c on .. No electric fan???


There should be a electric fan. Watch your temperature while it runs and when it gets up to around operating temperature the fan should kick in and run.

Aug 01, 2009 | 2001 Kia Sportage

1 Answer

The fan is running in the same speed as the engine Sportage 2001


you need a repair manual.to get you started you going have to remove top radiator hose.you also have to remove clutch and fan as a assembly from water pump.you going have to remove fan shroud with clutch and fan as a assembly to make it easy to get out.once you remove fan and clutch.you have to remove clutch from fan.in order to put on a new one.

Jul 19, 2009 | 2000 Kia Sportage

1 Answer

2001 kia sportage radiator fan fuse located


your fan prolly don't have a fuse as it is a clutch fan. Doesn't require fuses i think...

Jul 11, 2009 | 2001 Kia Sportage

1 Answer

Need to replace fan cluch


the radiator fan is mounted to the clutch, in other words remove the bolts / nuts that is holding the fan assembly to the water pump usually just four nuts once you pull the fan assembly the part that yo seperated from the water pump is the clutch, now remove the fan blades and mount thm on the new clutch assembly the piece which mounts tt the water ump is the fan clutch

Jul 10, 2009 | 2000 Kia Sportage

3 Answers

2001 Kia Sportage fuse 4 radiator fan?


Radiator fan fuse is fuse # 5 (40 amp/Green) located behind the interior fuse access panel on the left side of the instrument panel next to the steering column. Also, in the underhood Power distribution center, next to the air cleaner filter are two black fan relays: high speed (F) at the far left, second row down and a low speed, 1st one to the right on the bottom row.

Jun 16, 2009 | 2001 Kia Sportage

1 Answer

1999 Kia Sportage overheating issue


check fuse and relay for fan switch. replace both if needed. real cheap fix.

Apr 21, 2009 | 1999 Kia Sephia

Not finding what you are looking for?
2001 Kia Sportage Logo

1,914 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Marvin
Marvin

Level 3 Expert

83096 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...