Question about 2002 Kia Sportage

1 Answer

I have no electric power to the car anywhere. i have 12 volts going into the fuse box but nothing at the fuses can you help?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 6,927 Answers

If there is 12 volts going to the fuse box,it would have to be in the fuse box,remove the fuse box(disconnect the battery)and flip it over,and you will see the problem.

Posted on Jul 20, 2010

  • Ronny Bennett Sr.
    Ronny Bennett Sr. Jul 20, 2010

    If this was at all helpful,please rate,thank you.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there 12 volt I can tap into to fit alarm


12 volt taps are everywhere. One of the easiest places to tap off 12 volts is in the electrical fuse box. Whichever fuse you decide to use, make sure it is a non-critical fuse like the ECM or fuel pump. When you look at the fuse panel, test which side of the fuse has voltage when the vehicle is turned OFF. You don't want an alarm system that only works when the vehicle is turned on!

Nov 28, 2017 | Cars & Trucks

1 Answer

I am fiting electric seat in to my sorento but have no power to plug fuse is live in kick panal fuse box was manual seat


kia sorento ?

find any 12 volt power wire going into power side of the fuse box
jump//splice a new wire run it to the seat and controls
fit an inline 10 amp fuse where you can get to it

26321289-i2ml2krc5iwy0vdznkpglsjk-1-0.jpg

26321289-i2ml2krc5iwy0vdznkpglsjk-1-1.jpg

Oct 21, 2016 | Seat Cars & Trucks

1 Answer

Turn the key, nothing happens, new battery


check voltage at main fuse box (what car)? and those fuses.
to fix electrical , "nothing" means , bad head lights.
so that very simple system is the most easiest to diagnose.
voltage at the head light fuse, (no) then move back to the engine bay
fuse box for power on all fuses there (large fuses)
at one point you get 12v (HL are hot all the time)
between the last bad point and the good 12v point is the section that is open circuited.
easy huh?

Feb 10, 2013 | Suzuki Cars & Trucks

1 Answer

Front blower motor will not work in 1994 f 350 van all fuses are good no power anywhere (at switch, resistor, or blower motor in any position


check the 50 amp fuse in teh engine compartment fuse/realy box. Also check the blower motor relay that the fuse protects.
Alos, check fuse 9, 15 amp in fuse panel in truck.

Test by applying 12 volts to teh orange/red wire at teh blower motor connector. Use a 10 or 12 gauge wire with a 25 or 30 amp fuse in line.

report back

Jan 11, 2011 | 2002 Ford E350

3 Answers

No power to fuel pump car was running fine just quit repalced fuel pump no power to pump, car will start when spraying starting fluid in to intake, is there a fuse ? also replaced ECM, fuel filter,...


Check for 12 volts power at the fuel pump harness. If no power is going to the pump, check the fuel pump relay. Also, check the fuel pump inertia switch. Ford usually has it on either inside left or right rear trunk fenders.

Apr 09, 2010 | 1987 Ford Taurus

1 Answer

Car wont start but have power to lights but no dash lights when is turn on


check all fuses with dvom or 12 volt test light for power at all fuse boxes if there is no power then its probaly this electrical ign switch not the key switch hope this helps THunderboltz

Jan 28, 2010 | 2004 Pontiac Montana

1 Answer

How do I get 12 volts at the factory installed trailer connector


You are correct. There is a fuse in the underhood fuse/relay compartment that powers up the pin. It is one of the larger fuses and should be labeled as "AUX". Also check that the power wire is connected to the AUX bolt terminal. They shipped from the factory disconnected and the cable was zip-tied to something below the fuse box.

Aug 26, 2009 | 2005 Chevrolet Silverado

1 Answer

1994 Buick Century, V6 - Total loss of electrical power


ck your batterie it should be reading 12 volt dc then your batterie terminals ck for cracks acide build up and corrosions ck the ground cable for proper connection to the engine first then to the engine. if your batterie is not at 12 volt dc then you probabily have an alternator problem have it ck from a nearest parts store nicoas

Dec 13, 2008 | 1994 Buick Century

Not finding what you are looking for?
2002 Kia Sportage Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...