Question about 1999 Chrysler Town & Country

Open Question

How to change a water pump on a 99 chrysler town and country lx 3.8

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
garyq1970
  • 85 Answers

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Posted on Aug 24, 2008

Ad
  • 76 Answers

SOURCE: 2002 Chrysler Town and Country

Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug

Posted on Nov 18, 2008

bunnydawg
  • 5158 Answers

SOURCE: Water Pump 2005 Chrysler Town & Country 3.8

best and easiest is to go to the library and look for a chilton or other such repair manual. other then that most automotive box stores sell them.

Robert

Posted on Dec 16, 2008

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

  • 299 Answers

SOURCE: Estimated cost to have the shop replace water pump

Approx $450.00

Posted on Jun 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What bolt size does a 98 Chrysler Town And Country LX 3.8l take for the coal pack. I have1 bolt on it need 3 more.


The 1998 Chrysler Town & Country does not operate on coal. It has a gasoline engine. There is no "coal pack."

Aug 24, 2014 | 1998 Chrysler Town & Country

1 Answer

What size belt do i need to bypass ac compressor o a 99 chrysler town & country?


I wouldn't because you need the defrost to work while in Rain with windows up or in the winter. Good luck with finding measurement for mini-van. Not many people void them.

Jul 12, 2014 | 1999 Chrysler Town & Country

2 Answers

2006 Town and Country began whining noise up front, which kept pace with the motor; reved up moter, highr pitch whine. Power steering fluid is adequate, but circulating in resevoir. Is this normal?


ok the serpentine belt had to be replace every 20 000 to 25 000 miles the tensioner had a limit if it reach tha point the brlt is loose beter replace it

Dec 16, 2010 | 2007 Chrysler Town & Country LX New Cars

1 Answer

1998 chrysler town and country coolant pouring out...


Check for leak at the coolant tube that runs under the intake, possible bad o-ring, the intake will need to come of for inspection and repairs.

Jan 22, 2010 | 1998 Chrysler Town & Country

1 Answer

I have a 1997 chrysler town and country lx my


If the cable is not broke at the hood release handle check at the grill but look closely the other end may have come off its position not allowing it to unlatch. I worked on one that it happened to.

Nov 29, 2009 | 2007 Chrysler Town & Country LX New Cars

1 Answer

Washer bottle motor 1998 chrysler grand voyager 3.3 LX


should be located at the bottom attch to bottle follow the plug wire for washer motor and u will see and u will see

Jul 01, 2009 | 1998 Chrysler Town & Country

1 Answer

Town & Country 2007 LX model aircondition not working


It does have air conditioning installed. It may also have rear a/c. The rear a/c evaporator is probably leaking freon. I have replaced many rear evaporators on 2006 and 2007 Chrysler minivans as a result of a design change in 2006. Recharge the a/c and add dye to the system. If it has rear air, look behind the right rear wheel in the fender area under the car where the a/c lines go into the body.

Apr 21, 2009 | 2007 Chrysler Town & Country LX New Cars

Not finding what you are looking for?
1999 Chrysler Town & Country Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...