Question about 2003 Chrysler Town & Country

1 Answer

To start with, the motor started missing very badly. We took it to an auto repair and had it put on a computer. The mechanic said it showed a bad battery. A new battery was installed and it ran good for a day and a half. The next morning, it was back to the same thing. It was taken back to the mechanic and they finally said it was the computer. We ordered a refurbished computer off line and when installed, it did the same thing. Is this computer bad also?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Make sure your alternator isnt faulty first if you haven't already. A faulty alternator can intermittently produce sufficient voltage, but cause the symptoms you describe. A new battery seems to 'fix' it but when the battery is drained(because the faulty alternator is unable to keep it charged) ...the symptoms return. Good Luck

Posted on Jul 20, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 sebring 2.4L - car runs smooth, but idles rough intermittently.. not bad in neutral. but worse when in drive a stop, and very bad in reverse backing out.


Hey Miles ,did you get any codes from computer ? with car off put key in ignition and turn it off and on 3 times fast without starting motor and stop with key on ,that will activate on board diagnostic watch where speedometer millage counter is it will show codes ,example =P0442
when you see them wright them down ,when all codes have been retrieved dash will say DONE that's a start. most part stores can tell you what codes mean. I hope this helped if it did please check box below (helpful), thanks Woody.

Oct 12, 2014 | Chrysler Sebring Cars & Trucks

1 Answer

Ford F650 6.0 Nightmare!! Won't start, error code 221 Internal sensor voltage supply. fault mode Id:4 voltage below normal or shorted out! Help


Modern electrical issues can only be resolved only after all connections have been determined as clean, dry, and tight. Corrosion can cause voltage drops that will affect sensitive sensors and relays, that will prevent your vehicle from starting. Loose connections and especially an entire fuse box being loose will definitely be part of the problem. Repairs to this need to be done to continue diagnosis.

Jun 14, 2014 | 2007 Ford F-650

1 Answer

1998 Cadillac Catera missing


I'm not a mechanic but from experience I suggest that before you start with repairs, start with the fuel. You may have either picked up some dirty gas when last filled up or just stirred something up in the tank. Try a fuel cleaner from any auto parts store. Also, and this is probably not realated, the check engine light may come on if your gas cap is not tight. Good Luck

Dec 02, 2012 | 1998 Cadillac Catera

2 Answers

1999 chevy silverado miss firing


When you change the crank sensor you need a scan tool to set them.The distributor has to be turned using a scan tool to get the crank sensor dialed in.

Jan 09, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

1998 ford explorer runs ruff sometimes usually when first started took it to the dealer they replaced map sensor cleaned the fuel system and replaced the thermostat stll misses now they say computer module...


if fuel filter has more than 50,000 miles on it change that first, then take it to auto zone for a second opinion on comp. module. it may even be a bad coil pack.

Jul 09, 2011 | 1998 Ford Explorer

2 Answers

04' Ram 1500, bad mis-fire. cust repl s/plugs. no help. Codes for coils #7 & 8 w/mis-fire. replaced coils & wire set. Better, but still P0300. Compression good


You still have random misfires (PO300)
You most likely replaced those coils that set a code, and those were not the one bad offender,spiking the computer module.
Take a new coil and put in a cylinder,no change, replace old coil and move new one to next cylinder. You can do that once or twice a day, if you have nothing else to do. You need a 90 degree day, to really get that solved,unless you have an ignition oscilloscope.
Never had a bad spark plug in 45 years.

Sep 18, 2010 | 2004 Dodge Ram 1500

1 Answer

Missing in every gear..


you have to see if the coil pack fire up do you have spark coming out of the coil pack cylinder 2 never mind the other code the missing cylinder make the other sensor malfonction check if you have spark coming out of the coil pack if not change the coil pack if you have you spark check the compression let me know pierre please dont rate right away we work together to fix our problem because i whant you to get our car running good and i whant a fixya anything else is bad for me thanks pierre

Feb 25, 2009 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
2003 Chrysler Town & Country Logo

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

83081 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...