Question about 1999 Ford Windstar

1 Answer

Need fusebox diagram for 1999 Ford Windstar SE

Bought used 1999 Ford Windstar SE with no owner's manual have electronic problems i.e. sliding door not opening certain times, interior lights working then not. Just need fusebox diagram for 1999 Ford Windstar SE so can see which corresponds where.

Posted by on

  • Anonymous Mar 14, 2014

    what fuse do I need for the radio in a 1999 Ford Escort SE?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 80 Answers



need fusebox diagram for 1999 Ford Windstar SE - ef07f16.gif 342512b.gif


4cdb386.gif


58765ab.gif


Hope this helps.. :-)

Posted on Jul 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the interior light relay on 2001 ford windstar


Your interior lights are controlled by the GEM - generic electronic module !
Battery Saver The battery saver relay is controlled by the generic electronic module (GEM) and is located in the fuse junction panel. The battery saver relay is designed to supply B+ voltage to the following:
  • dome and map lamp switches
  • visor lamps
  • glove box lamp switch
  • interior lamp switch
  • interior courtesy lamp relay
  • delayed accessory relay
The function of the battery saver relay is to prevent excessive battery drain by interior lighting circuits. The GEM supplies a ground signal to the battery saver relay anytime one of the wake-up inputs of the GEM is activated to operate the battery saver relay. A wake-up command is sent when:
  • any door becomes ajar or is opened or closed.
  • the ignition key is inserted or removed.
  • the ignition switch is turned from OFF to RUN.
  • the ignition switch is turned from OFF to ACC.
  • a wake-up request is received from the remote anti-theft personality (RAP) module (if equipped).
  • The GEM will maintain the ground input with ignition in RUN or for 40 minutes from the last input activation with ignition in the OFF position. After 40 minutes the ground signal is discontinued.
This de-engergizes the battery saver relay preventing B+ voltage supply to the controlled switches and circuits.
  • Courtesy Lamp On Continuously
  • Short to power.
  • Damaged switch.
  • Generic electronic module.
  • GO to Pinpoint Test AF .
PINPOINT TEST AF: COURTESY LAMPS ON CONTINUOUSLY AF1 PRELIMINARY CHECKS
  • Check connections for clean tight fit.
  • Check for loose or damaged wires.
Do components and wiring check OK? Yes No GO to AF2 . SERVICE or REPLACE as required. GO to AF2 . AF2 CHECK CIRCUIT 53 (BK/LB)
  • Remove interior lamp relay.
  • Measure voltage at interior lamp relay connector Pin 87, Circuit 53 (BK/LB).
Is voltage greater than 0 volts? Yes No SERVICE Circuit 53 (BK/LB) for short to B+. RESTORE vehicle. RETEST system. GO to AF3 . AF3 CHECK CIRCUIT 434 (LB/BK)
  • Measure resistance between interior lamp relay connector Pin 85, Circuit 434 (LB/BK) and ground.
Is resistance 5 ohms or less? Yes No SERVICE Circuit 434 (LB/BK) for short to ground. RESTORE vehicle. RETEST system. REPLACE interior lamp relay. RESTORE vehicle. RETEST system. Interior lamp relay is located in the Instrument panel fuse box .
I/P Fuse Panel (Located Below Driver's Side of I/P )

Feb 28, 2015 | 2001 Ford Windstar

1 Answer

My 1999 Ford Windstar keeps lockng the doors and blinking the interior lights while driving.


You need the dealer to scan the Body control module while this is happening, i think you have a defective door ajar switch here.

Jun 12, 2012 | 2000 Ford Windstar

2 Answers

Interior lights stay on and car chimes when car is off ford windstar 1997


On certain model the dimmer is also control the inside light.
MOVE the dash dimmer control dial from the extreme right to the middle position. (counter clockwise)

======
Clean the metal contacts on the side sliding door.
You may find white lithium grease on the surface.......do you best to wipe these contact clean.
Do the same on the rear hatch contacts.
====
Both front doors has plastic pin switches.

Check one door at a time to make sure the plastic pin switch is good condition.
Press the switch in and see does it operate smoothly.

Aug 10, 2011 | 1996 Ford Windstar

1 Answer

We have a trans sport se 1994 model. A light that looks like a miniature version of the van shows up on left side of dash near where the tail gate ajar warning would show up. The battery has run completely...


A quick guess is that one of the power sliding doors is not closing properly or the switch for that door is broken. A broken door switch would leave the door motor or interior lights on continuously and drain the battery. Draining the battery more than a few times would ruin it. Also check the front door switches for broken or missing actuators - the door ajar icon looks similar to the sliding door open icon.

I tried to download an owner's manual so I could be sure I was interpreting your dashboard icon correctly, but the oldest one available is for 1999, so my information may not be accurate.

Jan 17, 2011 | 1994 Pontiac Trans Sport

1 Answer

Interior lights stay on after doors closed.


Had same problem with my 98 windstar. I checked all the doors to see which door it was and found it was the sliding door. I try w40 did not work i guess sensors were to worn. The only solution was to take sensor from the door and cross the black wires. It works no more light on.
4b305cc.jpg

May 19, 2010 | 1998 Ford Windstar

1 Answer

Door lights not turning on when the door is opened


Windstars have problems with door switches. The last owner likely clipped the wires to the defective switches because the lights would not go off.

Feb 27, 2009 | 1999 Ford Windstar

2 Answers

Interior lights do not come on


Is it an old van? Can you see on the door frame a switch does it come out when the door is opened (push in and out a few times). 3 position switch on always / off always and door switch?

Apr 10, 2017 | 1999 Ford Windstar

Not finding what you are looking for?
1999 Ford Windstar Logo

Related Topics:

5,533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5622 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...